Furnace Replacement cost: Edina vs Minneapolis (2026)
Edina and Minneapolis are a near-perfect match on furnace replacement cost in 2026, both landing around $6,700.
Edina MN
Typically around $6,700
Minneapolis MN
Typically around $6,700
Edina vs Minneapolis: full breakdown
| Factor | Edina | Minneapolis |
|---|---|---|
| Typical 2026 cost | $6,700 | $6,700 |
| Estimated range | $4,750–$8,600 | $4,750–$8,600 |
| Labor index (vs US) | ×1.11 | ×1.11 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $225 | $225 |
| Labor share | $4,000 | $4,000 |
| Materials/equipment | $2,700 | $2,700 |
All figures are 2026 localized planning estimates for furnace replacement — get an actual quote before you commit.
A wash — choose on quality, not city
Neither metro has a cost edge on furnace replacement — spend your decision-making energy on the contractor, not the location.
Furnace replacement by type: Edina vs Minneapolis
Each furnace replacement option, priced separately for both metros — the same local labor, climate and permit adjustments applied per city, so you can compare like for like.
| Type | Edina | Minneapolis |
|---|---|---|
| Gas furnace | $4,650–$8,450 | $4,650–$8,450 |
| High-efficiency gas furnace | $4,150–$8,450 | $4,150–$8,450 |
| Electric furnace | $2,600–$5,600 | $2,600–$5,600 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
Furnace replacement by home size: Edina vs Minneapolis
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Edina | Minneapolis |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,550–$6,450 | $3,550–$6,450 |
| 1,500 sq ft (≈68,000 BTU) | $4,150–$7,400 | $4,150–$7,400 |
| 2,000 sq ft (≈90,000 BTU) | $4,750–$8,600 | $4,750–$8,600 |
| 2,500 sq ft (≈110,000 BTU) | $5,500–$9,800 | $5,500–$9,800 |
| 3,000 sq ft (≈130,000 BTU) | $6,200–$11,000 | $6,200–$11,000 |
| 3,500+ sq ft (≈150,000 BTU) | $6,900–$12,200 | $6,900–$12,200 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
What hvac pros earn in each metro
About 60% of a furnace replacement bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
A furnace or AC that dies mid-heat-wave gets replaced at whatever the on-call crew charges. One that gets swapped in April or October gets a competitive, unhurried quote instead.
How much should you really budget for HVAC in 2026?
What you pay for HVAC hinges less on the badge than on how the quote is built — the load calculation behind it, the efficiency tier, and the markup. Our take on where each one lands.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The efficiency-first case
In a hot-summer or cold-winter region, a higher SEER2/AFUE unit — or a heat pump — earns its premium back in lower bills, and utility and state rebates can still cut into the sticker (the federal 25C/25D credits ended Dec 2025). Run the payback math before defaulting to the cheapest box.
The brand on the unit matters far less than getting the sizing and installation right. Insist on a Manual J calculation, match efficiency to your climate, and claim every rebate available.
Edina vs Minneapolis
Is furnace replacement cheaper in Edina or Minneapolis?
There's no meaningful difference: furnace replacement runs about $6,700 in both places.
Why does furnace replacement cost more in Minneapolis than Edina?
Labor rates explain most of it — 1.11 in Minneapolis vs 1.11 in Edina. A cold climate versus cold accounts for the rest.
How much is furnace replacement in Edina, MN?
Expect to pay $4,750 to $8,600 for furnace replacement in Edina in 2026, averaging around $6,700.
Do hvac pros really charge more in one city?
Real wage data backs this up — skilled installers earn roughly $36.7/hr in Minneapolis-St. Paul-Bloomington compared with $36.7/hr in Minneapolis-St. Paul-Bloomington (BLS OEWS). Labor is about 60% of a furnace replacement job, so that wage gap is what mostly drives the price difference.
When is the cheapest time to buy furnace replacement — and does it differ by city?
The best window is the same in both Edina and Minneapolis: Spring and fall (Mar–May, Sep–Oct), when demand drops and installers discount to keep crews busy — typically 5–15% off peak pricing. The most expensive time anywhere is an emergency replacement during peak summer and mid-winter.
Should I choose where to live based on furnace replacement cost?
No — the cost is essentially identical between Edina and Minneapolis. Base the decision on the things that actually vary: contractor reputation, scope, equipment tier and timing.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik