Furnace Replacement cost: Annapolis vs Rockville (2026)
Annapolis runs 1% higher than Rockville for furnace replacement — expect around $5,950 in Annapolis against $5,900 in Rockville, a difference of about $50.
Annapolis MD
Typically around $5,950
Rockville MD
Lower costTypically around $5,900
Annapolis vs Rockville: full breakdown
| Factor | Annapolis | Rockville |
|---|---|---|
| Typical 2026 cost | $5,950 | $5,900 |
| Estimated range | $4,250–$7,600 | $4,200–$7,550 |
| Labor index (vs US) | ×1.05 | ×1.04 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $225 | $225 |
| Labor share | $3,550 | $3,550 |
| Materials/equipment | $2,400 | $2,350 |
All figures are 2026 localized planning estimates for furnace replacement — get an actual quote before you commit.
How much should this gap actually matter?
That 1% gap is small — for furnace replacement it's usually less than the spread between two local contractors' quotes, so the metro matters far less than who you hire and when you buy.
Furnace replacement by type: Annapolis vs Rockville
Below, each furnace replacement option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.
| Type | Annapolis | Rockville |
|---|---|---|
| Gas furnace | $4,100–$7,500 | $4,100–$7,400 |
| High-efficiency gas furnace | $3,700–$7,500 | $3,650–$7,400 |
| Electric furnace | $2,350–$4,950 | $2,300–$4,900 |
Treat these as 2026 localized estimates for furnace replacement, not quotes from a contractor.
Furnace replacement by home size: Annapolis vs Rockville
Furnace cost scales with the heating capacity (BTU) your home needs — roughly 40–45 BTU per square foot in a mixed climate. Larger homes need a bigger unit and more ductwork.
| Size | Annapolis | Rockville |
|---|---|---|
| 1,000 sq ft (≈45,000 BTU) | $3,150–$5,700 | $3,150–$5,650 |
| 1,500 sq ft (≈68,000 BTU) | $3,700–$6,550 | $3,650–$6,500 |
| 2,000 sq ft (≈90,000 BTU) | $4,250–$7,600 | $4,200–$7,550 |
| 2,500 sq ft (≈110,000 BTU) | $4,850–$8,650 | $4,800–$8,550 |
| 3,000 sq ft (≈130,000 BTU) | $5,500–$9,700 | $5,450–$9,600 |
| 3,500+ sq ft (≈150,000 BTU) | $6,100–$10,750 | $6,050–$10,650 |
Treat these as 2026 localized estimates for furnace replacement, not quotes from a contractor.
What hvac pros earn in each metro
Labor is about 60% of a furnace replacement bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Baltimore-Columbia-Towson metro · about 9% above the US average installer wage.
Philadelphia-Camden-Wilmington metro · about 7% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for furnace replacement in either city
A furnace or AC that dies mid-heat-wave gets replaced at whatever the on-call crew charges. One that gets swapped in April or October gets a competitive, unhurried quote instead.
How much should you really budget for HVAC in 2026?
Sizing, efficiency tier and brand pull a quote in different directions. Here's how our editors weigh the trade-offs that decide what you actually pay.
The efficiency-first case
High runtime changes the math. In a demanding climate the extra efficiency of a heat pump or a top-tier SEER2/AFUE unit gets paid back month after month on the utility bill, and state and utility incentives can shave the upfront figure further now that the federal 25C/25D credits have expired. Price the lifetime bills, not just the tag, before you default down.
The longevity case
Brand is a footnote; sizing and install quality write the story. A right-sized mid-tier system that's properly commissioned and serviced once a year will outlive an oversized premium unit that short-cycles itself to an early grave. Put the money into the crew and the setup rather than the nameplate.
The budget-first case
Size the system to your home with a Manual J calculation and buy the standard efficiency tier (80% AFUE / 14.3 SEER2). In a mild climate the cheaper unit pays off because you rarely run it hard — paying for premium efficiency you won't use is the most common way to overspend.
The costly errors in an HVAC job are a bad load calculation and a sloppy install — not the logo you chose. Size it with a real Manual J, let your climate set the efficiency tier, and claim whatever rebates you still qualify for.
Annapolis vs Rockville
Is furnace replacement cheaper in Annapolis or Rockville?
Rockville comes out ahead here, at roughly $5,900 for furnace replacement compared with $5,950 in Annapolis — a 1% ($50) gap as of 2026.
Why does furnace replacement cost more in Annapolis than Rockville?
Annapolis's higher labor index (1.05 vs 1.04 in Rockville) is the biggest factor, with the mixed/mixed climate split playing a smaller role.
How much is furnace replacement in Annapolis, MD?
Expect to pay $4,250 to $7,600 for furnace replacement in Annapolis in 2026, averaging around $5,950.
Do hvac pros really charge more in one city?
It's not a myth — BLS data puts installer wages at about $33.9/hr in the Baltimore-Columbia-Towson area and $33.4/hr in Philadelphia-Camden-Wilmington. Given labor is around 60% of a furnace replacement job's cost, that gap explains most of the price spread.
When is the cheapest time to buy furnace replacement — and does it differ by city?
It doesn't vary by location — Spring and fall (Mar–May, Sep–Oct) is the discount window in both Annapolis and Rockville (roughly 5–15% off), while peak summer and mid-winter tends to be the most expensive in either city.
Should I choose where to live based on furnace replacement cost?
Not really — the $50 gap is one-time, and smart timing and tighter quotes in Annapolis can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.
Compare furnace replacement in other cities
Updated June 2026 · By Serhat Özçelik