Furnace Replacement cost: Brookline vs Worcester (2026)
Brookline runs 10% higher than Worcester for furnace replacement — expect around $6,900 in Brookline against $6,250 in Worcester, a difference of about $650.
Brookline MA
Typically around $6,900
Worcester MA
Lower costTypically around $6,250
Brookline vs Worcester: full breakdown
| Factor | Brookline | Worcester |
|---|---|---|
| Typical 2026 cost | $6,900 | $6,250 |
| Estimated range | $4,950–$8,850 | $4,450–$8,000 |
| Labor index (vs US) | ×1.14 | ×1.03 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.08 | ×1.08 |
| Local permit | $250 | $225 |
| Labor share | $4,150 | $3,750 |
| Materials/equipment | $2,750 | $2,500 |
Treat these as 2026 localized estimates for furnace replacement, not quotes from a contractor.
Is the price difference a dealbreaker?
A 10% spread (roughly $650) is significant enough to plan around, but not fixed — off-peak timing and sharper bidding in Brookline typically recover some of it.
Furnace replacement by type: Brookline vs Worcester
Below, each furnace replacement option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Brookline | Worcester |
|---|---|---|
| Gas furnace | $4,800–$8,750 | $4,350–$7,900 |
| High-efficiency gas furnace | $4,300–$8,750 | $3,900–$7,900 |
| Electric furnace | $2,700–$5,800 | $2,450–$5,250 |
Furnace replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Furnace replacement by home size: Brookline vs Worcester
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Brookline | Worcester |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,700–$6,650 | $3,350–$6,000 |
| 1,500 sq ft (≈68,000 BTU) | $4,300–$7,650 | $3,900–$6,900 |
| 2,000 sq ft (≈90,000 BTU) | $4,950–$8,850 | $4,450–$8,000 |
| 2,500 sq ft (≈110,000 BTU) | $5,650–$10,100 | $5,100–$9,100 |
| 3,000 sq ft (≈130,000 BTU) | $6,400–$11,350 | $5,800–$10,250 |
| 3,500+ sq ft (≈150,000 BTU) | $7,150–$12,550 | $6,450–$11,350 |
These are 2026 planning figures for furnace replacement, localized to each city — not formal quotes.
What hvac pros earn in each metro
About 60% of a furnace replacement bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Boston-Cambridge-Newton metro · about 23% above the US average installer wage.
No BLS metro wage series for Worcester; we use Massachusetts regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
A furnace or AC that dies mid-heat-wave gets replaced at whatever the on-call crew charges. One that gets swapped in April or October gets a competitive, unhurried quote instead.
How much should you really budget for HVAC in 2026?
Sizing, efficiency tier and brand pull a quote in different directions. Here's how our editors weigh the trade-offs that decide what you actually pay.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The longevity case
The single biggest cost driver isn't the brand — it's correct sizing and install quality. A properly sized, well-commissioned mid-tier system with annual maintenance outlasts an oversized premium unit that short-cycles. Spend on the install, not the badge.
The efficiency-first case
In a hot-summer or cold-winter region, a higher SEER2/AFUE unit — or a heat pump — earns its premium back in lower bills, and utility and state rebates can still cut into the sticker (the federal 25C/25D credits ended Dec 2025). Run the payback math before defaulting to the cheapest box.
The brand on the unit matters far less than getting the sizing and installation right. Insist on a Manual J calculation, match efficiency to your climate, and claim every rebate available.
Brookline vs Worcester
Is furnace replacement cheaper in Brookline or Worcester?
In 2026, furnace replacement is cheaper in Worcester at about $6,250, versus $6,900 in Brookline — a difference of about $650 (10%).
Why does furnace replacement cost more in Brookline than Worcester?
Brookline's higher labor index (1.14 vs 1.03 in Worcester) is the biggest factor, with the cold/cold climate split and permit fee differences playing a smaller role.
How much is furnace replacement in Brookline, MA?
furnace replacement in Brookline runs $4,950–$8,850 as of 2026 — most jobs land near $6,900.
When is the cheapest time to buy furnace replacement — and does it differ by city?
The best window is the same in both Brookline and Worcester: Spring and fall (Mar–May, Sep–Oct), when demand drops and installers discount to keep crews busy — typically 5–15% off peak pricing. The most expensive time anywhere is an emergency replacement during peak summer and mid-winter.
Should I choose where to live based on furnace replacement cost?
Rarely. The $650 difference is real but one-time, and you can often close most of it in Brookline by buying in the off-season and getting tighter, apples-to-apples bids. Ongoing factors — energy prices, climate and home condition — matter more over the life of the system.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik