Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Pasco vs Spokane (2026)

Pasco runs 0% higher than Spokane for metal roof installation — expect around $22,300 in Pasco against $22,200 in Spokane, a difference of about $100.

Pasco WA

$13,600 $31,000

Typically around $22,300

Spokane WA

Lower cost
$13,550 $30,850

Typically around $22,200

Pasco costs about $100 (0%) more than Spokane for metal roof installation, largely because of the local labor rate gap.
Side by side

Pasco vs Spokane: full breakdown

FactorPascoSpokane
Typical 2026 cost$22,300$22,200
Estimated range$13,600–$31,000$13,550–$30,850
Labor index (vs US)×1.02×1.02
Climate zoneMixedMixed
Climate factor×1×1
Local permit$300$300
Labor share$13,400$13,300
Materials/equipment$8,900$8,900

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

Is the price difference a dealbreaker?

0% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Metal roof installation by type: Pasco vs Spokane

Every metal roof installation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.

TypePascoSpokane
Corrugated steel (exposed fastener)$9,500$18,750$9,450$18,600
Standing-seam steel$18,750$36,150$18,600$35,950
Aluminum$14,650$28,950$14,550$28,800
Copper$31,000$61,750$30,850$61,400
Zinc$28,950$56,600$28,800$56,300

Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.

By size

Metal roof installation by roof size: Pasco vs Spokane

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizePascoSpokane
1,000 sq ft (10 squares)$8,500$16,700$8,450$16,600
1,500 sq ft (15 squares)$11,550$23,850$11,500$23,700
2,000 sq ft (20 squares)$13,600$31,000$13,550$30,850
2,500 sq ft (25 squares)$16,700$37,150$16,600$36,950
3,000+ sq ft (30 squares)$19,750$43,300$19,650$43,050

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Best time to buy

Cheapest time for metal roof installation in either city

Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.

The do-it-right case

A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

Our take

Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.

FAQ

Pasco vs Spokane

Is metal roof installation cheaper in Pasco or Spokane?

Spokane comes out ahead here, at roughly $22,200 for metal roof installation compared with $22,300 in Pasco — a 0% ($100) gap as of 2026.

Why does metal roof installation cost more in Pasco than Spokane?

Pasco's higher labor index (1.02 vs 1.02 in Spokane) is the biggest factor, with the mixed/mixed climate split playing a smaller role.

How much is metal roof installation in Pasco, WA?

Pasco homeowners can expect $13,600 to $31,000 for metal roof installation in 2026, with $22,300 the typical number.

When is the cheapest time to buy metal roof installation — and does it differ by city?

The best window is the same in both Pasco and Spokane: Late spring to early fall (dry, 45–85°F), when demand drops and installers discount to keep crews busy — typically 5–10% off peak pricing. The most expensive time anywhere is an emergency replacement during mid-winter and the post-storm rush.

Should I choose where to live based on metal roof installation cost?

That would be a stretch. $100 is a one-time difference, not an ongoing one, and off-season buying plus apples-to-apples bids in Pasco can close a good chunk of it. What matters more long-term is energy costs, climate and the condition of the home.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik