Furnace Replacement cost: Greenfield vs Kenosha (2026)
Budget-wise, furnace replacement in Greenfield ($6,350) runs 3% more than in Kenosha ($6,150), a roughly $200 spread.
Greenfield WI
Typically around $6,350
Kenosha WI
Lower costTypically around $6,150
Greenfield vs Kenosha: full breakdown
| Factor | Greenfield | Kenosha |
|---|---|---|
| Typical 2026 cost | $6,350 | $6,150 |
| Estimated range | $4,500–$8,150 | $4,400–$7,900 |
| Labor index (vs US) | ×1.05 | ×1.01 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $200 | $225 |
| Labor share | $3,800 | $3,700 |
| Materials/equipment | $2,550 | $2,450 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
Is the gap worth worrying about?
A 3% difference on furnace replacement is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.
Furnace replacement by type: Greenfield vs Kenosha
Every furnace replacement type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Greenfield | Kenosha |
|---|---|---|
| Gas furnace | $4,400–$8,050 | $4,250–$7,750 |
| High-efficiency gas furnace | $3,950–$8,050 | $3,850–$7,750 |
| Electric furnace | $2,450–$5,300 | $2,400–$5,150 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
Furnace replacement by home size: Greenfield vs Kenosha
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Greenfield | Kenosha |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,400–$6,100 | $3,300–$5,900 |
| 1,500 sq ft (≈68,000 BTU) | $3,950–$7,000 | $3,850–$6,800 |
| 2,000 sq ft (≈90,000 BTU) | $4,500–$8,150 | $4,400–$7,900 |
| 2,500 sq ft (≈110,000 BTU) | $5,200–$9,300 | $5,050–$8,950 |
| 3,000 sq ft (≈130,000 BTU) | $5,850–$10,400 | $5,700–$10,050 |
| 3,500+ sq ft (≈150,000 BTU) | $6,550–$11,550 | $6,350–$11,150 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What hvac pros earn in each metro
Since labor accounts for around 60% of what a furnace replacement job costs, it's the biggest lever behind any price gap between cities. What you're seeing below is actual BLS metro wage data for skilled installers — not a guess.
Milwaukee-Waukesha metro · about 8% above the US average installer wage.
No BLS metro wage series for Kenosha; we use Wisconsin regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
HVAC demand collapses in the mild shoulder seasons, so installers discount to keep crews busy. The most expensive time to buy is during a heat wave or cold snap, when a dead system forces a full-price emergency replacement.
How much should you really budget for HVAC in 2026?
Sizing, efficiency tier and brand pull a quote in different directions. Here's how our editors weigh the trade-offs that decide what you actually pay.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The efficiency-first case
Where you face brutal summers or hard winters, a higher SEER2/AFUE system or a heat pump runs enough hours to claw back its premium through lower bills — and utility or state rebates can still trim the sticker even though the federal 25C/25D credits closed at the end of 2025. Do the payback arithmetic before you reach for the cheapest box on the lot.
Skip the brand debate. A correctly sized system, an efficiency tier that fits your climate, and a properly commissioned install will save you more than any label ever could.
Greenfield vs Kenosha
Is furnace replacement cheaper in Greenfield or Kenosha?
In 2026, furnace replacement is cheaper in Kenosha at about $6,150, versus $6,350 in Greenfield — a difference of about $200 (3%).
Why does furnace replacement cost more in Greenfield than Kenosha?
The main driver is local labor rates: Greenfield's labor index is 1.05 versus 1.01 in Kenosha. Climate zone (cold vs cold) and permit fees also shift the total.
How much is furnace replacement in Greenfield, WI?
Greenfield homeowners can expect $4,500 to $8,150 for furnace replacement in 2026, with $6,350 the typical number.
When is the cheapest time to buy furnace replacement — and does it differ by city?
Timing doesn't change by city here — Spring and fall (Mar–May, Sep–Oct) is the cheapest window in both Greenfield and Kenosha, saving roughly 5–15%. Avoid peak summer and mid-winter in either location, when emergency replacements push prices up.
Should I choose where to live based on furnace replacement cost?
Probably not. Yes, $200 is a real gap, but it's a one-time cost you can partly offset in Greenfield with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik