Metal Roof Installation cost: Jacksonville vs Town 'n' Country (2026)
Jacksonville runs 3% higher than Town 'n' Country for metal roof installation — expect around $21,200 in Jacksonville against $20,600 in Town 'n' Country, a difference of about $600.
Jacksonville FL
Typically around $21,200
Town 'n' Country FL
Lower costTypically around $20,600
Jacksonville vs Town 'n' Country: full breakdown
| Factor | Jacksonville | Town 'n' Country |
|---|---|---|
| Typical 2026 cost | $21,200 | $20,600 |
| Estimated range | $12,950–$29,450 | $12,550–$28,650 |
| Labor index (vs US) | ×0.94 | ×0.92 |
| Climate zone | Hot | Hot |
| Climate factor | ×1.03 | ×1.03 |
| Local permit | $275 | $275 |
| Labor share | $12,700 | $12,350 |
| Materials/equipment | $8,500 | $8,250 |
Treat these as 2026 localized estimates for metal roof installation, not quotes from a contractor.
Is the price difference a dealbreaker?
At 3%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for metal roof installation — focus on the contractor, not the city.
Metal roof installation by type: Jacksonville vs Town 'n' Country
Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Jacksonville | Town 'n' Country |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,050–$17,800 | $8,800–$17,300 |
| Standing-seam steel | $17,800–$34,350 | $17,300–$33,400 |
| Aluminum | $13,900–$27,500 | $13,500–$26,750 |
| Copper | $29,450–$58,650 | $28,650–$57,050 |
| Zinc | $27,500–$53,800 | $26,750–$52,300 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Metal roof installation by roof size: Jacksonville vs Town 'n' Country
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Jacksonville | Town 'n' Country |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,050–$15,850 | $7,850–$15,400 |
| 1,500 sq ft (15 squares) | $11,000–$22,650 | $10,700–$22,050 |
| 2,000 sq ft (20 squares) | $12,950–$29,450 | $12,550–$28,650 |
| 2,500 sq ft (25 squares) | $15,850–$35,300 | $15,400–$34,350 |
| 3,000+ sq ft (30 squares) | $18,750–$41,150 | $18,250–$40,000 |
These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.
What roofing pros earn in each metro
Roughly 60% of what you pay for metal roof installation is labor, which is why local wages explain most of the price gap. The numbers below are actual metro wages for skilled installers, sourced from BLS OEWS — not guesses.
Jacksonville metro · about 9% below the US average installer wage.
Tampa-St. Petersburg-Clearwater metro · about 14% below the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Why summer costs more: it's the only stretch shingles seal reliably, so every storm-damaged roof in the region is competing for the same crews. Reserve a spring slot during the slow winter season and you're not in that queue.
Where does a smart roofing budget go in 2026?
Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.
The risk case
Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.
The do-it-right case
Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.
The value case
Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.
Full tear-off, architectural shingles and a written deck-repair rate protect you from the two big risks — hidden rot and warranty gaps. The lowest storm-season bid is rarely the cheapest over the roof's life.
Jacksonville vs Town 'n' Country
Is metal roof installation cheaper in Jacksonville or Town 'n' Country?
In 2026, metal roof installation is cheaper in Town 'n' Country at about $20,600, versus $21,200 in Jacksonville — a difference of about $600 (3%).
Why does metal roof installation cost more in Jacksonville than Town 'n' Country?
Jacksonville's higher labor index (0.94 vs 0.92 in Town 'n' Country) is the biggest factor, with the hot/hot climate split playing a smaller role.
How much is metal roof installation in Jacksonville, FL?
Expect to pay $12,950 to $29,450 for metal roof installation in Jacksonville in 2026, averaging around $21,200.
Do roofing pros really charge more in one city?
Yes — and the wage data shows it. A skilled installer earns about $28.3/hr in the Jacksonville area versus $26.9/hr around Tampa-St. Petersburg-Clearwater (BLS metro wage data). Since labor is roughly 60% of a metal roof installation job, that wage gap is the biggest reason the installed prices differ.
When is the cheapest time to buy metal roof installation — and does it differ by city?
No, the seasonal pattern is the same in Jacksonville and Town 'n' Country: book during Late spring to early fall (dry, 45–85°F) for about 5–10% in savings. Mid-winter and the post-storm rush is the priciest stretch in both cities, mostly due to emergency replacements.
Should I choose where to live based on metal roof installation cost?
Probably not. Yes, $600 is a real gap, but it's a one-time cost you can partly offset in Jacksonville with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik