Metal Roof Installation cost: Eden Prairie vs St. Paul (2026)
Metal roof installation costs about the same in Eden Prairie and St. Paul in 2026 — roughly $25,050 in each.
Eden Prairie MN
Typically around $25,050
St. Paul MN
Typically around $25,050
Eden Prairie vs St. Paul: full breakdown
| Factor | Eden Prairie | St. Paul |
|---|---|---|
| Typical 2026 cost | $25,050 | $25,050 |
| Estimated range | $15,250–$34,850 | $15,250–$34,850 |
| Labor index (vs US) | ×1.11 | ×1.11 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.04 | ×1.04 |
| Local permit | $300 | $300 |
| Labor share | $15,050 | $15,050 |
| Materials/equipment | $10,000 | $10,000 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
No real cost edge either way
This is a statistical tie on metal roof installation cost, so let contractor reputation and project timing decide, not geography.
Metal roof installation by type: Eden Prairie vs St. Paul
Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Eden Prairie | St. Paul |
|---|---|---|
| Corrugated steel (exposed fastener) | $10,650–$21,000 | $10,650–$21,000 |
| Standing-seam steel | $21,000–$40,600 | $21,000–$40,600 |
| Aluminum | $16,400–$32,550 | $16,400–$32,550 |
| Copper | $34,850–$69,350 | $34,850–$69,350 |
| Zinc | $32,550–$63,600 | $32,550–$63,600 |
All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.
Metal roof installation by roof size: Eden Prairie vs St. Paul
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Eden Prairie | St. Paul |
|---|---|---|
| 1,000 sq ft (10 squares) | $9,500–$18,700 | $9,500–$18,700 |
| 1,500 sq ft (15 squares) | $12,950–$26,750 | $12,950–$26,750 |
| 2,000 sq ft (20 squares) | $15,250–$34,850 | $15,250–$34,850 |
| 2,500 sq ft (25 squares) | $18,700–$41,750 | $18,700–$41,750 |
| 3,000+ sq ft (30 squares) | $22,150–$48,650 | $22,150–$48,650 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What roofing pros earn in each metro
Labor is about 60% of a metal roof installation bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.
Where does a smart roofing budget go in 2026?
Two roofs of the same square footage can price hundreds apart because of something you can't see from the ground — the deck under the old shingles. Add the tear-off-versus-overlay call and the shingle grade, and you have the decisions that actually move the number.
The risk case
Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.
Eden Prairie vs St. Paul
Is metal roof installation cheaper in Eden Prairie or St. Paul?
Practically identical — expect around $25,050 for metal roof installation whichever city you're in.
Why does metal roof installation cost more in St. Paul than Eden Prairie?
The main driver is local labor rates: St. Paul's labor index is 1.11 versus 1.11 in Eden Prairie. Climate zone (cold vs cold) also shift the total.
How much is metal roof installation in Eden Prairie, MN?
metal roof installation in Eden Prairie runs $15,250–$34,850 as of 2026 — most jobs land near $25,050.
Do roofing pros really charge more in one city?
Yes — and the wage data shows it. A skilled installer earns about $36.7/hr in the Minneapolis-St. Paul-Bloomington area versus $36.7/hr around Minneapolis-St. Paul-Bloomington (BLS metro wage data). Since labor is roughly 60% of a metal roof installation job, that wage gap is the biggest reason the installed prices differ.
When is the cheapest time to buy metal roof installation — and does it differ by city?
No, the seasonal pattern is the same in Eden Prairie and St. Paul: book during Late spring to early fall (dry, 45–85°F) for about 5–10% in savings. Mid-winter and the post-storm rush is the priciest stretch in both cities, mostly due to emergency replacements.
Should I choose where to live based on metal roof installation cost?
No — the cost is essentially identical between Eden Prairie and St. Paul. Base the decision on the things that actually vary: contractor reputation, scope, equipment tier and timing.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik