Furnace Replacement cost: Everett vs Lowell (2026)
There's essentially no price gap here: furnace replacement runs close to $6,900 in both Everett and Lowell in 2026.
Everett MA
Typically around $6,900
Lowell MA
Typically around $6,900
Everett vs Lowell: full breakdown
| Factor | Everett | Lowell |
|---|---|---|
| Typical 2026 cost | $6,900 | $6,900 |
| Estimated range | $4,950–$8,850 | $4,950–$8,850 |
| Labor index (vs US) | ×1.14 | ×1.14 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $250 | $250 |
| Labor share | $4,150 | $4,150 |
| Materials/equipment | $2,750 | $2,750 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
A wash — choose on quality, not city
The two metros are effectively a wash for furnace replacement — pick on contractor quality and timing, not location.
Furnace replacement by type: Everett vs Lowell
Every furnace replacement type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Everett | Lowell |
|---|---|---|
| Gas furnace | $4,800–$8,750 | $4,800–$8,750 |
| High-efficiency gas furnace | $4,300–$8,750 | $4,300–$8,750 |
| Electric furnace | $2,700–$5,800 | $2,700–$5,800 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
Furnace replacement by home size: Everett vs Lowell
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Everett | Lowell |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,700–$6,650 | $3,700–$6,650 |
| 1,500 sq ft (≈68,000 BTU) | $4,300–$7,650 | $4,300–$7,650 |
| 2,000 sq ft (≈90,000 BTU) | $4,950–$8,850 | $4,950–$8,850 |
| 2,500 sq ft (≈110,000 BTU) | $5,650–$10,100 | $5,650–$10,100 |
| 3,000 sq ft (≈130,000 BTU) | $6,400–$11,350 | $6,400–$11,350 |
| 3,500+ sq ft (≈150,000 BTU) | $7,150–$12,550 | $7,150–$12,550 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
What hvac pros earn in each metro
With labor making up about 60% of a furnace replacement job, wage differences between metros do most of the work here. These figures are real BLS OEWS installer wages, not modeled estimates.
Boston-Cambridge-Newton metro · about 23% above the US average installer wage.
Boston-Cambridge-Newton metro · about 23% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
Installers cut prices in spring and fall because job volume drops and crews sit idle — the opposite happens during a summer heat wave or winter cold snap, when a dead system forces homeowners into a full-price emergency swap.
How much should you really budget for HVAC in 2026?
Ask five contractors for an HVAC quote and you'll get five different numbers — usually because they disagree on sizing, efficiency and equipment tier. Here's how our editors think through those trade-offs.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The budget-first case
In a temperate region the smart move is to size the job correctly with a Manual J and take the base efficiency tier. A system that spends most days coasting can't recover the cost of a high-SEER2 compressor, because the savings only show up under heavy load you don't put on it. Match the equipment to how little you actually run it, not to the brochure's top number.
The efficiency-first case
Where you face brutal summers or hard winters, a higher SEER2/AFUE system or a heat pump runs enough hours to claw back its premium through lower bills — and utility or state rebates can still trim the sticker even though the federal 25C/25D credits closed at the end of 2025. Do the payback arithmetic before you reach for the cheapest box on the lot.
The costly errors in an HVAC job are a bad load calculation and a sloppy install — not the logo you chose. Size it with a real Manual J, let your climate set the efficiency tier, and claim whatever rebates you still qualify for.
Everett vs Lowell
Is furnace replacement cheaper in Everett or Lowell?
There's no meaningful difference: furnace replacement runs about $6,900 in both places.
Why does furnace replacement cost more in Lowell than Everett?
Lowell's higher labor index (1.14 vs 1.14 in Everett) is the biggest factor, with the cold/cold climate split playing a smaller role.
How much is furnace replacement in Everett, MA?
furnace replacement in Everett runs $4,950–$8,850 as of 2026 — most jobs land near $6,900.
Do hvac pros really charge more in one city?
They do, and the BLS wage data confirms it: installers earn about $38.4/hr around Boston-Cambridge-Newton versus $38.4/hr near Boston-Cambridge-Newton. With labor making up about 60% of a furnace replacement job, that difference carries straight through to the final price.
When is the cheapest time to buy furnace replacement — and does it differ by city?
It doesn't vary by location — Spring and fall (Mar–May, Sep–Oct) is the discount window in both Everett and Lowell (roughly 5–15% off), while peak summer and mid-winter tends to be the most expensive in either city.
Should I choose where to live based on furnace replacement cost?
Not on this basis — Everett and Lowell cost about the same. Weigh contractor quality, scope, equipment tier and timing instead.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik