Roofing · Broomfield, CO
How much does metal roof installation cost in Broomfield, CO? (2026)
In Broomfield, metal roof installation runs $13,800–$31,500, with most paying around $22,650 — about 5% above the national average. Installing a metal roof — higher upfront cost, long lifespan and strong durability.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $22,650
- Typical cost
- $22,650
- Labor vs US
- US avg
- Climate
- Cold
- Local permit
- $275
Refine your estimate
Tune it to your home to narrow the metal roof installation range.
Key takeaways for Broomfield
- Broomfield homeowners typically pay $13,800–$31,500 for metal roof installation, with $22,650 the usual landing spot — about 5% above the national average.
- Because local crews charge close to national rates, this metal roof installation estimate lands right around the countrywide figure.
- A Roofing permit in Broomfield runs about $275 — it's already folded into the estimate above.
- Expect 40–70 years of service, so planning a replacement beats a full-price emergency call.
- Cheapest time to buy: Late spring to early fall (dry, 45–85°F) — roughly 5–10% off peak-season pricing.
What goes into the price in Broomfield
A typical Broomfield metal roof installation of $22,650 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Broomfield 2026 range |
|---|---|
| Materials & equipmentThe unit and materials — largely the same cost no matter which city you're in. | $5,400 – $12,500 |
| Labor & installationCrew time for removal, installation and startup; local labor rates drive most of the swing here. | $8,125 – $18,725 |
| Permit & feesRoofing permit cost, adjusted to this city's rate. | $275 |
| Total installed cost | $13,800 – $31,500 |
Split from the Broomfield estimate using a 60% local-labor share; line items sum to the total.
Why metal roof installation costs what it does in Broomfield
- There's no real labor premium or discount in Broomfield — it's near the national norm (based on price levels for the Boulder metro area).
- Broomfield's cold climate increases typical metal roof installation cost by about 4% versus a neutral climate.
- Budget about $275 for the local Roofing permit in Broomfield — already folded into the estimate above.
Metal Roof Installation cost by roof size in Broomfield
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| roof size | Broomfield 2026 range |
|---|---|
| 1,000 sq ft (10 squares) | $8,600 – $16,900 |
| 1,500 sq ft (15 squares) | $11,700 – $24,200 |
| 2,000 sq ft (20 squares) | $13,800 – $31,500 |
| 2,500 sq ft (25 squares) | $16,900 – $37,700 |
| 3,000+ sq ft (30 squares) | $20,050 – $43,950 |
National size ranges localized to Broomfield labor and climate.
Metal Roof Installation cost by type in Broomfield
| Corrugated steel (exposed fastener) | $9,650 – $19,000 |
| Standing-seam steel | $19,000 – $36,700 |
| Aluminum | $14,850 – $29,400 |
| Copper | $31,500 – $62,700 |
| Zinc | $29,400 – $57,500 |
Adjusted to Broomfield from national type-level ranges.
Metal Roof Installation cost by efficiency in Broomfield
The panel system and metal type set the price. Exposed-fastener panels are the budget option; standing-seam hides the fasteners and lasts longer; specialty metals (copper, zinc) are architectural premiums.
| Exposed-fastener / corrugated steelLowest-cost metal; fasteners need periodic resealing | $8,600 – $19,000 |
| Standing-seam steel or aluminumHidden fasteners, sleek look; the mainstream choice | $13,800 – $31,500 |
| Copper / zinc (specialty)Premium architectural metal; 70+ yr life | $26,300 – $52,300 |
Labor vs. materials in Broomfield
Install crew, removal, permit & startup — the part Broomfield rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $22,650 Broomfield project; your mix varies with scope.
How we estimate it
| National range | $13,000 – $30,000 |
| Broomfield labor adjustment | ×1 |
| cold climate factor | ×1.04 |
| Local permit | +$275 |
| Broomfield estimate | $13,800 – $31,500 |
Promo prices vs. the real cost
The prices that fill your mailbox after a hailstorm are built to look cheap, not to describe the job — here's what those advertised figures usually assume:
- Financing offers$0 down · low APR
- Free roof inspection$0 — it's a sales visit
- Per-square teaser priceadvertised low; varies by pitch & material
Additional metal roof installation costs to budget for
Only a handful of these will touch your total. Which ones depend on what's already in place and how the crew has to reach it.
| Tear-off & disposal of old roofSkippable if installing over a sound existing roof with furring | $1,000 – $3,000 |
| Decking / sheathing repair | $500 – $3,000 |
| Underlayment (high-temp synthetic) | $400 – $1,500 |
| Custom flashing, trim & ridge capsMore on complex or steep rooflines | $500 – $2,500 |
| Snow guards (in snowy regions) | $300 – $1,500 |
| Permit | $150 – $500 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- Metal panels or standing-seam system
- Tear-off of the old roof
- Labor, cleanup and permit
- Underlayment, fasteners and trim
What affects the cost
- Metal: steel, aluminum, copper or zinc
- Panel type (exposed-fastener vs standing seam)
- Roof complexity and number of penetrations
- Whether existing roof can be overlaid
Ways to save on metal roof installation in Broomfield
- Metal's 40–70 yr life lowers lifetime cost
- Some insurers discount metal and impact-rated roofs
- Steel standing seam balances cost and longevity
- Compare lifetime cost, not just the install price
How long does metal roof installation last in Broomfield?
Steel/aluminum panels last 40–70 years; copper and zinc can exceed 100.
Mostly inspection — checking fasteners, sealant, and flashing; far less hands-on than asphalt.
Signs you need metal roof installation in Broomfield
- Loose, backed-out, or corroded fasteners on exposed-fastener panels
- Rust spots, especially at seams, edges, or scratches
- Failed sealant or lifted seams letting water track underneath
- Loose or damaged flashing around chimneys, valleys, and skylights
- Dents or panel deformation after hail or fallen limbs
- Faded or peeling factory finish near the end of its warranty
Repair or replace in Broomfield?
Repair if…
- The problem is loose fasteners, worn sealant, or a single damaged panel
- Rust is localized and can be treated and resealed
- Flashing has failed but the panels themselves are sound
Replace if…
- Corrosion or rust-through is widespread across panels
- Panels are heavily dented or deformed beyond repair
- The system is decades old and the protective coating has fully failed
Cost calculator
Roof cost by material in Broomfield, CO
Roofs are priced per square (100 sq ft). An average US home is about 20 squares. Prices are localized to Broomfield, CO labor; the last column is what each material costs per year of life — often the real deciding number.
| Material | Lifespan | Total (20 sq) | Per year of life |
|---|---|---|---|
Architectural asphalt shingle The default US roof — best cost-per-year for most homes. Wind: up to 130 mph. | 25–30 yr | $7,000–$12,000 | $350/yr |
Flat / low-slope (TPO, EPDM) For flat and low-slope roofs; single-ply membrane over the deck. Wind: membrane, fully adhered. | 20–30 yr | $8,000–$16,000 | $500/yr |
Standing-seam metalThis page High upfront cost but the lowest cost-per-year; sheds snow, resists hail and fire. Wind: 140+ mph. | 40–70 yr | $18,000–$32,000 | $450/yr |
Clay / concrete tile Longest-lasting; needs a structure rated for the extra weight. Wind: 125+ mph. | 50–75 yr | $20,000–$40,000 | $500/yr |
Per-square ranges are national installed benchmarks localized to Broomfield, CO labor; lifespan and wind ratings are manufacturer / ASTM figures. A research estimate, not a quote.
Cheapest time for metal roof installation in Broomfield
Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.
Why metal roof installation quotes vary — and how to compare them fairly
Big gaps between bids come down to scope far more often than greed. This breaks down the levers and how to force a like-for-like comparison.
Why a quote looks high (or low)
- Shingle tier (3-tab vs. architectural vs. premium) changes both material and labor.
- Deck repair, underlayment grade and ventilation may or may not be in the price.
- A storm-chaser's lowball often skips flashing, ice-and-water shield or a real warranty.
Get an apples-to-apples bid
- Confirm underlayment, ice-and-water shield, flashing and ventilation are included.
- Specify tear-off vs. overlay so all bids match.
- Verify the contractor is licensed, insured and local, with recent references.
- Ask how deck/sheathing repairs are priced if rot is found.
Questions to ask Broomfield Roofing pros
Quotes only compare cleanly when every bidder is pricing the same work — put these to each of them before you commit.
- 1Is a full tear-off included, or are you laying over the existing roof?
- 2How will you handle deck repairs or rotten sheathing found after tear-off, and at what rate?
- 3What underlayment, ice-and-water shield, and ventilation are included?
- 4Are you licensed and insured here, and can you share recent local references?
- 5What's the workmanship warranty, and how does it interact with the material warranty?
Metal Roof Installation in Broomfield
How much does metal roof installation cost in Broomfield, CO?
Broomfield's going rate for metal roof installation is $13,800–$31,500 in 2026, with $22,650 the number most homeowners end up paying. Strip out Broomfield's labor rates, its cold climate and permit fees and you'd be left with a national average — this range keeps them in.
Is metal roof installation more expensive in Broomfield than average?
Broomfield is about 5% higher than the national average, mainly because local labor runs at an index of 1 relative to the US average., plus a local Roofing permit running about $275.
Do I need a permit for metal roof installation in Broomfield?
Most Broomfield jurisdictions require a Roofing permit for this work. Budget roughly $275 for the permit; it is already included in the estimate above.
What affects metal roof installation cost the most?
Start with the fundamentals — installing a metal roof — higher upfront cost, long lifespan and strong durability. Expect equipment/material grade, home size and complexity, local labor rates and the cold climate zone to matter most here.
Where does a smart roofing budget go in 2026?
The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.
The value case
For a typical home, the architectural shingle is the default that makes sense. It outlasts 3-tab by a wide margin at a modest premium, and it spares you the cost of metal or tile that most roofs never need to justify.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
The risk case
The surprise that wrecks a roofing budget is rot in the decking, and you rarely see it until the old shingles come off. Fix the price per replacement sheet in the contract before the crew starts, so a low bid can't quietly climb once the deck is open.
The two things that actually protect a roofing budget are a real tear-off and a written rate for any deck repairs found along the way. The cheapest post-storm bid usually isn't the cheapest roof, long-term.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national metal roof installation ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Broomfield using the BEA Regional Price Parity labor index (×1 here), the IECC cold-climate factor (×1.04) and a typical local permit fee (≈$275). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Broomfield metal roof installation estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Metal roof installation alternatives in Broomfield
Homeowners in Broomfield often pair this with
A metal roof installation rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Broomfield
Browse local 2026 costs for every home project in Broomfield, CO.