Water Heaters · Redmond, WA
How much does tankless water heater installation cost in Redmond, WA? (2026)
In Redmond, tankless water heater installation runs $3,100–$6,750, with most paying around $4,950 — about 22% above the national average. Installing an on-demand tankless water heater, which heats water only as needed.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $4,950
- Typical cost
- $4,950
- Labor vs US
- +14%
- Climate
- Mixed
- Local permit
- $175
Refine your estimate
Tune it to your home to narrow the tankless water heater installation range.
Key takeaways for Redmond
- Most Redmond homeowners land around $4,950 for tankless water heater installation, within a $3,100–$6,750 range that sits about 22% above the national average.
- This estimate departs from the national number mainly because Redmond labor sits +14% versus the US average.
- The estimate already covers the Water Heaters permit — roughly $175 in Redmond.
- 18 to 20 years is the usual service life, so budget for the next one before it fails.
- Booking during Spring and early fall typically saves about 5–10% versus peak-season pricing.
- Federal 25C/25D credits plus utility rebates sit below and can shave the final bill; the estimate here is pre-incentive.
What goes into the price in Redmond
A typical Redmond tankless water heater installation of $4,950 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Redmond 2026 range |
|---|---|
| Materials & equipmentEquipment and supplies, which price out close to the national baseline. | $1,300 – $2,950 |
| Labor & installationInstall crew, removal and startup — the part local rates move most. | $1,625 – $3,625 |
| Permit & feesWater Heaters permit cost, adjusted to this city's rate. | $175 |
| Total installed cost | $3,100 – $6,750 |
Split from the Redmond estimate using a 55% local-labor share; line items sum to the total.
Why tankless water heater installation costs what it does in Redmond
- Redmond's labor rates sit about 14% higher than the national average (based on price levels for the Seattle-Tacoma-Bellevue metro area), pushing the price up.
- A Water Heaters permit in Redmond costs around $175, included above.
Tankless Water Heater Installation cost by flow rate (GPM) in Redmond
Tankless units are sized by flow rate — gallons per minute (GPM) — rather than tank size. Add up the fixtures you'd run at once: a shower is ~2 GPM, so a larger household needs a higher-GPM unit (or two).
| flow rate (GPM) | Redmond 2026 range |
|---|---|
| 5–7 GPM (1–2 people, 1 bath) | $2,750 – $5,100 |
| 7–9 GPM (2–3 people, 2 baths) | $3,250 – $5,950 |
| 9–11 GPM (3–4 people, 2–3 baths) | $3,700 – $6,500 |
| 11+ GPM (5+ people / whole-home) | $4,300 – $7,100 |
National size ranges localized to Redmond labor and climate.
Tankless Water Heater Installation cost by type in Redmond
| Gas tankless | $3,700 – $7,850 |
| Electric tankless | $2,200 – $3,950 |
Adjusted to Redmond from national type-level ranges.
Tankless Water Heater Installation cost by efficiency in Redmond
Tankless comes as gas or electric. Gas handles whole-home demand and often needs venting and gas-line work; condensing gas is the most efficient and the type most likely to qualify for a utility rebate.
| Electric tankless (point-of-use / small home)Cheaper unit; may need a panel/circuit upgrade | $1,950 – $4,300 |
| Non-condensing gas tanklessStrong whole-home flow; standard venting | $3,100 – $6,050 |
| Condensing gas tankless (ENERGY STAR, UEF ≥0.95)Most efficient; check utility rebates | $3,950 – $7,000 |
Labor vs. materials in Redmond
Install crew, removal, permit & startup — the part Redmond rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $4,950 Redmond project; your mix varies with scope.
Skilled installers in the Seattle-Tacoma-Bellevue area earn about $41.1/hr (32% above the US average, per BLS metro wage data) — the local wage is what moves the labor half of your tankless water heater installation cost.
How we estimate it
| National range | $2,500 – $5,600 |
| Redmond labor adjustment | ×1.18 |
| mixed climate factor | ×1 |
| Local permit | +$175 |
| Redmond estimate | $3,100 – $6,750 |
Promo prices vs. the real cost
Water heater ads often quote the unit, not the job. The gaps usually show up in these line items:
- Service / diagnostic call$75–$150
- "Basic swap" specialfrom ~$1,200 (simple tank)
- "Free" estimate$0 — it's a sales visit
Additional tankless water heater installation costs to budget for
Some of these land on the final invoice and some never surface — it comes down to your home's age, access and existing setup.
| Old heater removal & disposal | $50 – $200 |
| Gas line upsize (gas units often need it) | $300 – $1,000 |
| Stainless venting / re-venting | $250 – $1,000 |
| Electrical panel / circuit upgrade (electric units) | $300 – $1,500 |
| Water softener (protects against hard-water scale) | $500 – $1,500 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- The tankless unit
- Venting and mounting
- Gas line or electrical upgrades as needed
- Removal of the old heater, labor and permit
What affects the cost
- Gas vs electric (gas often needs a larger line)
- Venting requirements and wall penetration
- Whether an electrical/gas upgrade is required
- Flow rate (GPM) for your household size
Ways to save on tankless water heater installation in Redmond
- Check utility efficiency rebates in your area
- Descale annually to protect the unit
- Endless hot water and ~20-year life offset the upfront cost
- Electric tankless suits smaller homes for less
How long does tankless water heater installation last in Redmond?
Tankless units last about 20 years — roughly double a tank — and most parts are replaceable.
Descale (flush) the unit yearly, especially in hard-water areas, to protect the heat exchanger and warranty.
Signs you need tankless water heater installation in Redmond
- Your current tank is failing and you want endless hot water
- You keep running out of hot water with a storage tank
- You want to reclaim the floor space a tank takes up
- Hot water is slow to arrive or fluctuates in temperature
- An existing tankless unit is 20+ years old or throwing error codes
- You want lower standby energy loss and a longer-lived unit
Repair or replace in Redmond?
Repair if…
- The unit is under ~15 years old
- It's a flow sensor, igniter, fan, or control board (replaceable parts)
- Descaling clears an efficiency or error-code issue
Replace if…
- The heat exchanger has failed and it's out of warranty
- It's 20+ years old with mounting issues
- Repair costs approach the price of a new unit
Cost to run
Yearly running cost — what most cost guides skip
Install price is only half the story. Over 10 years, the fuel bill often outweighs the price difference between models. National operating-cost estimates below (FTC EnergyGuide):
| Type | Per year | 10-year fuel |
|---|---|---|
Heat pump water heaterCheapest to run Cheapest to run — pulls heat from the air, ~3–4× more efficient than resistance. | $130 | $1,300 |
Gas tanklessThis page On-demand gas; no standby loss, so cheaper to run than a gas tank. | $270 | $2,700 |
Gas storage tank Low running cost where natural gas is cheap; some standby heat loss. | $330 | $3,300 |
Electric tankless On-demand electric; needs a heavy electrical service upgrade. | $500 | $5,000 |
Electric storage tank Cheapest to buy, most expensive to run at national electricity prices. | $570 | $5,700 |
Verified July 2026. Figures use FTC EnergyGuide / DOE (national average fuel prices) — your state's fuel prices move them: where electricity is cheap or gas is expensive the ranking shifts. Check current EIA residential energy prices for your state.
Rebates & tax credits
The federal 25C tax credit for high-efficiency tankless units ended December 31, 2025 and is not available for 2026 installs. A condensing gas ENERGY STAR unit (UEF ≥0.95) still runs cheapest and may earn a utility rebate — check your gas utility and the DSIRE database.
Cheapest time for tankless water heater installation in Redmond
Winter is when tanks fail most, because cold incoming water and heavy demand push an aging unit past its limit — right when everyone needs an emergency replacement at emergency prices. Swap it proactively in a slower month instead.
Why tankless water heater installation quotes vary — and how to compare them fairly
Big gaps between bids come down to scope far more often than greed. This breaks down the levers and how to force a like-for-like comparison.
Why a quote looks high (or low)
- Code work (expansion tank, venting, drain pan, straps) may be excluded from a low bid.
- Fuel type and first-hour/GPM sizing change the equipment cost.
- Removal and disposal of the old unit is sometimes a hidden add-on.
Get an apples-to-apples bid
- Ask whether code upgrades (expansion tank, venting) are included.
- Confirm old-unit removal and disposal are in the price.
- Decide tank vs. tankless first, then compare like models.
- For tankless, ask if the gas line or electrical panel needs upgrading.
Questions to ask Redmond Water Heaters pros
Before you pick, make each contractor answer the same things — gaps in their replies tell you as much as the price.
- 1Will the new unit meet current code (expansion tank, venting, seismic straps, drain pan)?
- 2Is removal and disposal of the old heater included in the price?
- 3For tankless: does my gas line or electrical panel need an upgrade?
- 4What's the first-hour rating / GPM, and is it sized for my household?
- 5What does the warranty cover, and who handles warranty service?
Tankless Water Heater Installation in Redmond
How much does tankless water heater installation cost in Redmond, WA?
Redmond's going rate for tankless water heater installation is $3,100–$6,750 in 2026, with $4,950 the number most homeowners end up paying. Redmond labor rates, the mixed climate and permit fees each shift the total, and all three already sit inside this range.
Is tankless water heater installation more expensive in Redmond than average?
Redmond is about 22% higher than the national average, mainly because local labor runs at an index of 1.18 relative to the US average. and the local Water Heaters permit costs about $175.
Do I need a permit for tankless water heater installation in Redmond?
The estimate above already covers the Water Heaters permit Redmond generally requires for this job, so the $175 or so it costs won't land as a surprise.
What affects tankless water heater installation cost the most?
Start with the fundamentals — installing an on-demand tankless water heater, which heats water only as needed. What moves the price most: equipment or material grade, your home's size and complexity, local labor rates, and the mixed climate zone.
Tank or tankless — and what should you budget?
Tank, tankless or heat-pump — the format you pick shapes the bill today and the utility bill for years after. Our editors weigh the trade-offs.
The tankless case
Going tankless means paying more at install — often for a resized gas line or a dedicated electrical circuit — in exchange for hot water that never runs dry and a unit that outlives two conventional tanks. Dropping the standby loss of a constantly reheated reservoir trims the monthly bill on top of that. It fits a full house that isn't selling anytime soon.
The heat-pump case
A hybrid heat-pump unit carries the steepest sticker price and draws the largest utility rebates on the market, then pays that back by pulling warmth from the surrounding air instead of generating heat — operating cost falls to a fraction of a standard electric tank's. The condition is location: it wants a roomy, temperate spot like a garage or basement to perform.
The simple-swap case
A matching tank replacement skips every costly upgrade that comes with changing formats. Same footprint, same connections, same vent, so labor stays low and the crew is usually gone by midday. It's the obvious answer when the budget is thin and the old setup was never the problem.
The cheapest to install and the cheapest to run are rarely the same unit. Tanks win the first, heat-pumps win the second where the install spot allows, and tankless sits between them — trading a higher upfront number for a supply that never quits.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national tankless water heater installation ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Redmond using the BLS metro wage data labor index (×1.18 here), the IECC mixed-climate factor (×1) and a typical local permit fee (≈$175). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Redmond tankless water heater installation estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Tankless water heater installation alternatives in Redmond
Homeowners in Redmond often pair this with
A tankless water heater installation rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Redmond
Browse local 2026 costs for every home project in Redmond, WA.