Metal Roof Installation cost: Edmond vs Tulsa (2026)
Edmond runs 1% higher than Tulsa for metal roof installation — expect around $20,850 in Edmond against $20,600 in Tulsa, a difference of about $250.
Edmond OK
Typically around $20,850
Tulsa OK
Lower costTypically around $20,600
Edmond vs Tulsa: full breakdown
| Factor | Edmond | Tulsa |
|---|---|---|
| Typical 2026 cost | $20,850 | $20,600 |
| Estimated range | $12,700–$28,950 | $12,550–$28,650 |
| Labor index (vs US) | ×0.96 | ×0.95 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $250 | $250 |
| Labor share | $12,500 | $12,350 |
| Materials/equipment | $8,350 | $8,250 |
These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.
How much should this gap actually matter?
That 1% gap is small — for metal roof installation it's usually less than the spread between two local contractors' quotes, so the metro matters far less than who you hire and when you buy.
Metal roof installation by type: Edmond vs Tulsa
We localize each metal roof installation type separately for both metros, applying the same labor, climate and permit adjustments each time, so you're comparing like for like.
| Type | Edmond | Tulsa |
|---|---|---|
| Corrugated steel (exposed fastener) | $8,850–$17,450 | $8,750–$17,300 |
| Standing-seam steel | $17,450–$33,700 | $17,300–$33,350 |
| Aluminum | $13,650–$27,000 | $13,500–$26,750 |
| Copper | $28,950–$57,600 | $28,650–$57,000 |
| Zinc | $27,000–$52,850 | $26,750–$52,300 |
These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.
Metal roof installation by roof size: Edmond vs Tulsa
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Edmond | Tulsa |
|---|---|---|
| 1,000 sq ft (10 squares) | $7,900–$15,550 | $7,800–$15,400 |
| 1,500 sq ft (15 squares) | $10,750–$22,250 | $10,650–$22,000 |
| 2,000 sq ft (20 squares) | $12,700–$28,950 | $12,550–$28,650 |
| 2,500 sq ft (25 squares) | $15,550–$34,650 | $15,400–$34,300 |
| 3,000+ sq ft (30 squares) | $18,400–$40,400 | $18,200–$40,000 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
What roofing pros earn in each metro
Labor is about 60% of a metal roof installation bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Oklahoma City metro · about 7% below the US average installer wage.
No BLS metro wage series for Tulsa; we use Oklahoma regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Roofers are slammed the moment warm weather returns, especially after storms. Get on their books in the off-season for a spring job and you're negotiating with an empty calendar, not a waiting list.
Where does a smart roofing budget go in 2026?
The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.
The risk case
Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.
The do-it-right case
Skipping the tear-off means burying whatever's failing underneath, and a second layer bakes the shingles from below until they curl early. Doing it properly means stripping to the deck, then paying for real underlayment, flashing and airflow — the work that sets how long the roof lasts, not just how it looks the first week.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
A roof's real cost shows up over its lifespan, not on install day. Tear-off, a documented repair rate and a mid-tier shingle grade are what keep that lifetime cost in check.
Edmond vs Tulsa
Is metal roof installation cheaper in Edmond or Tulsa?
Yes — Edmond costs more. Expect around $20,850 for metal roof installation there against $20,600 in Tulsa, about $250 (1%) apart in 2026.
Why does metal roof installation cost more in Edmond than Tulsa?
Edmond's higher labor index (0.96 vs 0.95 in Tulsa) is the biggest factor, with the mixed/mixed climate split playing a smaller role.
How much is metal roof installation in Edmond, OK?
metal roof installation in Edmond runs $12,700–$28,950 as of 2026 — most jobs land near $20,850.
When is the cheapest time to buy metal roof installation — and does it differ by city?
No, the seasonal pattern is the same in Edmond and Tulsa: book during Late spring to early fall (dry, 45–85°F) for about 5–10% in savings. Mid-winter and the post-storm rush is the priciest stretch in both cities, mostly due to emergency replacements.
Should I choose where to live based on metal roof installation cost?
That would be a stretch. $250 is a one-time difference, not an ongoing one, and off-season buying plus apples-to-apples bids in Edmond can close a good chunk of it. What matters more long-term is energy costs, climate and the condition of the home.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik