Water Heaters · Murray, UT
How much does tank water heater replacement cost in Murray, UT? (2026)
In Murray, tank water heater replacement runs $1,250–$3,300, with most paying around $2,300 — about 10% above the national average. Replacing a standard storage-tank water heater, including the unit and installation.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $2,300
- Typical cost
- $2,300
- Labor vs US
- −4%
- Climate
- Cold
- Local permit
- $150
Refine your estimate
Tune it to your home to narrow the tank water heater replacement range.
Key takeaways for Murray
- Murray homeowners typically pay $1,250–$3,300 for tank water heater replacement, with $2,300 the usual landing spot — about 10% above the national average.
- Local labor in Murray is −4% relative to the national average, which is what pushes this estimate away from the countrywide number.
- Set aside roughly $150 for the permit; that's already part of the range above, not an add-on.
- Schedule the replacement early — this typically holds up 8–12 years, and an emergency swap costs full price.
- Roughly 5–10% comes off when you book in Spring and early fall instead of peak season.
- Don't price this without checking the rebates section below — federal 25C/25D credits and local utility incentives can bring the net cost down.
What goes into the price in Murray
A typical Murray tank water heater replacement of $2,300 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Murray 2026 range |
|---|---|
| Materials & equipmentHardware and supplies for the job; national pricing applies almost everywhere you go. | $500 – $1,400 |
| Labor & installationInstall crew, removal and startup — the part local rates move most. | $600 – $1,750 |
| Permit & feesThe Water Heaters permit fee for this metro, based on local rates. | $150 |
| Total installed cost | $1,250 – $3,300 |
Split from the Murray estimate using a 55% local-labor share; line items sum to the total.
Why tank water heater replacement costs what it does in Murray
- Labor in Murray runs about 4% below the national average (based on price levels for the Salt Lake City-Murray metro area), which lowers the installed price.
- Because Murray sits in a cold climate zone, tank water heater replacement costs run about 3% higher than a neutral-climate baseline.
- Murray's Water Heaters permit runs roughly $150, which is already part of the number above.
Tank Water Heater Replacement cost by tank capacity in Murray
Storage-tank cost scales with capacity — measured in gallons and matched to your household size. A bigger tank costs more for the unit and a little more to install, but undersizing means running out of hot water.
| tank capacity | Murray 2026 range |
|---|---|
| 30 gal (1–2 people) | $1,150 – $2,400 |
| 40 gal (2–3 people) | $1,250 – $2,800 |
| 50 gal (3–4 people) | $1,450 – $3,100 |
| 75 gal (5+ people) | $1,950 – $3,700 |
National size ranges localized to Murray labor and climate.
Tank Water Heater Replacement cost by type in Murray
| Gas (40–50 gal) | $1,250 – $1,950 |
| Electric (40–50 gal) | $1,050 – $1,750 |
| High-capacity (75 gal) | $1,950 – $3,300 |
Adjusted to Murray from national type-level ranges.
Tank Water Heater Replacement cost by efficiency in Murray
Storage tanks come in gas and electric. Gas units cost more upfront but run cheaper where gas is available; high-efficiency condensing gas models cost the most but run the cheapest and may qualify for utility rebates.
| Standard electric tankCheapest upfront; higher running cost | $1,050 – $2,400 |
| Standard gas tankLower operating cost where gas is available | $1,250 – $3,000 |
| High-efficiency condensing gas (ENERGY STAR)Lowest gas bills; check utility rebates | $1,950 – $3,800 |
Labor vs. materials in Murray
Install crew, removal, permit & startup — the part Murray rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $2,300 Murray project; your mix varies with scope.
Skilled installers in the Salt Lake City-Murray area earn about $30.1/hr (3% below the US average, per BLS metro wage data) — the local wage is what moves the labor half of your tank water heater replacement cost.
How we estimate it
| National range | $1,100 – $3,100 |
| Murray labor adjustment | ×0.98 |
| cold climate factor | ×1.03 |
| Local permit | +$150 |
| Murray estimate | $1,250 – $3,300 |
Promo prices vs. the real cost
An eye-catching quote tends to assume nothing about your setup needs to change. Bring it up to current code — drain pan, seismic strapping, proper venting, a pulled permit — and the gaps below are what fill in:
- Service / diagnostic call$75–$150
- "Basic swap" specialfrom ~$1,200 (simple tank)
- "Free" estimate$0 — it's a sales visit
Additional tank water heater replacement costs to budget for
Expect a few of these rather than all. Which ones apply tracks with access, hidden damage and local code.
| Old heater removal & disposal | $50 – $200 |
| Expansion tank (often code-required) | $100 – $350 |
| Drain pan & new shutoff valves | $50 – $250 |
| Bringing venting / gas line up to code | $150 – $800 |
| Seismic straps (where required) | $30 – $150 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- The storage-tank unit
- Removal and disposal of the old heater
- Connection to water, gas/electrical and venting
- Labor, code updates and permit
What affects the cost
- Fuel type (gas vs electric)
- Code-required upgrades (expansion tank, venting, straps)
- Tank capacity (40, 50 or 75+ gallons)
- Accessibility of the install location
Ways to save on tank water heater replacement in Murray
- Check rebates on high-efficiency models
- Electric tanks cost less upfront than gas
- Replace before failure to avoid emergency-call premiums
- Right-size the tank to your household — bigger isn't always better
How long does tank water heater replacement last in Murray?
Tank water heaters typically last 8–12 years; hard water and skipped flushing shorten this.
Flush the tank yearly and check the anode rod every few years to prevent corrosion.
Signs you need tank water heater replacement in Murray
- The heater is 10+ years old (at or past its service life)
- Rusty, cloudy or coffee-colored hot water
- You run out of hot water faster than you used to
- Water pooling around the base of the tank (a leak — replace, don't wait)
- Rumbling, popping or banging from sediment buildup
- Visible rust or corrosion on the tank or fittings
Repair or replace in Murray?
Repair if…
- The unit is under ~8 years old
- It's a cheap part — thermostat, heating element, or thermocouple
- The tank shell is sound and not leaking
Replace if…
- The tank itself is leaking
- It's 10+ years old and needs a meaningful repair
- Repeated repairs are adding up
- You want to switch to a more efficient gas or hybrid model
Cost to run
Yearly running cost — what most cost guides skip
Install price is only half the story. Over 10 years, the fuel bill often outweighs the price difference between models. National operating-cost estimates below (FTC EnergyGuide):
| Type | Per year | 10-year fuel |
|---|---|---|
Heat pump water heaterCheapest to run Cheapest to run — pulls heat from the air, ~3–4× more efficient than resistance. | $130 | $1,300 |
Gas tankless On-demand gas; no standby loss, so cheaper to run than a gas tank. | $270 | $2,700 |
Gas storage tank Low running cost where natural gas is cheap; some standby heat loss. | $330 | $3,300 |
Electric tankless On-demand electric; needs a heavy electrical service upgrade. | $500 | $5,000 |
Electric storage tankThis page Cheapest to buy, most expensive to run at national electricity prices. | $570 | $5,700 |
Verified July 2026. Figures use FTC EnergyGuide / DOE (national average fuel prices) — your state's fuel prices move them: where electricity is cheap or gas is expensive the ranking shifts. Check current EIA residential energy prices for your state.
Rebates & tax credits
The federal 25C tax credit for high-efficiency water heaters ended December 31, 2025 and is not available for 2026 installs. Many gas and water utilities still offer their own rebates on ENERGY STAR condensing gas tanks — check your provider and the DSIRE database — and the lower running cost adds up over the tank's life.
Cheapest time for tank water heater replacement in Murray
An aging tank tends to give out in winter, when it's working hardest against cold incoming water — and that's exactly when replacement costs the most. Get ahead of it.
Why tank water heater replacement quotes vary — and how to compare them fairly
Price differences on an identical job trace back to the assumptions each contractor made; understand those and the 'expensive' bid often turns out fair.
Why a quote looks high (or low)
- Removal and disposal of the old unit is sometimes a hidden add-on.
- Code work (expansion tank, venting, drain pan, straps) may be excluded from a low bid.
- Tank vs. tankless is a different job — tankless often needs gas-line or electrical-panel upgrades.
Get an apples-to-apples bid
- Ask whether code upgrades (expansion tank, venting) are included.
- For tankless, ask if the gas line or electrical panel needs upgrading.
- Decide tank vs. tankless first, then compare like models.
- Confirm old-unit removal and disposal are in the price.
Questions to ask Murray Water Heaters pros
You can't judge bids side by side unless they cover the same ground; run through these with every pro on your list.
- 1Will the new unit meet current code (expansion tank, venting, seismic straps, drain pan)?
- 2Is removal and disposal of the old heater included in the price?
- 3For tankless: does my gas line or electrical panel need an upgrade?
- 4What's the first-hour rating / GPM, and is it sized for my household?
- 5What does the warranty cover, and who handles warranty service?
Tank Water Heater Replacement in Murray
How much does tank water heater replacement cost in Murray, UT?
In Murray, tank water heater replacement typically costs $1,250 to $3,300 in 2026, with most homeowners paying around $2,300. That range already accounts for Murray's labor rates, its cold climate and local permit costs.
Is tank water heater replacement more expensive in Murray than average?
Murray is about 10% higher than the national average, mainly because local labor runs at an index of 0.98 relative to the US average., and factor in about $150 for the local Water Heaters permit.
Do I need a permit for tank water heater replacement in Murray?
Expect to pull a Water Heaters permit in Murray — about $150 — which is already built into the estimate above, not an extra charge.
What affects tank water heater replacement cost the most?
Replacing a standard storage-tank water heater, including the unit and installation. That's the baseline — the price moves from there. Grade of equipment and materials tops the list, followed by home size and complexity, local labor, and the cold climate zone.
Tank or tankless — and what should you budget?
Three formats, three very different cost profiles. Our editors on how to decide which one actually fits your household.
The simple-swap case
When money is the constraint and the existing tank has kept up with the household, dropping in the same fuel type and capacity is the least disruptive move. No venting rework, no new gas line, no panel space to find — a plumber can pull the old unit and set the new one before lunch.
The heat-pump case
A heat-pump (hybrid) water heater costs the most upfront but slashes operating cost and earns the strongest utility rebates where offered — the long-run winner where the install location suits it.
The tankless case
Going tankless means paying more at install — often for a resized gas line or a dedicated electrical circuit — in exchange for hot water that never runs dry and a unit that outlives two conventional tanks. Dropping the standby loss of a constantly reheated reservoir trims the monthly bill on top of that. It fits a full house that isn't selling anytime soon.
Budget and time horizon settle this more than any spec sheet. A tank clears the lowest hurdle, tankless buys convenience and a longer life, and a heat-pump chases the cheapest years of operation once it has the space to run.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national tank water heater replacement ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Murray using the BLS metro wage data labor index (×0.98 here), the IECC cold-climate factor (×1.03) and a typical local permit fee (≈$150). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Murray tank water heater replacement estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Tank water heater replacement alternatives in Murray
Homeowners in Murray often pair this with
A tank water heater replacement rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Murray
Browse local 2026 costs for every home project in Murray, UT.