Furnace Replacement cost: Camden vs Edison (2026)
In 2026, furnace replacement is about 4% more expensive in Camden than in Edison. Most homeowners pay around $5,900 in Camden versus $5,650 in Edison — a gap of roughly $250.
Camden NJ
Typically around $5,900
Edison NJ
Lower costTypically around $5,650
Camden vs Edison: full breakdown
| Factor | Camden | Edison |
|---|---|---|
| Typical 2026 cost | $5,900 | $5,650 |
| Estimated range | $4,200–$7,550 | $4,050–$7,250 |
| Labor index (vs US) | ×1.04 | ×1.01 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $225 | $225 |
| Labor share | $3,550 | $3,400 |
| Materials/equipment | $2,350 | $2,250 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
Is the gap worth worrying about?
At 4%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for furnace replacement — focus on the contractor, not the city.
Furnace replacement by type: Camden vs Edison
We localize each furnace replacement type separately for both metros, applying the same labor, climate and permit adjustments each time, so you're comparing like for like.
| Type | Camden | Edison |
|---|---|---|
| Gas furnace | $4,100–$7,400 | $3,950–$7,150 |
| High-efficiency gas furnace | $3,650–$7,400 | $3,550–$7,150 |
| Electric furnace | $2,300–$4,900 | $2,250–$4,750 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Furnace replacement by home size: Camden vs Edison
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Camden | Edison |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,150–$5,650 | $3,050–$5,450 |
| 1,500 sq ft (≈68,000 BTU) | $3,650–$6,500 | $3,550–$6,250 |
| 2,000 sq ft (≈90,000 BTU) | $4,200–$7,550 | $4,050–$7,250 |
| 2,500 sq ft (≈110,000 BTU) | $4,800–$8,550 | $4,650–$8,250 |
| 3,000 sq ft (≈130,000 BTU) | $5,450–$9,600 | $5,250–$9,300 |
| 3,500+ sq ft (≈150,000 BTU) | $6,050–$10,650 | $5,850–$10,300 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national furnace replacement range for local labor, climate and permits.
What hvac pros earn in each metro
About 60% of a furnace replacement bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Philadelphia-Camden-Wilmington metro · about 7% above the US average installer wage.
No BLS metro wage series for Edison; we use New Jersey regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
Installers cut prices in spring and fall because job volume drops and crews sit idle — the opposite happens during a summer heat wave or winter cold snap, when a dead system forces homeowners into a full-price emergency swap.
How much should you really budget for HVAC in 2026?
Sizing, efficiency tier and brand pull a quote in different directions. Here's how our editors weigh the trade-offs that decide what you actually pay.
The longevity case
The single biggest cost driver isn't the brand — it's correct sizing and install quality. A properly sized, well-commissioned mid-tier system with annual maintenance outlasts an oversized premium unit that short-cycles. Spend on the install, not the badge.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The efficiency-first case
In a hot-summer or cold-winter region, a higher SEER2/AFUE unit — or a heat pump — earns its premium back in lower bills, and utility and state rebates can still cut into the sticker (the federal 25C/25D credits ended Dec 2025). Run the payback math before defaulting to the cheapest box.
If there's one takeaway, it's this: sizing and install quality decide whether an HVAC system performs, not the badge on the box. Get the load calculation right, match efficiency to climate, and take the rebates on offer.
Camden vs Edison
Is furnace replacement cheaper in Camden or Edison?
Yes — Camden costs more. Expect around $5,900 for furnace replacement there against $5,650 in Edison, about $250 (4%) apart in 2026.
Why does furnace replacement cost more in Camden than Edison?
Labor rates explain most of it — 1.04 in Camden vs 1.01 in Edison. A mixed climate versus mixed accounts for the rest.
How much is furnace replacement in Camden, NJ?
Expect to pay $4,200 to $7,550 for furnace replacement in Camden in 2026, averaging around $5,900.
When is the cheapest time to buy furnace replacement — and does it differ by city?
It doesn't vary by location — Spring and fall (Mar–May, Sep–Oct) is the discount window in both Camden and Edison (roughly 5–15% off), while peak summer and mid-winter tends to be the most expensive in either city.
Should I choose where to live based on furnace replacement cost?
Not really — the $250 gap is one-time, and smart timing and tighter quotes in Camden can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik