Metal Roof Installation cost: Jacksonville vs Pine Hills (2026)
Budget-wise, metal roof installation in Jacksonville ($21,200) runs 6% less than in Pine Hills ($22,550), a roughly $1,350 spread.
Jacksonville FL
Lower costTypically around $21,200
Pine Hills FL
Typically around $22,550
Jacksonville vs Pine Hills: full breakdown
| Factor | Jacksonville | Pine Hills |
|---|---|---|
| Typical 2026 cost | $21,200 | $22,550 |
| Estimated range | $12,950–$29,450 | $13,750–$31,350 |
| Labor index (vs US) | ×0.94 | ×1.01 |
| Climate zone | Hot | Hot |
| Climate factor | ×1.03 | ×1.03 |
| Local permit | $275 | $275 |
| Labor share | $12,700 | $13,550 |
| Materials/equipment | $8,500 | $9,000 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Is the price difference a dealbreaker?
At 6%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for metal roof installation — focus on the contractor, not the city.
Metal roof installation by type: Jacksonville vs Pine Hills
Every metal roof installation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Jacksonville | Pine Hills |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,050–$17,800 | $9,600–$18,950 |
| Standing-seam steel | $17,800–$34,350 | $18,950–$36,550 |
| Aluminum | $13,900–$27,500 | $14,800–$29,300 |
| Copper | $29,450–$58,650 | $31,350–$62,450 |
| Zinc | $27,500–$53,800 | $29,300–$57,250 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
Metal roof installation by roof size: Jacksonville vs Pine Hills
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Jacksonville | Pine Hills |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,050–$15,850 | $8,550–$16,850 |
| 1,500 sq ft (15 squares) | $11,000–$22,650 | $11,650–$24,100 |
| 2,000 sq ft (20 squares) | $12,950–$29,450 | $13,750–$31,350 |
| 2,500 sq ft (25 squares) | $15,850–$35,300 | $16,850–$37,600 |
| 3,000+ sq ft (30 squares) | $18,750–$41,150 | $19,950–$43,800 |
All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.
What roofing pros earn in each metro
Labor is about 60% of a metal roof installation bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Jacksonville metro · about 9% below the US average installer wage.
No BLS metro wage series for Pine Hills; we use Florida regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.
Where does a smart roofing budget go in 2026?
The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.
The risk case
Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.
The do-it-right case
Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.
The value case
Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.
Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.
Jacksonville vs Pine Hills
Is metal roof installation cheaper in Jacksonville or Pine Hills?
In 2026, metal roof installation is cheaper in Jacksonville at about $21,200, versus $22,550 in Pine Hills — a difference of about $1,350 (6%).
Why does metal roof installation cost more in Pine Hills than Jacksonville?
The main driver is local labor rates: Pine Hills's labor index is 1.01 versus 0.94 in Jacksonville. Climate zone (hot vs hot) also shift the total.
How much is metal roof installation in Jacksonville, FL?
metal roof installation in Jacksonville runs $12,950–$29,450 as of 2026 — most jobs land near $21,200.
When is the cheapest time to buy metal roof installation — and does it differ by city?
Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Jacksonville and Pine Hills, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.
Should I choose where to live based on metal roof installation cost?
That would be a stretch. $1,350 is a one-time difference, not an ongoing one, and off-season buying plus apples-to-apples bids in Pine Hills can close a good chunk of it. What matters more long-term is energy costs, climate and the condition of the home.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik