Metal Roof Installation cost: Beaumont vs San Antonio (2026)
Budget-wise, metal roof installation in Beaumont ($21,200) runs 0% less than in San Antonio ($21,250), a roughly $50 spread.
Beaumont TX
Lower costTypically around $21,200
San Antonio TX
Typically around $21,250
Beaumont vs San Antonio: full breakdown
| Factor | Beaumont | San Antonio |
|---|---|---|
| Typical 2026 cost | $21,200 | $21,250 |
| Estimated range | $12,900–$29,500 | $12,950–$29,550 |
| Labor index (vs US) | ×0.95 | ×0.95 |
| Climate zone | Hot | Hot |
| Climate factor | ×1.03 | ×1.03 |
| Local permit | $250 | $275 |
| Labor share | $12,700 | $12,750 |
| Materials/equipment | $8,500 | $8,500 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Is the gap worth worrying about?
0% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.
Metal roof installation by type: Beaumont vs San Antonio
Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Beaumont | San Antonio |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,000–$17,800 | $9,050–$17,850 |
| Standing-seam steel | $17,800–$34,350 | $17,850–$34,450 |
| Aluminum | $13,900–$27,550 | $13,950–$27,600 |
| Copper | $29,500–$58,700 | $29,550–$58,850 |
| Zinc | $27,550–$53,850 | $27,600–$53,950 |
All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.
Metal roof installation by roof size: Beaumont vs San Antonio
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Beaumont | San Antonio |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,050–$15,850 | $8,100–$15,900 |
| 1,500 sq ft (15 squares) | $10,950–$22,650 | $11,000–$22,750 |
| 2,000 sq ft (20 squares) | $12,900–$29,500 | $12,950–$29,550 |
| 2,500 sq ft (25 squares) | $15,850–$35,350 | $15,900–$35,400 |
| 3,000+ sq ft (30 squares) | $18,750–$41,150 | $18,800–$41,300 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What roofing pros earn in each metro
About 60% of a metal roof installation bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
No BLS metro wage series for Beaumont; we use Texas regional price parity instead.
San Antonio-New Braunfels metro · about 9% below the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.
Where does a smart roofing budget go in 2026?
Two roofs of the same square footage can price hundreds apart because of something you can't see from the ground — the deck under the old shingles. Add the tear-off-versus-overlay call and the shingle grade, and you have the decisions that actually move the number.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The risk case
Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.
The two things that actually protect a roofing budget are a real tear-off and a written rate for any deck repairs found along the way. The cheapest post-storm bid usually isn't the cheapest roof, long-term.
Beaumont vs San Antonio
Is metal roof installation cheaper in Beaumont or San Antonio?
Beaumont comes out ahead here, at roughly $21,200 for metal roof installation compared with $21,250 in San Antonio — a 0% ($50) gap as of 2026.
Why does metal roof installation cost more in San Antonio than Beaumont?
San Antonio's higher labor index (0.95 vs 0.95 in Beaumont) is the biggest factor, with the hot/hot climate split and permit fee differences playing a smaller role.
How much is metal roof installation in Beaumont, TX?
metal roof installation in Beaumont runs $12,900–$29,500 as of 2026 — most jobs land near $21,200.
When is the cheapest time to buy metal roof installation — and does it differ by city?
It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Beaumont and San Antonio (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.
Should I choose where to live based on metal roof installation cost?
Not really — the $50 gap is one-time, and smart timing and tighter quotes in San Antonio can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik