Plumbing · McLean, VA
How much does whole-house repipe cost in McLean, VA? (2026)
In McLean, whole-house repipe runs $3,950–$8,950, with most paying around $6,450 — about 13% above the national average. Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $6,450
- Typical cost
- $6,450
- Labor vs US
- +11%
- Climate
- Mixed
- Local permit
- $275
Refine your estimate
Tune it to your home to narrow the whole-house repipe range.
Key takeaways for McLean
- Expect $3,950 to $8,950 for whole-house repipe in McLean; most quotes cluster near $6,450, about 13% above the national average.
- The +11% gap between McLean and national labor rates is the single biggest reason this price isn't the national average.
- A Plumbing permit in McLean runs about $275 — it's already folded into the estimate above.
- Expect 50–100 years of service, so planning a replacement beats a full-price emergency call.
- Cheapest time to buy: Off-peak winter for planned work — roughly Around 5% off peak-season pricing.
What goes into the price in McLean
A typical McLean whole-house repipe of $6,450 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | McLean 2026 range |
|---|---|
| Materials & equipmentEquipment and supplies, which price out close to the national baseline. | $1,450 – $3,450 |
| Labor & installationCrew time for removal, installation and startup; local labor rates drive most of the swing here. | $2,225 – $5,225 |
| Permit & feesTypical local Plumbing permit, scaled to this metro. | $275 |
| Total installed cost | $3,950 – $8,950 |
Split from the McLean estimate using a 60% local-labor share; line items sum to the total.
Why whole-house repipe costs what it does in McLean
- Expect labor here to run 11% above the national norm (based on price levels for the Washington-Arlington-Alexandria metro area) — that's what raises the total.
- Budget about $275 for the local Plumbing permit in McLean — already folded into the estimate above.
Whole House Repipe cost by home size in McLean
Repipe cost scales with how many bathrooms and fixtures the crew has to reach — more baths means more runs, more wall and ceiling access, and more labor. Pricing below assumes standard single-story access.
| home size | McLean 2026 range |
|---|---|
| 1 bath / ~1,000 sq ft | $3,500 – $6,250 |
| 2 bath / ~1,500 sq ft | $4,400 – $7,850 |
| 3 bath / ~2,000 sq ft | $5,450 – $10,000 |
| 4+ bath / 2,500+ sq ft | $6,750 – $13,250 |
National size ranges localized to McLean labor and climate.
Whole House Repipe cost by type in McLean
| PEX | $3,950 – $7,850 |
| CPVC | $4,600 – $8,900 |
| Copper | $6,750 – $16,500 |
Adjusted to McLean from national type-level ranges.
Whole House Repipe cost by efficiency in McLean
The pipe material drives both price and longevity. PEX is flexible, fast to run, and the cheapest to install; rigid copper costs more in material and labor but is the long-haul standard many buyers prefer.
| PEX (cross-linked polyethylene)Cheapest to install; flexible, freeze-tolerant | $3,500 – $6,750 |
| CPVCMid-cost rigid plastic; common in hot-water lines | $4,050 – $7,850 |
| Copper (rigid)Highest cost; long lifespan, resale appeal | $5,700 – $13,250 |
Labor vs. materials in McLean
Install crew, removal, permit & startup — the part McLean rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $6,450 McLean project; your mix varies with scope.
Skilled installers in the Washington-Arlington-Alexandria area earn about $35.4/hr (14% above the US average, per BLS metro wage data) — the local wage is what moves the labor half of your whole-house repipe cost.
How we estimate it
| National range | $3,400 – $8,000 |
| McLean labor adjustment | ×1.08 |
| mixed climate factor | ×1 |
| Local permit | +$275 |
| McLean estimate | $3,950 – $8,950 |
Promo prices vs. the real cost
Don't confuse a service-call fee with a project estimate; they cover different things entirely:
- "Free" estimate on big jobs$0 — it's a sales visit
- Camera inspection$100–$350 (sometimes waived)
- Service / diagnostic call$75–$200
Additional whole-house repipe costs to budget for
These aren't always in the headline price. Whether you'll pay them depends on your home's condition and setup.
