Water Heaters · Myrtle Beach, SC
How much does heat pump water heater installation cost in Myrtle Beach, SC? (2026)
In Myrtle Beach, heat pump water heater installation runs $2,350–$4,400, with most paying around $3,400 — about 1% above the national average. Installing a hybrid heat pump water heater — the most energy-efficient option, with the lowest operating cost.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $3,400
- Typical cost
- $3,400
- Labor vs US
- −6%
- Climate
- Hot
- Local permit
- $150
Refine your estimate
Tune it to your home to narrow the heat pump water heater installation range.
Key takeaways for Myrtle Beach
- Expect $2,350 to $4,400 for heat pump water heater installation in Myrtle Beach; most quotes cluster near $3,400, about 1% above the national average.
- The −6% gap between Myrtle Beach and national labor rates is the single biggest reason this price isn't the national average.
- Budget about $150 for the local Water Heaters permit; it's already included above.
- 13 to 15 years is the usual service life, so budget for the next one before it fails.
- Roughly 5–10% comes off when you book in Spring and early fall instead of peak season.
- Federal 25C/25D credits plus utility rebates sit below and can shave the final bill; the estimate here is pre-incentive.
What goes into the price in Myrtle Beach
A typical Myrtle Beach heat pump water heater installation of $3,400 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Myrtle Beach 2026 range |
|---|---|
| Materials & equipmentHardware and supplies for the job; national pricing applies almost everywhere you go. | $1,000 – $1,900 |
| Labor & installationLabor to remove the old system and install the new one — this is where your city's wage index shows up. | $1,200 – $2,350 |
| Permit & feesThe Water Heaters permit fee for this metro, based on local rates. | $150 |
| Total installed cost | $2,350 – $4,400 |
Split from the Myrtle Beach estimate using a 55% local-labor share; line items sum to the total.
Why heat pump water heater installation costs what it does in Myrtle Beach
- Expect labor here to run 6% below the national norm (based on price levels for the Myrtle Beach-Conway-North Myrtle Beach metro area) — that's what lowers the total.
- Budget about $150 for the local Water Heaters permit in Myrtle Beach — already folded into the estimate above.
Heat Pump Water Heater Installation cost by tank capacity in Myrtle Beach
Hybrid heat pump water heaters use a storage tank, so they're sized in gallons by household — but because they recover heat efficiently, a 50-gallon hybrid often serves a home that needed a 65–80 gallon electric tank.
| tank capacity | Myrtle Beach 2026 range |
|---|---|
| 40 gal (1–2 people) | $2,200 – $3,650 |
| 50 gal (2–4 people) | $2,350 – $4,000 |
| 65 gal (4–5 people) | $2,750 – $4,200 |
| 80 gal (5+ people) | $3,050 – $4,400 |
National size ranges localized to Myrtle Beach labor and climate.
Heat Pump Water Heater Installation cost by type in Myrtle Beach
| 40–50 gallon | $2,400 – $3,850 |
| 65–66 gallon | $2,850 – $4,200 |
| 80 gallon | $3,350 – $4,900 |
Adjusted to Myrtle Beach from national type-level ranges.
Labor vs. materials in Myrtle Beach
Install crew, removal, permit & startup — the part Myrtle Beach rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $3,400 Myrtle Beach project; your mix varies with scope.
How we estimate it
| National range | $2,300 – $4,400 |
| Myrtle Beach labor adjustment | ×0.97 |
| hot climate factor | ×1 |
| Local permit | +$150 |
| Myrtle Beach estimate | $2,350 – $4,400 |
Promo prices vs. the real cost
A low advertised price rarely includes the code work a real installation requires — here's what tends to get left out:
- Service / diagnostic call$75–$150
- "Basic swap" specialfrom ~$1,200 (simple tank)
- "Free" estimate$0 — it's a sales visit
Additional heat pump water heater installation costs to budget for
Treat them as possibilities, not certainties — the ones that reach your quote follow your property's age and setup.
| Old heater removal & disposal | $50 – $200 |
| Electrical circuit / panel upgrade240V units need a dedicated circuit; older panels may need an upgrade | $300 – $2,000 |
| Condensate drain run | $100 – $400 |
| Expansion tank (often code-required) | $100 – $350 |
| Ducting / louvered door for adequate air volume | $150 – $600 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- The hybrid heat pump water heater
- Electrical and condensate connections
- Removal of the old unit
- Labor and permit
What affects the cost
- Electrical capacity and any panel upgrade
- Condensate drainage routing
- Tank capacity and first-hour rating
- Install location (needs adequate air volume)
Ways to save on heat pump water heater installation in Myrtle Beach
- Lowest operating cost of any type — big lifetime savings
- Pair with time-of-use electricity rates
- Place in a warm space (garage, utility room) for efficiency
- Strong federal and state heat-pump incentives
How long does heat pump water heater installation last in Myrtle Beach?
Heat pump water heaters last about 13–15 years — longer than a standard tank — with the heat-pump components covered by warranty.
Flush the tank and clean the air filter and evaporator coil yearly so the heat pump keeps running efficiently.
Signs you need heat pump water heater installation in Myrtle Beach
- Your electric tank is failing and you want to cut running costs
- Your water heating bills are high (a hybrid uses ~2–3x less energy)
- You're electrifying the home and away from gas
- You have a warm space (garage/basement) with room for the unit and its airflow
- An existing unit is 13+ years old
- You want the lowest operating cost and can tap local utility or state rebates
Repair or replace in Myrtle Beach?
Repair if…
- The unit is under ~10 years old
- It's the backup heating element, fan, or a sensor
- The compressor is still under warranty
Replace if…
- The tank itself is leaking
- The compressor has failed and it's out of warranty
- It's 13+ years old and needs a major repair
Cost to run
Yearly running cost — what most cost guides skip
Install price is only half the story. Over 10 years, the fuel bill often outweighs the price difference between models. National operating-cost estimates below (FTC EnergyGuide):
| Type | Per year | 10-year fuel |
|---|---|---|
Heat pump water heaterCheapest to runThis page Cheapest to run — pulls heat from the air, ~3–4× more efficient than resistance. | $130 | $1,300 |
Gas tankless On-demand gas; no standby loss, so cheaper to run than a gas tank. | $270 | $2,700 |
Gas storage tank Low running cost where natural gas is cheap; some standby heat loss. | $330 | $3,300 |
Electric tankless On-demand electric; needs a heavy electrical service upgrade. | $500 | $5,000 |
Electric storage tank Cheapest to buy, most expensive to run at national electricity prices. | $570 | $5,700 |
Verified July 2026. Figures use FTC EnergyGuide / DOE (national average fuel prices) — your state's fuel prices move them: where electricity is cheap or gas is expensive the ranking shifts. Check current EIA residential energy prices for your state.
Rebates & tax credits
The federal 25C credit for heat-pump water heaters (up to $2,000) ended December 31, 2025 and is not available for 2026 installs. State and utility rebate programs may still cut the cost — check the DSIRE database, your state energy office, and your utility — and a heat-pump unit's very low running cost pays back over time.
Cheapest time for heat pump water heater installation in Myrtle Beach
Wait for a winter failure and you're paying rush rates on a unit already past 10 years, when the cold incoming water finally does it in. Replace it on your own schedule in spring or fall and you avoid that premium entirely.
Why heat pump water heater installation quotes vary — and how to compare them fairly
When two quotes for one project diverge by thousands, the cause is usually what each one includes, not markup — here's how to read the difference.
Why a quote looks high (or low)
- Code work (expansion tank, venting, drain pan, straps) may be excluded from a low bid.
- Fuel type and first-hour/GPM sizing change the equipment cost.
- Tank vs. tankless is a different job — tankless often needs gas-line or electrical-panel upgrades.
Get an apples-to-apples bid
- Decide tank vs. tankless first, then compare like models.
- Confirm old-unit removal and disposal are in the price.
- Match the first-hour rating / GPM to your household size.
- Ask whether code upgrades (expansion tank, venting) are included.
Questions to ask Myrtle Beach Water Heaters pros
You can't judge bids side by side unless they cover the same ground; run through these with every pro on your list.
- 1Will the new unit meet current code (expansion tank, venting, seismic straps, drain pan)?
- 2Is removal and disposal of the old heater included in the price?
- 3For tankless: does my gas line or electrical panel need an upgrade?
- 4What's the first-hour rating / GPM, and is it sized for my household?
- 5What does the warranty cover, and who handles warranty service?
Heat Pump Water Heater Installation in Myrtle Beach
How much does heat pump water heater installation cost in Myrtle Beach, SC?
Myrtle Beach's going rate for heat pump water heater installation is $2,350–$4,400 in 2026, with $3,400 the number most homeowners end up paying. That range already accounts for Myrtle Beach's labor rates, its hot climate and local permit costs.
Is heat pump water heater installation more expensive in Myrtle Beach than average?
Myrtle Beach is about 1% higher than the national average, mainly because local labor runs at an index of 0.97 relative to the US average. (a local Water Heaters permit tacks on about $150).
Do I need a permit for heat pump water heater installation in Myrtle Beach?
Most Myrtle Beach jurisdictions require a Water Heaters permit for this work. Budget roughly $150 for the permit; it is already included in the estimate above.
What affects heat pump water heater installation cost the most?
Installing a hybrid heat pump water heater — the most energy-efficient option, with the lowest operating cost. Four things drive the number more than anything else — equipment/material grade, home size and complexity, local labor, and your hot climate zone.
Tank or tankless — and what should you budget?
The format choice drives both upfront cost and lifetime value. How our editors think about it.
The simple-swap case
If your current tank suits your household and the budget is tight, a like-for-like tank replacement is the cheapest, fastest job — no gas-line or panel upgrades, done in a morning.
The heat-pump case
For the lowest running cost of the three, the heat-pump water heater wins outright, and where utilities offer incentives the rebates behind it are the richest available. You pay for that advantage up front, and the unit needs the right home — a warm, well-ventilated area with real clearance. Wedge it into a tight closet and the savings disappear.
The tankless case
The tankless premium buys longevity and endless supply: nothing sitting hot around the clock, a lifespan roughly double a tank's, and no cold showers when demand spikes. The catch lives in the setup, since most retrofits need a bigger gas line or an electrical upgrade first. Larger households planning to stay put recover that cost fastest.
There's no universally "best" water heater — only the one that fits your budget and timeline. Tight budget, go tank; want endless hot water, go tankless; optimizing for the lowest bill, go heat-pump.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national heat pump water heater installation ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Myrtle Beach using the BEA Regional Price Parity labor index (×0.97 here), the IECC hot-climate factor (×1) and a typical local permit fee (≈$150). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote. Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Myrtle Beach heat pump water heater installation estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Heat pump water heater installation alternatives in Myrtle Beach
Other projects in Myrtle Beach
Browse local 2026 costs for every home project in Myrtle Beach, SC.