Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Kennewick vs Spokane (2026)

The two metros aren't quite in sync on metal roof installation: Kennewick sits 0% above Spokane, or roughly $22,300 versus $22,200 — about $100 apart.

Kennewick WA

$13,600 $31,000

Typically around $22,300

Spokane WA

Lower cost
$13,550 $30,850

Typically around $22,200

Expect to pay roughly $100 (0%) more for metal roof installation in Kennewick than in Spokane — local labor is the main reason.
Side by side

Kennewick vs Spokane: full breakdown

FactorKennewickSpokane
Typical 2026 cost$22,300$22,200
Estimated range$13,600–$31,000$13,550–$30,850
Labor index (vs US)×1.02×1.02
Climate zoneMixedMixed
Climate factor×1×1
Local permit$300$300
Labor share$13,400$13,300
Materials/equipment$8,900$8,900

Treat these as 2026 localized estimates for metal roof installation, not quotes from a contractor.

The verdict

Is the gap worth worrying about?

A 0% difference on metal roof installation is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.

By type

Metal roof installation by type: Kennewick vs Spokane

Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeKennewickSpokane
Corrugated steel (exposed fastener)$9,500$18,750$9,450$18,600
Standing-seam steel$18,750$36,150$18,600$35,950
Aluminum$14,650$28,950$14,550$28,800
Copper$31,000$61,750$30,850$61,400
Zinc$28,950$56,600$28,800$56,300

Treat these as 2026 localized estimates for metal roof installation, not quotes from a contractor.

By size

Metal roof installation by roof size: Kennewick vs Spokane

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizeKennewickSpokane
1,000 sq ft (10 squares)$8,500$16,700$8,450$16,600
1,500 sq ft (15 squares)$11,550$23,850$11,500$23,700
2,000 sq ft (20 squares)$13,600$31,000$13,550$30,850
2,500 sq ft (25 squares)$16,700$37,150$16,600$36,950
3,000+ sq ft (30 squares)$19,750$43,300$19,650$43,050

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Best time to buy

Cheapest time for metal roof installation in either city

Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

The value case

Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.

The do-it-right case

Skipping the tear-off means burying whatever's failing underneath, and a second layer bakes the shingles from below until they curl early. Doing it properly means stripping to the deck, then paying for real underlayment, flashing and airflow — the work that sets how long the roof lasts, not just how it looks the first week.

Our take

Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.

FAQ

Kennewick vs Spokane

Is metal roof installation cheaper in Kennewick or Spokane?

In 2026, metal roof installation is cheaper in Spokane at about $22,200, versus $22,300 in Kennewick — a difference of about $100 (0%).

Why does metal roof installation cost more in Kennewick than Spokane?

Labor rates explain most of it — 1.02 in Kennewick vs 1.02 in Spokane. A mixed climate versus mixed accounts for the rest.

How much is metal roof installation in Kennewick, WA?

Expect to pay $13,600 to $31,000 for metal roof installation in Kennewick in 2026, averaging around $22,300.

When is the cheapest time to buy metal roof installation — and does it differ by city?

No, the seasonal pattern is the same in Kennewick and Spokane: book during Late spring to early fall (dry, 45–85°F) for about 5–10% in savings. Mid-winter and the post-storm rush is the priciest stretch in both cities, mostly due to emergency replacements.

Should I choose where to live based on metal roof installation cost?

Rarely. The $100 difference is real but one-time, and you can often close most of it in Kennewick by buying in the off-season and getting tighter, apples-to-apples bids. Ongoing factors — energy prices, climate and home condition — matter more over the life of the system.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik