Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Jacksonville vs Lehigh Acres (2026)

The two metros aren't quite in sync on metal roof installation: Jacksonville sits 7% below Lehigh Acres, or roughly $21,200 versus $22,700 — about $1,500 apart.

Jacksonville FL

Lower cost
$12,950 $29,450

Typically around $21,200

Lehigh Acres FL

$13,850 $31,550

Typically around $22,700

The $1,500 (7%) premium on metal roof installation in Lehigh Acres versus Jacksonville comes down mostly to local labor rates.
Side by side

Jacksonville vs Lehigh Acres: full breakdown

FactorJacksonvilleLehigh Acres
Typical 2026 cost$21,200$22,700
Estimated range$12,950–$29,450$13,850–$31,550
Labor index (vs US)×0.94×1.01
Climate zoneHotHot
Climate factor×1.03×1.03
Local permit$275$275
Labor share$12,700$13,600
Materials/equipment$8,500$9,100

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

How much should this gap actually matter?

A 7% difference on metal roof installation is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.

By type

Metal roof installation by type: Jacksonville vs Lehigh Acres

Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeJacksonvilleLehigh Acres
Corrugated steel (exposed fastener)$9,050$17,800$9,650$19,050
Standing-seam steel$17,800$34,350$19,050$36,750
Aluminum$13,900$27,500$14,850$29,450
Copper$29,450$58,650$31,550$62,800
Zinc$27,500$53,800$29,450$57,600

These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.

By size

Metal roof installation by roof size: Jacksonville vs Lehigh Acres

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizeJacksonvilleLehigh Acres
1,000 sq ft (10 squares)$8,050$15,850$8,600$16,950
1,500 sq ft (15 squares)$11,000$22,650$11,750$24,250
2,000 sq ft (20 squares)$12,950$29,450$13,850$31,550
2,500 sq ft (25 squares)$15,850$35,300$16,950$37,800
3,000+ sq ft (30 squares)$18,750$41,150$20,100$44,050

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Local labor reality

What roofing pros earn in each metro

With labor making up about 60% of a metal roof installation job, wage differences between metros do most of the work here. These figures are real BLS OEWS installer wages, not modeled estimates.

Jacksonville, FL
$28.3/hr

Jacksonville metro · about 9% below the US average installer wage.

Lehigh Acres, FL
Modeled from state data

No BLS metro wage series for Lehigh Acres; we use Florida regional price parity instead.

Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).

Best time to buy

Cheapest time for metal roof installation in either city

Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

A roofing quote can hide a lot behind a single number — whether it's a true tear-off, the shingle grade, and what's under the surface. Here's how our editors sort through it.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The value case

Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.

Our take

A roof's real cost shows up over its lifespan, not on install day. Tear-off, a documented repair rate and a mid-tier shingle grade are what keep that lifetime cost in check.

FAQ

Jacksonville vs Lehigh Acres

Is metal roof installation cheaper in Jacksonville or Lehigh Acres?

Jacksonville wins on price: metal roof installation runs about $21,200 there versus $22,700 in Lehigh Acres, a gap of roughly $1,500 (7%) as of 2026.

Why does metal roof installation cost more in Lehigh Acres than Jacksonville?

Lehigh Acres's higher labor index (1.01 vs 0.94 in Jacksonville) is the biggest factor, with the hot/hot climate split playing a smaller role.

How much is metal roof installation in Jacksonville, FL?

metal roof installation in Jacksonville runs $12,950–$29,450 as of 2026 — most jobs land near $21,200.

When is the cheapest time to buy metal roof installation — and does it differ by city?

Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Jacksonville and Lehigh Acres, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.

Should I choose where to live based on metal roof installation cost?

Not really — the $1,500 gap is one-time, and smart timing and tighter quotes in Lehigh Acres can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik