Water Heaters · Revere, MA
How much does tank water heater replacement cost in Revere, MA? (2026)
In Revere, tank water heater replacement runs $1,450–$3,800, with most paying around $2,650 — about 26% above the national average. Replacing a standard storage-tank water heater, including the unit and installation.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $2,650
- Typical cost
- $2,650
- Labor vs US
- +12%
- Climate
- Cold
- Local permit
- $175
Refine your estimate
Tune it to your home to narrow the tank water heater replacement range.
Key takeaways for Revere
- Expect $1,450 to $3,800 for tank water heater replacement in Revere; most quotes cluster near $2,650, about 26% above the national average.
- Revere labor runs +12% versus the US average — the main reason the local price differs from the national figure.
- Around $175 of the range above goes to the local Water Heaters permit, not an extra line item.
- Schedule the replacement early — this typically holds up 8–12 years, and an emergency swap costs full price.
- Skip peak pricing by scheduling in Spring and early fall; the shift is worth about 5–10%.
- Federal 25C/25D tax credits and local utility rebates can lower the net cost — see the rebates section below.
What goes into the price in Revere
A typical Revere tank water heater replacement of $2,650 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Revere 2026 range |
|---|---|
| Materials & equipmentHardware and supplies for the job; national pricing applies almost everywhere you go. | $550 – $1,650 |
| Labor & installationCrew time for removal, installation and startup; local labor rates drive most of the swing here. | $725 – $1,975 |
| Permit & feesThe Water Heaters permit fee for this metro, based on local rates. | $175 |
| Total installed cost | $1,450 – $3,800 |
Split from the Revere estimate using a 55% local-labor share; line items sum to the total.
Why tank water heater replacement costs what it does in Revere
- Expect labor here to run 12% above the national norm (based on price levels for the Boston-Cambridge-Newton metro area) — that's what raises the total.
- The cold climate in Revere adds roughly 3% to typical tank water heater replacement pricing versus a neutral climate.
- Budget about $175 for the local Water Heaters permit in Revere — already folded into the estimate above.
Tank Water Heater Replacement cost by tank capacity in Revere
Storage-tank cost scales with capacity — measured in gallons and matched to your household size. A bigger tank costs more for the unit and a little more to install, but undersizing means running out of hot water.
| tank capacity | Revere 2026 range |
|---|---|
| 30 gal (1–2 people) | $1,350 – $2,750 |
| 40 gal (2–3 people) | $1,450 – $3,200 |
| 50 gal (3–4 people) | $1,700 – $3,550 |
| 75 gal (5+ people) | $2,250 – $4,250 |
National size ranges localized to Revere labor and climate.
Tank Water Heater Replacement cost by type in Revere
| Gas (40–50 gal) | $1,450 – $2,250 |
| Electric (40–50 gal) | $1,200 – $2,050 |
| High-capacity (75 gal) | $2,250 – $3,800 |
Adjusted to Revere from national type-level ranges.
Tank Water Heater Replacement cost by efficiency in Revere
Storage tanks come in gas and electric. Gas units cost more upfront but run cheaper where gas is available; high-efficiency condensing gas models cost the most but run the cheapest and may qualify for utility rebates.
| Standard electric tankCheapest upfront; higher running cost | $1,200 – $2,750 |
| Standard gas tankLower operating cost where gas is available | $1,450 – $3,450 |
| High-efficiency condensing gas (ENERGY STAR)Lowest gas bills; check utility rebates | $2,250 – $4,350 |
Labor vs. materials in Revere
Install crew, removal, permit & startup — the part Revere rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $2,650 Revere project; your mix varies with scope.
Skilled installers in the Boston-Cambridge-Newton area earn about $38.4/hr (23% above the US average, per BLS metro wage data) — the local wage is what moves the labor half of your tank water heater replacement cost.
How we estimate it
| National range | $1,100 – $3,100 |
| Revere labor adjustment | ×1.13 |
| cold climate factor | ×1.03 |
| Local permit | +$175 |
| Revere estimate | $1,450 – $3,800 |
Promo prices vs. the real cost
That advertised install price usually stops at the unit on the shelf — the permit, an expansion tank, updated venting and hauling off the old heater all land on the final invoice. Here's where the ad number and the real one part ways:
- "Basic swap" specialfrom ~$1,200 (simple tank)
- Service / diagnostic call$75–$150
- "Free" estimate$0 — it's a sales visit
Additional tank water heater replacement costs to budget for
These hit some bids and skip others. The deciding factors are your home's condition, layout and what the crew finds once work begins.
| Old heater removal & disposal | $50 – $200 |
| Expansion tank (often code-required) | $100 – $350 |
| Drain pan & new shutoff valves | $50 – $250 |
| Bringing venting / gas line up to code | $150 – $800 |
| Seismic straps (where required) | $30 – $150 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- Labor, code updates and permit
- Connection to water, gas/electrical and venting
- Removal and disposal of the old heater
- The storage-tank unit
What affects the cost
- Code-required upgrades (expansion tank, venting, straps)
- Tank capacity (40, 50 or 75+ gallons)
- Fuel type (gas vs electric)
- Accessibility of the install location
Ways to save on tank water heater replacement in Revere
- Electric tanks cost less upfront than gas
- Check rebates on high-efficiency models
- Right-size the tank to your household — bigger isn't always better
- Replace before failure to avoid emergency-call premiums
How long does tank water heater replacement last in Revere?
Tank water heaters typically last 8–12 years; hard water and skipped flushing shorten this.
Flush the tank yearly and check the anode rod every few years to prevent corrosion.
Signs you need tank water heater replacement in Revere
- The heater is 10+ years old (at or past its service life)
- Rusty, cloudy or coffee-colored hot water
- You run out of hot water faster than you used to
- Water pooling around the base of the tank (a leak — replace, don't wait)
- Rumbling, popping or banging from sediment buildup
- Visible rust or corrosion on the tank or fittings
Repair or replace in Revere?
Repair if…
- The unit is under ~8 years old
- It's a cheap part — thermostat, heating element, or thermocouple
- The tank shell is sound and not leaking
Replace if…
- The tank itself is leaking
- It's 10+ years old and needs a meaningful repair
- Repeated repairs are adding up
- You want to switch to a more efficient gas or hybrid model
Cost to run
Yearly running cost — what most cost guides skip
Install price is only half the story. Over 10 years, the fuel bill often outweighs the price difference between models. National operating-cost estimates below (FTC EnergyGuide):
| Type | Per year | 10-year fuel |
|---|---|---|
Heat pump water heaterCheapest to run Cheapest to run — pulls heat from the air, ~3–4× more efficient than resistance. | $130 | $1,300 |
Gas tankless On-demand gas; no standby loss, so cheaper to run than a gas tank. | $270 | $2,700 |
Gas storage tank Low running cost where natural gas is cheap; some standby heat loss. | $330 | $3,300 |
Electric tankless On-demand electric; needs a heavy electrical service upgrade. | $500 | $5,000 |
Electric storage tankThis page Cheapest to buy, most expensive to run at national electricity prices. | $570 | $5,700 |
Verified July 2026. Figures use FTC EnergyGuide / DOE (national average fuel prices) — your state's fuel prices move them: where electricity is cheap or gas is expensive the ranking shifts. Check current EIA residential energy prices for your state.
Rebates & tax credits
The federal 25C tax credit for high-efficiency water heaters ended December 31, 2025 and is not available for 2026 installs. Many gas and water utilities still offer their own rebates on ENERGY STAR condensing gas tanks — check your provider and the DSIRE database — and the lower running cost adds up over the tank's life.
Cheapest time for tank water heater replacement in Revere
An aging tank tends to give out in winter, when it's working hardest against cold incoming water — and that's exactly when replacement costs the most. Get ahead of it.
Why tank water heater replacement quotes vary — and how to compare them fairly
One bid high, one low, same house? The variable is scope. Here's what pushes the figure up or down and how to get quotes you can actually compare.
Why a quote looks high (or low)
- Code work (expansion tank, venting, drain pan, straps) may be excluded from a low bid.
- Fuel type and first-hour/GPM sizing change the equipment cost.
- Tank vs. tankless is a different job — tankless often needs gas-line or electrical-panel upgrades.
Get an apples-to-apples bid
- For tankless, ask if the gas line or electrical panel needs upgrading.
- Confirm old-unit removal and disposal are in the price.
- Decide tank vs. tankless first, then compare like models.
- Ask whether code upgrades (expansion tank, venting) are included.
Questions to ask Revere Water Heaters pros
Before you pick, make each contractor answer the same things — gaps in their replies tell you as much as the price.
- 1Will the new unit meet current code (expansion tank, venting, seismic straps, drain pan)?
- 2Is removal and disposal of the old heater included in the price?
- 3For tankless: does my gas line or electrical panel need an upgrade?
- 4What's the first-hour rating / GPM, and is it sized for my household?
- 5What does the warranty cover, and who handles warranty service?
Tank Water Heater Replacement in Revere
How much does tank water heater replacement cost in Revere, MA?
Revere's going rate for tank water heater replacement is $1,450–$3,800 in 2026, with $2,650 the number most homeowners end up paying. The figure is adjusted for local labor rates, cold-climate factors and permit fees.
Is tank water heater replacement more expensive in Revere than average?
Why the gap? Revere prices about 26% higher than the national average, and local labor — indexed at 1.13 against the US average — does most of the work. — the local Water Heaters permit, about $175, is part of that too.
Do I need a permit for tank water heater replacement in Revere?
The estimate above already covers the Water Heaters permit Revere generally requires for this job, so the $175 or so it costs won't land as a surprise.
What affects tank water heater replacement cost the most?
Start with the fundamentals — replacing a standard storage-tank water heater, including the unit and installation. What should you watch? Equipment or material grade, the home's size and complexity, local labor rates, and your cold climate zone — in roughly that order.
Tank or tankless — and what should you budget?
Fuel type and household size come after the real fork in the road: tank, tankless, or heat-pump. That single choice sets both the install bill and every hot-water bill that follows.
The heat-pump case
A heat-pump (hybrid) water heater costs the most upfront but slashes operating cost and earns the strongest utility rebates where offered — the long-run winner where the install location suits it.
The tankless case
The tankless premium buys longevity and endless supply: nothing sitting hot around the clock, a lifespan roughly double a tank's, and no cold showers when demand spikes. The catch lives in the setup, since most retrofits need a bigger gas line or an electrical upgrade first. Larger households planning to stay put recover that cost fastest.
The simple-swap case
When money is the constraint and the existing tank has kept up with the household, dropping in the same fuel type and capacity is the least disruptive move. No venting rework, no new gas line, no panel space to find — a plumber can pull the old unit and set the new one before lunch.
There's no universally "best" water heater — only the one that fits your budget and timeline. Tight budget, go tank; want endless hot water, go tankless; optimizing for the lowest bill, go heat-pump.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national tank water heater replacement ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Revere using the BLS metro wage data labor index (×1.13 here), the IECC cold-climate factor (×1.03) and a typical local permit fee (≈$175). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Revere tank water heater replacement estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Tank water heater replacement alternatives in Revere
Homeowners in Revere often pair this with
A tank water heater replacement rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Revere
Browse local 2026 costs for every home project in Revere, MA.