Metal Roof Installation cost: Enid vs Tulsa (2026)
Enid runs 1% higher than Tulsa for metal roof installation — expect around $20,850 in Enid against $20,600 in Tulsa, a difference of about $250.
Enid OK
Typically around $20,850
Tulsa OK
Lower costTypically around $20,600
Enid vs Tulsa: full breakdown
| Factor | Enid | Tulsa |
|---|---|---|
| Typical 2026 cost | $20,850 | $20,600 |
| Estimated range | $12,700–$28,950 | $12,550–$28,650 |
| Labor index (vs US) | ×0.96 | ×0.95 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $250 | $250 |
| Labor share | $12,500 | $12,350 |
| Materials/equipment | $8,350 | $8,250 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Is the price difference a dealbreaker?
1% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.
Metal roof installation by type: Enid vs Tulsa
Every metal roof installation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Enid | Tulsa |
|---|---|---|
| Corrugated steel (exposed fastener) | $8,850–$17,450 | $8,750–$17,300 |
| Standing-seam steel | $17,450–$33,700 | $17,300–$33,350 |
| Aluminum | $13,650–$27,000 | $13,500–$26,750 |
| Copper | $28,950–$57,600 | $28,650–$57,000 |
| Zinc | $27,000–$52,850 | $26,750–$52,300 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
Metal roof installation by roof size: Enid vs Tulsa
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Enid | Tulsa |
|---|---|---|
| 1,000 sq ft (10 squares) | $7,900–$15,550 | $7,800–$15,400 |
| 1,500 sq ft (15 squares) | $10,750–$22,250 | $10,650–$22,000 |
| 2,000 sq ft (20 squares) | $12,700–$28,950 | $12,550–$28,650 |
| 2,500 sq ft (25 squares) | $15,550–$34,650 | $15,400–$34,300 |
| 3,000+ sq ft (30 squares) | $18,400–$40,400 | $18,200–$40,000 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What roofing pros earn in each metro
About 60% of a metal roof installation bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Oklahoma City metro · about 7% below the US average installer wage.
No BLS metro wage series for Tulsa; we use Oklahoma regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Why summer costs more: it's the only stretch shingles seal reliably, so every storm-damaged roof in the region is competing for the same crews. Reserve a spring slot during the slow winter season and you're not in that queue.
Where does a smart roofing budget go in 2026?
The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.
The risk case
The surprise that wrecks a roofing budget is rot in the decking, and you rarely see it until the old shingles come off. Fix the price per replacement sheet in the contract before the crew starts, so a low bid can't quietly climb once the deck is open.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
The two things that actually protect a roofing budget are a real tear-off and a written rate for any deck repairs found along the way. The cheapest post-storm bid usually isn't the cheapest roof, long-term.
Enid vs Tulsa
Is metal roof installation cheaper in Enid or Tulsa?
Tulsa wins on price: metal roof installation runs about $20,600 there versus $20,850 in Enid, a gap of roughly $250 (1%) as of 2026.
Why does metal roof installation cost more in Enid than Tulsa?
It comes down to labor: Enid indexes at 0.96 against Tulsa's 0.95. The mixed-vs-mixed climate difference adds to the gap.
How much is metal roof installation in Enid, OK?
metal roof installation in Enid runs $12,700–$28,950 as of 2026 — most jobs land near $20,850.
When is the cheapest time to buy metal roof installation — and does it differ by city?
Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Enid and Tulsa, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.
Should I choose where to live based on metal roof installation cost?
That would be a stretch. $250 is a one-time difference, not an ongoing one, and off-season buying plus apples-to-apples bids in Enid can close a good chunk of it. What matters more long-term is energy costs, climate and the condition of the home.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik