Furnace Replacement cost: Everett vs Worcester (2026)
In 2026, furnace replacement is about 10% more expensive in Everett than in Worcester. Most homeowners pay around $6,900 in Everett versus $6,250 in Worcester — a gap of roughly $650.
Everett MA
Typically around $6,900
Worcester MA
Lower costTypically around $6,250
Everett vs Worcester: full breakdown
| Factor | Everett | Worcester |
|---|---|---|
| Typical 2026 cost | $6,900 | $6,250 |
| Estimated range | $4,950–$8,850 | $4,450–$8,000 |
| Labor index (vs US) | ×1.14 | ×1.03 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $250 | $225 |
| Labor share | $4,150 | $3,750 |
| Materials/equipment | $2,750 | $2,500 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
How much should this gap actually matter?
That's a real $650 difference (10%) on furnace replacement — worth factoring in, though off-season timing and a tighter quote in Everett can narrow it.
Furnace replacement by type: Everett vs Worcester
Every furnace replacement type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Everett | Worcester |
|---|---|---|
| Gas furnace | $4,800–$8,750 | $4,350–$7,900 |
| High-efficiency gas furnace | $4,300–$8,750 | $3,900–$7,900 |
| Electric furnace | $2,700–$5,800 | $2,450–$5,250 |
All figures are 2026 localized planning estimates for furnace replacement — get an actual quote before you commit.
Furnace replacement by home size: Everett vs Worcester
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Everett | Worcester |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,700–$6,650 | $3,350–$6,000 |
| 1,500 sq ft (≈68,000 BTU) | $4,300–$7,650 | $3,900–$6,900 |
| 2,000 sq ft (≈90,000 BTU) | $4,950–$8,850 | $4,450–$8,000 |
| 2,500 sq ft (≈110,000 BTU) | $5,650–$10,100 | $5,100–$9,100 |
| 3,000 sq ft (≈130,000 BTU) | $6,400–$11,350 | $5,800–$10,250 |
| 3,500+ sq ft (≈150,000 BTU) | $7,150–$12,550 | $6,450–$11,350 |
Treat these as 2026 localized estimates for furnace replacement, not quotes from a contractor.
What hvac pros earn in each metro
Roughly 60% of what you pay for furnace replacement is labor, which is why local wages explain most of the price gap. The numbers below are actual metro wages for skilled installers, sourced from BLS OEWS — not guesses.
Boston-Cambridge-Newton metro · about 23% above the US average installer wage.
No BLS metro wage series for Worcester; we use Massachusetts regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
Installers cut prices in spring and fall because job volume drops and crews sit idle — the opposite happens during a summer heat wave or winter cold snap, when a dead system forces homeowners into a full-price emergency swap.
How much should you really budget for HVAC in 2026?
What you pay for HVAC hinges less on the badge than on how the quote is built — the load calculation behind it, the efficiency tier, and the markup. Our take on where each one lands.
The longevity case
The single biggest cost driver isn't the brand — it's correct sizing and install quality. A properly sized, well-commissioned mid-tier system with annual maintenance outlasts an oversized premium unit that short-cycles. Spend on the install, not the badge.
The efficiency-first case
Where you face brutal summers or hard winters, a higher SEER2/AFUE system or a heat pump runs enough hours to claw back its premium through lower bills — and utility or state rebates can still trim the sticker even though the federal 25C/25D credits closed at the end of 2025. Do the payback arithmetic before you reach for the cheapest box on the lot.
The budget-first case
In a temperate region the smart move is to size the job correctly with a Manual J and take the base efficiency tier. A system that spends most days coasting can't recover the cost of a high-SEER2 compressor, because the savings only show up under heavy load you don't put on it. Match the equipment to how little you actually run it, not to the brochure's top number.
Climate decides the efficiency tier; a proper load calculation decides everything else. Nail both, stack the rebates you can, and you've sidestepped the two mistakes — wrong size, rushed install — that actually inflate the lifetime cost.
Everett vs Worcester
Is furnace replacement cheaper in Everett or Worcester?
Yes — Everett costs more. Expect around $6,900 for furnace replacement there against $6,250 in Worcester, about $650 (10%) apart in 2026.
Why does furnace replacement cost more in Everett than Worcester?
It comes down to labor: Everett indexes at 1.14 against Worcester's 1.03. The cold-vs-cold climate difference, plus permit fees, adds to the gap.
How much is furnace replacement in Everett, MA?
Everett homeowners can expect $4,950 to $8,850 for furnace replacement in 2026, with $6,900 the typical number.
When is the cheapest time to buy furnace replacement — and does it differ by city?
It doesn't vary by location — Spring and fall (Mar–May, Sep–Oct) is the discount window in both Everett and Worcester (roughly 5–15% off), while peak summer and mid-winter tends to be the most expensive in either city.
Should I choose where to live based on furnace replacement cost?
That would be a stretch. $650 is a one-time difference, not an ongoing one, and off-season buying plus apples-to-apples bids in Everett can close a good chunk of it. What matters more long-term is energy costs, climate and the condition of the home.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik