Furnace Replacement cost: Conway vs Jonesboro (2026)
The two metros aren't quite in sync on furnace replacement: Conway sits 2% above Jonesboro, or roughly $5,250 versus $5,150 — about $100 apart.
Conway AR
Typically around $5,250
Jonesboro AR
Lower costTypically around $5,150
Conway vs Jonesboro: full breakdown
| Factor | Conway | Jonesboro |
|---|---|---|
| Typical 2026 cost | $5,250 | $5,150 |
| Estimated range | $3,750–$6,750 | $3,700–$6,600 |
| Labor index (vs US) | ×0.93 | ×0.92 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $200 | $200 |
| Labor share | $3,150 | $3,100 |
| Materials/equipment | $2,100 | $2,050 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
How much should this gap actually matter?
A 2% difference on furnace replacement is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.
Furnace replacement by type: Conway vs Jonesboro
Below, each furnace replacement option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Conway | Jonesboro |
|---|---|---|
| Gas furnace | $3,650–$6,650 | $3,600–$6,500 |
| High-efficiency gas furnace | $3,300–$6,650 | $3,200–$6,500 |
| Electric furnace | $2,050–$4,400 | $2,050–$4,300 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Furnace replacement by home size: Conway vs Jonesboro
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Conway | Jonesboro |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $2,800–$5,050 | $2,750–$4,950 |
| 1,500 sq ft (≈68,000 BTU) | $3,300–$5,800 | $3,200–$5,700 |
| 2,000 sq ft (≈90,000 BTU) | $3,750–$6,750 | $3,700–$6,600 |
| 2,500 sq ft (≈110,000 BTU) | $4,300–$7,650 | $4,250–$7,550 |
| 3,000 sq ft (≈130,000 BTU) | $4,850–$8,600 | $4,800–$8,450 |
| 3,500+ sq ft (≈150,000 BTU) | $5,450–$9,550 | $5,350–$9,350 |
All figures are 2026 localized planning estimates for furnace replacement — get an actual quote before you commit.
Cheapest time for furnace replacement in either city
Crews are busiest — and priciest — exactly when it's hottest or coldest, since that's when systems fail under load. Book in the mild months and you're negotiating from a position of choice, not a broken furnace.
How much should you really budget for HVAC in 2026?
Three factors move an HVAC quote more than anything else: how well it's sized, which efficiency tier you pick, and the brand markup. Our editors break down how they weigh each one.
The efficiency-first case
Where you face brutal summers or hard winters, a higher SEER2/AFUE system or a heat pump runs enough hours to claw back its premium through lower bills — and utility or state rebates can still trim the sticker even though the federal 25C/25D credits closed at the end of 2025. Do the payback arithmetic before you reach for the cheapest box on the lot.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
Skip the brand debate. A correctly sized system, an efficiency tier that fits your climate, and a properly commissioned install will save you more than any label ever could.
Conway vs Jonesboro
Is furnace replacement cheaper in Conway or Jonesboro?
Jonesboro wins on price: furnace replacement runs about $5,150 there versus $5,250 in Conway, a gap of roughly $100 (2%) as of 2026.
Why does furnace replacement cost more in Conway than Jonesboro?
It comes down to labor: Conway indexes at 0.93 against Jonesboro's 0.92. The mixed-vs-mixed climate difference adds to the gap.
How much is furnace replacement in Conway, AR?
furnace replacement in Conway runs $3,750–$6,750 as of 2026 — most jobs land near $5,250.
When is the cheapest time to buy furnace replacement — and does it differ by city?
Timing doesn't change by city here — Spring and fall (Mar–May, Sep–Oct) is the cheapest window in both Conway and Jonesboro, saving roughly 5–15%. Avoid peak summer and mid-winter in either location, when emergency replacements push prices up.
Should I choose where to live based on furnace replacement cost?
Probably not. Yes, $100 is a real gap, but it's a one-time cost you can partly offset in Conway with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik