Furnace Replacement cost: Concord vs Evansville (2026)
The two metros aren't quite in sync on furnace replacement: Concord sits 12% above Evansville, or roughly $6,350 versus $5,650 — about $700 apart.
Concord NH
Typically around $6,350
Evansville IN
Lower costTypically around $5,650
Concord vs Evansville: full breakdown
| Factor | Concord | Evansville |
|---|---|---|
| Typical 2026 cost | $6,350 | $5,650 |
| Estimated range | $4,550–$8,150 | $4,050–$7,250 |
| Labor index (vs US) | ×1.05 | ×0.93 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $250 | $200 |
| Labor share | $3,800 | $3,400 |
| Materials/equipment | $2,550 | $2,250 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Is the gap worth worrying about?
That's a real $700 difference (12%) on furnace replacement — worth factoring in, though off-season timing and a tighter quote in Concord can narrow it.
Furnace replacement by type: Concord vs Evansville
We localize each furnace replacement type separately for both metros, applying the same labor, climate and permit adjustments each time, so you're comparing like for like.
| Type | Concord | Evansville |
|---|---|---|
| Gas furnace | $4,450–$8,050 | $3,950–$7,150 |
| High-efficiency gas furnace | $4,000–$8,050 | $3,550–$7,150 |
| Electric furnace | $2,500–$5,350 | $2,200–$4,750 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
Furnace replacement by home size: Concord vs Evansville
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Concord | Evansville |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,400–$6,150 | $3,000–$5,450 |
| 1,500 sq ft (≈68,000 BTU) | $4,000–$7,050 | $3,550–$6,250 |
| 2,000 sq ft (≈90,000 BTU) | $4,550–$8,150 | $4,050–$7,250 |
| 2,500 sq ft (≈110,000 BTU) | $5,250–$9,300 | $4,650–$8,250 |
| 3,000 sq ft (≈130,000 BTU) | $5,900–$10,450 | $5,250–$9,300 |
| 3,500+ sq ft (≈150,000 BTU) | $6,600–$11,550 | $5,850–$10,300 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
Cheapest time for furnace replacement in either city
HVAC demand collapses in the mild shoulder seasons, so installers discount to keep crews busy. The most expensive time to buy is during a heat wave or cold snap, when a dead system forces a full-price emergency replacement.
How much should you really budget for HVAC in 2026?
Ask five contractors for an HVAC quote and you'll get five different numbers — usually because they disagree on sizing, efficiency and equipment tier. Here's how our editors think through those trade-offs.
The efficiency-first case
Where you face brutal summers or hard winters, a higher SEER2/AFUE system or a heat pump runs enough hours to claw back its premium through lower bills — and utility or state rebates can still trim the sticker even though the federal 25C/25D credits closed at the end of 2025. Do the payback arithmetic before you reach for the cheapest box on the lot.
The longevity case
The most expensive variable on the quote isn't the logo — it's whether the system is sized right and installed well. Oversize a premium unit and it short-cycles, wears fast and underperforms; commission a correctly sized mid-tier one and keep up the annual service, and it simply lasts longer. Spend on the installation, not the badge.
The budget-first case
In a temperate region the smart move is to size the job correctly with a Manual J and take the base efficiency tier. A system that spends most days coasting can't recover the cost of a high-SEER2 compressor, because the savings only show up under heavy load you don't put on it. Match the equipment to how little you actually run it, not to the brochure's top number.
Skip the brand debate. A correctly sized system, an efficiency tier that fits your climate, and a properly commissioned install will save you more than any label ever could.
Concord vs Evansville
Is furnace replacement cheaper in Concord or Evansville?
Yes — Concord costs more. Expect around $6,350 for furnace replacement there against $5,650 in Evansville, about $700 (12%) apart in 2026.
Why does furnace replacement cost more in Concord than Evansville?
Concord's higher labor index (1.05 vs 0.93 in Evansville) is the biggest factor, with the cold/cold climate split and permit fee differences playing a smaller role.
How much is furnace replacement in Concord, NH?
furnace replacement in Concord runs $4,550–$8,150 as of 2026 — most jobs land near $6,350.
When is the cheapest time to buy furnace replacement — and does it differ by city?
Timing doesn't change by city here — Spring and fall (Mar–May, Sep–Oct) is the cheapest window in both Concord and Evansville, saving roughly 5–15%. Avoid peak summer and mid-winter in either location, when emergency replacements push prices up.
Should I choose where to live based on furnace replacement cost?
Not really — the $700 gap is one-time, and smart timing and tighter quotes in Concord can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik