Furnace Replacement cost: Cheyenne vs Evansville (2026)
Cheyenne runs 4% higher than Evansville for furnace replacement — expect around $5,850 in Cheyenne against $5,650 in Evansville, a difference of about $200.
Cheyenne WY
Typically around $5,850
Evansville IN
Lower costTypically around $5,650
Cheyenne vs Evansville: full breakdown
| Factor | Cheyenne | Evansville |
|---|---|---|
| Typical 2026 cost | $5,850 | $5,650 |
| Estimated range | $4,150–$7,500 | $4,050–$7,250 |
| Labor index (vs US) | ×0.96 | ×0.93 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $200 | $200 |
| Labor share | $3,500 | $3,400 |
| Materials/equipment | $2,350 | $2,250 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
Is the price difference a dealbreaker?
At 4%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for furnace replacement — focus on the contractor, not the city.
Furnace replacement by type: Cheyenne vs Evansville
Every furnace replacement type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Cheyenne | Evansville |
|---|---|---|
| Gas furnace | $4,050–$7,400 | $3,950–$7,150 |
| High-efficiency gas furnace | $3,650–$7,400 | $3,550–$7,150 |
| Electric furnace | $2,300–$4,900 | $2,200–$4,750 |
Treat these as 2026 localized estimates for furnace replacement, not quotes from a contractor.
Furnace replacement by home size: Cheyenne vs Evansville
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Cheyenne | Evansville |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,100–$5,600 | $3,000–$5,450 |
| 1,500 sq ft (≈68,000 BTU) | $3,650–$6,450 | $3,550–$6,250 |
| 2,000 sq ft (≈90,000 BTU) | $4,150–$7,500 | $4,050–$7,250 |
| 2,500 sq ft (≈110,000 BTU) | $4,800–$8,550 | $4,650–$8,250 |
| 3,000 sq ft (≈130,000 BTU) | $5,400–$9,550 | $5,250–$9,300 |
| 3,500+ sq ft (≈150,000 BTU) | $6,050–$10,600 | $5,850–$10,300 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Cheapest time for furnace replacement in either city
HVAC demand collapses in the mild shoulder seasons, so installers discount to keep crews busy. The most expensive time to buy is during a heat wave or cold snap, when a dead system forces a full-price emergency replacement.
How much should you really budget for HVAC in 2026?
Three factors move an HVAC quote more than anything else: how well it's sized, which efficiency tier you pick, and the brand markup. Our editors break down how they weigh each one.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The efficiency-first case
In a hot-summer or cold-winter region, a higher SEER2/AFUE unit — or a heat pump — earns its premium back in lower bills, and utility and state rebates can still cut into the sticker (the federal 25C/25D credits ended Dec 2025). Run the payback math before defaulting to the cheapest box.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The brand on the unit matters far less than getting the sizing and installation right. Insist on a Manual J calculation, match efficiency to your climate, and claim every rebate available.
Cheyenne vs Evansville
Is furnace replacement cheaper in Cheyenne or Evansville?
In 2026, furnace replacement is cheaper in Evansville at about $5,650, versus $5,850 in Cheyenne — a difference of about $200 (4%).
Why does furnace replacement cost more in Cheyenne than Evansville?
Cheyenne's higher labor index (0.96 vs 0.93 in Evansville) is the biggest factor, with the cold/cold climate split playing a smaller role.
How much is furnace replacement in Cheyenne, WY?
furnace replacement in Cheyenne runs $4,150–$7,500 as of 2026 — most jobs land near $5,850.
When is the cheapest time to buy furnace replacement — and does it differ by city?
It doesn't vary by location — Spring and fall (Mar–May, Sep–Oct) is the discount window in both Cheyenne and Evansville (roughly 5–15% off), while peak summer and mid-winter tends to be the most expensive in either city.
Should I choose where to live based on furnace replacement cost?
Probably not. Yes, $200 is a real gap, but it's a one-time cost you can partly offset in Cheyenne with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik