Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Tile Roof Installation cost: Akron vs Dayton (2026)

Budget-wise, tile roof installation in Akron ($17,150) runs 1% more than in Dayton ($17,050), a roughly $100 spread.

Akron OH

$10,250 $24,050

Typically around $17,150

Dayton OH

Lower cost
$10,200 $23,900

Typically around $17,050

Akron costs about $100 (1%) more than Dayton for tile roof installation, largely because of the local labor rate gap.
Side by side

Akron vs Dayton: full breakdown

FactorAkronDayton
Typical 2026 cost$17,150$17,050
Estimated range$10,250–$24,050$10,200–$23,900
Labor index (vs US)×0.95×0.95
Climate zoneColdCold
Climate factor×1×1
Local permit$250$250
Labor share$10,300$10,250
Materials/equipment$6,850$6,800

Tile roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

Is the price difference a dealbreaker?

1% is within noise for tile roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Tile roof installation by type: Akron vs Dayton

Below, each tile roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeAkronDayton
Concrete tile$10,250$20,250$10,200$20,100
Clay / terracotta tile$13,600$26,900$13,500$26,750
Slate$19,300$47,850$19,150$47,550

Treat these as 2026 localized estimates for tile roof installation, not quotes from a contractor.

By size

Tile roof installation by roof size: Akron vs Dayton

Tile is priced per square (100 sq ft) and runs about $7–$15 per sq ft installed. Its weight matters: many homes need the roof structure reinforced before concrete or clay tile can go on.

SizeAkronDayton
1,000 sq ft (10 squares)$6,900$13,600$6,850$13,500
1,500 sq ft (15 squares)$8,800$18,350$8,750$18,200
2,000 sq ft (20 squares)$10,250$24,050$10,200$23,900
2,500 sq ft (25 squares)$12,650$28,800$12,550$28,650
3,000+ sq ft (30 squares)$15,500$34,500$15,400$34,300

All figures are 2026 localized planning estimates for tile roof installation — get an actual quote before you commit.

Best time to buy

Cheapest time for tile roof installation in either city

The material dictates the season (shingles need warmth to seal), but the price is set by demand, and demand spikes after every regional hailstorm. Booking your spot in the quiet winter months for spring work avoids that spike.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

A roofing quote can hide a lot behind a single number — whether it's a true tear-off, the shingle grade, and what's under the surface. Here's how our editors sort through it.

The risk case

The surprise that wrecks a roofing budget is rot in the decking, and you rarely see it until the old shingles come off. Fix the price per replacement sheet in the contract before the crew starts, so a low bid can't quietly climb once the deck is open.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

Our take

Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.

FAQ

Akron vs Dayton

Is tile roof installation cheaper in Akron or Dayton?

In 2026, tile roof installation is cheaper in Dayton at about $17,050, versus $17,150 in Akron — a difference of about $100 (1%).

Why does tile roof installation cost more in Akron than Dayton?

It comes down to labor: Akron indexes at 0.95 against Dayton's 0.95. The cold-vs-cold climate difference adds to the gap.

How much is tile roof installation in Akron, OH?

Akron homeowners can expect $10,250 to $24,050 for tile roof installation in 2026, with $17,150 the typical number.

When is the cheapest time to buy tile roof installation — and does it differ by city?

It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Akron and Dayton (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.

Should I choose where to live based on tile roof installation cost?

Not really — the $100 gap is one-time, and smart timing and tighter quotes in Akron can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.

Keep comparing

Compare tile roof installation in other cities

Updated June 2026 · By Serhat Özçelik