Plumbing · Murray, UT
How much does sewer line replacement cost in Murray, UT? (2026)
In Murray, sewer line replacement runs $3,350–$12,600, with most paying around $8,000 — about 7% above the national average. Replacing the main sewer line from the home to the municipal connection (trenchless or traditional excavation).
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $8,000
- Typical cost
- $8,000
- Labor vs US
- −4%
- Climate
- Cold
- Local permit
- $250
Refine your estimate
Tune it to your home to narrow the sewer line replacement range.
Key takeaways for Murray
- In Murray, sewer line replacement runs $3,350–$12,600 — call it $8,000 for a typical job, about 7% above the national average.
- This estimate departs from the national number mainly because Murray labor sits −4% versus the US average.
- Budget about $250 for the local Plumbing permit; it's already included above.
- Service life runs 50–100 years on average; replacing on your schedule beats replacing on an emergency one.
- Off-peak winter for planned work is the low-price window — about Around 5% under peak rates.
What goes into the price in Murray
A typical Murray sewer line replacement of $8,000 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Murray 2026 range |
|---|---|
| Materials & equipmentEquipment and supplies, which price out close to the national baseline. | $1,250 – $4,950 |
| Labor & installationLabor to remove the old system and install the new one — this is where your city's wage index shows up. | $1,850 – $7,400 |
| Permit & feesWhat this city's building department charges for a Plumbing permit. | $250 |
| Total installed cost | $3,350 – $12,600 |
Split from the Murray estimate using a 60% local-labor share; line items sum to the total.
Why sewer line replacement costs what it does in Murray
- Expect labor here to run 4% below the national norm (based on price levels for the Salt Lake City-Murray metro area) — that's what lowers the total.
- Because Murray sits in a cold climate zone, sewer line replacement costs run about 5% higher than a neutral-climate baseline.
- Budget about $250 for the local Plumbing permit in Murray — already folded into the estimate above.
Sewer Line Replacement cost by line length in Murray
Sewer replacement is priced largely by the length of line from the house to the city main, at roughly $50–$250 per foot depending on method, depth, and what's above the trench.
| line length | Murray 2026 range |
|---|---|
| 25 ft (short run) | $2,300 – $6,450 |
| 50 ft (typical) | $3,350 – $9,500 |
| 75 ft | $4,900 – $12,600 |
| 100+ ft (long / deep run) | $6,450 – $18,800 |
National size ranges localized to Murray labor and climate.
Sewer Line Replacement cost by type in Murray
| Trenchless lining (CIPP) | $4,350 – $12,600 |
| Pipe bursting | $5,400 – $13,650 |
| Traditional excavation | $3,350 – $13,650 |
Adjusted to Murray from national type-level ranges.
Sewer Line Replacement cost by efficiency in Murray
The install method matters as much as the length. Trenchless (pipe bursting or lining) costs more per foot but spares your yard, driveway, and landscaping; traditional open-trench digging is cheaper per foot but tears up the surface.
| Traditional open-trench digPer foot; lowest per-foot cost but full surface restoration | $300 – $400 |
| Trenchless pipe lining (CIPP)Per foot; cures a liner inside the old pipe, minimal digging | $350 – $500 |
| Trenchless pipe burstingPer foot; pulls a new pipe through, breaking the old one | $300 – $450 |
Labor vs. materials in Murray
Install crew, removal, permit & startup — the part Murray rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $8,000 Murray project; your mix varies with scope.
Skilled installers in the Salt Lake City-Murray area earn about $30.1/hr (3% below the US average, per BLS metro wage data) — the local wage is what moves the labor half of your sewer line replacement cost.
How we estimate it
| National range | $3,000 – $12,000 |
| Murray labor adjustment | ×0.98 |
| cold climate factor | ×1.05 |
| Local permit | +$250 |
| Murray estimate | $3,350 – $12,600 |
Promo prices vs. the real cost
Service-call pricing is separate from the project cost:
- Camera inspection$100–$350 (sometimes waived)
- "Free" estimate on big jobs$0 — it's a sales visit
- Service / diagnostic call$75–$200
Additional sewer line replacement costs to budget for
Only a handful of these will touch your total. Which ones depend on what's already in place and how the crew has to reach it.
| Sewer camera inspection (diagnosis)Confirm the scope before any digging — often credited toward the job | $100 – $500 |
| Permit & inspection | $100 – $1,000 |
| Landscape / lawn restorationOpen-trench only; trenchless avoids most of this | $300 – $4,000 |
| Driveway / sidewalk / concrete repairIf the line runs under paving | $500 – $5,000 |
| Tree / root removal in the trench path | $200 – $2,000 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- Connection to home and city main
- Excavation or trenchless boring
- Backfill, basic restoration and permit
- New sewer pipe
What affects the cost
- Soil conditions and access
- Line length and depth (frost line)
- Landscaping or driveway restoration
- Trenchless vs traditional dig
Ways to save on sewer line replacement in Murray
- Trenchless avoids costly excavation and restoration
- Compare excavation vs pipe-lining quotes
- Get a camera inspection — a spot repair may do
- Check if the city owns part of the line
How long does sewer line replacement last in Murray?
Modern PVC and HDPE sewer pipe lasts 50–100 years; cured-in-place liners are rated for ~50 years.
A new line needs little upkeep; budget for an occasional camera check or jetting if you have nearby trees.
Signs you need sewer line replacement in Murray
- Recurring drain clogs and backups across multiple fixtures
- Sewage smell in the yard or around floor drains
- Soggy, sunken, or unusually green patches in the lawn (sewage leak)
- Multiple slow drains throughout the house at once
- Gurgling toilets or drains when other fixtures run
- Tree-root intrusion confirmed on a camera inspection
- Old clay, cast-iron, or Orangeburg (tar-paper) sewer pipe
Repair or replace in Murray?
Repair if…
- Damage is one isolated crack or offset joint
- The rest of the line is structurally sound on camera
- A spot repair or partial trenchless lining can reach it
Replace if…
- The line is clay, cast iron, or Orangeburg and failing
- There are multiple breaks, bellies, or root intrusions
- A section has collapsed or sagged (recurring backups)
- Repeated rooter/jetting visits aren't holding the problem
Cost calculator
Sewer line cost by method in Murray, UT
Enter the run length (most home laterals are 40–100 ft, house to street). Per-foot ranges are localized to Murray, UT labor.
| Method | Per foot | Total (60 ft) |
|---|---|---|
Open-trench (dig & replace) Traditional dig-up. Cheapest per foot but adds surface restoration (lawn, driveway, patio). | $49–$123 | $2,950–$7,350 |
Pipe bursting (trenchless) Pulls a new pipe through the old one via two access pits — minimal digging. | $59–$196 | $3,550–$11,750 |
CIPP lining (cure-in-place) A resin liner cured inside the existing pipe. No trench, but the pipe must be intact enough to line. | $78–$245 | $4,700–$14,700 |
Add surface restoration for open-trench (concrete/driveway $2–$25/sq ft) and permits where a run crosses into the public right-of-way. Per-foot ranges are national benchmarks localized to Murray, UT labor — a research estimate, not a quote.
Cheapest time for sewer line replacement in Murray
An actual emergency always pays full rate — there's no negotiating room. But a planned repipe or sewer-line job can be timed to a slower month, where crews have more attention to give and a little more room on price.
Why sewer line replacement quotes vary — and how to compare them fairly
A wide spread between bids rarely means someone is overcharging; it usually means they priced different work. Below is what moves the number and how to line the quotes up.
Why a quote looks high (or low)
- Trenchless vs. traditional dig is a major price difference.
- Pipe material (PEX vs. copper) changes both cost and longevity.
- Scope is often unknown until a camera inspection confirms it.
Get an apples-to-apples bid
- Compare pipe material on equal terms.
- Confirm permits, inspection and restoration are included.
- Ask whether trenchless or dig fits your situation and why.
- Require a camera inspection so the scope is confirmed before work.
Questions to ask Murray Plumbing pros
Before you pick, make each contractor answer the same things — gaps in their replies tell you as much as the price.
- 1Trenchless vs. traditional dig — which fits my situation and why?
- 2Is a camera inspection included so we confirm the scope before digging?
- 3Are permits, inspection, and surface/landscape restoration included?
- 4What pipe material are you using (PEX vs. copper) and why?
- 5Who is responsible for the city-owned portion of the line?
Sewer Line Replacement in Murray
How much does sewer line replacement cost in Murray, UT?
Expect to pay $3,350 to $12,600 for sewer line replacement in Murray in 2026 — most quotes cluster around $8,000. Local labor, the cold climate and permit fees are all baked into that number.
Is sewer line replacement more expensive in Murray than average?
Labor is the biggest lever here: at an index of 0.98 versus the US average, Murray ends up about 7% higher than the national average., before the Plumbing permit, which runs about $250.
Do I need a permit for sewer line replacement in Murray?
Budget about $250 for the Plumbing permit most Murray jobs like this require — and note it already sits inside the estimate above, not on top of it.
What affects sewer line replacement cost the most?
In plain terms, replacing the main sewer line from the home to the municipal connection (trenchless or traditional excavation). Grade of equipment and materials tops the list, followed by home size and complexity, local labor, and the cold climate zone.
How do you budget a major plumbing job?
Repipes and sewer lines are scope-driven — the method and what's underground decide the price. Our editors on the trade-offs.
The diagnosis-first case
Never budget a sewer or repipe job from a guess. A camera inspection confirms the real scope and stops you paying for work you don't need — or being blindsided by work you do.
The method case
Trenchless runs a higher per-foot rate, but the savings hide in what you never have to rebuild — no torn-up driveway, no re-sodded lawn, no ripped-out patio. Open-cut digging only wins on price when there's almost nothing on top of the line to put back.
The material case
PEX is cheaper, faster and freeze-tolerant; copper costs more but lasts longer and some buyers prefer it. Match the material to your climate and how long you'll own the home.
Scope, not brand, is what sets a plumbing price. Confirm it with a camera inspection, compare trenchless against the full cost of a dig — landscaping included — and match pipe material to your climate.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national sewer line replacement ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Murray using the BLS metro wage data labor index (×0.98 here), the IECC cold-climate factor (×1.05) and a typical local permit fee (≈$250). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Murray sewer line replacement estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Homeowners in Murray often pair this with
A sewer line replacement rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Murray
Browse local 2026 costs for every home project in Murray, UT.