| Drywall & wall/ceiling patch + repaintCrews open walls to reach pipes; finishing is often separate | $500 – $3,000 |
| Permit & inspection | $100 – $500 |
| Move out / hotel during workWhole-house repipes can take 2–5 days with water off | $0 – $1,000 |
| Replace shutoff valves & supply lines | $150 – $600 |
| Slab access / concrete cut (slab homes)Only if lines run under a concrete slab | $1,000 – $4,000 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- Fixture reconnections
- New PEX or copper supply lines
- Removal of accessible old piping
- Basic drywall patching and permit
What affects the cost
- PEX vs copper
- Home size and number of bathrooms
- Wall opening and patching needed
- Slab vs crawlspace/basement access
Ways to save on whole-house repipe in McLean
- PEX costs less than copper and installs faster
- Get multiple licensed-plumber bids
- Act before a leak causes water damage
- Repipe during a remodel to share wall access
How long does whole-house repipe last in McLean?
PEX and CPVC last ~40–50+ years; copper commonly reaches 50–70+ years. A repipe is essentially a once-in-a-lifetime job.
Repiped supply lines need almost no upkeep; budget only for the occasional shutoff-valve or fixture check.
Signs you need whole-house repipe in McLean
- Chronic low water pressure throughout the house
- Rusty, brown, or metallic-tasting water (corroding pipes)
- Frequent or repeated pinhole leaks and pipe repairs
- Old galvanized steel, polybutylene, or lead supply pipes
- Banging, knocking, or whistling pipes (water hammer / corrosion)
- Visible corrosion, flaking, or green stains on exposed pipe
- The home is 50+ years old on its original plumbing
Repair or replace in McLean?
Repair if…
- A single, accessible leak in otherwise sound modern pipe (PEX/copper)
- The rest of the system is under ~25 years old and leak-free
- The damaged section is short and easy to isolate
Replace if…
- Pipes are galvanized steel, polybutylene, or lead
- Leaks keep recurring in different spots (systemic corrosion)
- Water pressure and water quality are both declining
- You're already gutting walls for a remodel (do it once)
Cheapest time for whole-house repipe in McLean
The only real lever here is planning: emergencies pay top dollar no matter what, but a repipe or sewer-line replacement booked in an off-peak month costs a bit less and gets more careful work.
Why whole-house repipe quotes vary — and how to compare them fairly
Two bids for the “same” job can differ by thousands. Usually it's scope, not greed — here's what moves the number and how to get an apples-to-apples comparison.
Why a quote looks high (or low)
- Permits, inspection and surface/landscape restoration may be excluded.
- Pipe material (PEX vs. copper) changes both cost and longevity.
- Scope is often unknown until a camera inspection confirms it.
Get an apples-to-apples bid
- Confirm permits, inspection and restoration are included.
- Clarify who owns the city-side portion of the line.
- Require a camera inspection so the scope is confirmed before work.
- Ask whether trenchless or dig fits your situation and why.
Questions to ask McLean Plumbing pros
Comparing quotes is only fair when they cover the same scope. Ask every bidder these before you sign.
- 1Trenchless vs. traditional dig — which fits my situation and why?
- 2Is a camera inspection included so we confirm the scope before digging?
- 3Are permits, inspection, and surface/landscape restoration included?
- 4What pipe material are you using (PEX vs. copper) and why?
- 5Who is responsible for the city-owned portion of the line?
Whole House Repipe in McLean
How much does whole-house repipe cost in McLean, VA?
Expect to pay $3,950 to $8,950 for whole-house repipe in McLean in 2026 — most quotes cluster around $6,450. Local labor, the mixed climate and permit fees are all baked into that number.
Is whole-house repipe more expensive in McLean than average?
McLean comes in about 13% higher than the national average. The main reason is labor: it indexes at 1.08 relative to the national average., and factor in about $275 for the local Plumbing permit.
Do I need a permit for whole-house repipe in McLean?
Expect to pull a Plumbing permit in McLean — about $275 — which is already built into the estimate above, not an extra charge.
What affects whole-house repipe cost the most?
Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper. That's the baseline — the price moves from there. Price swings mostly come down to equipment or material grade, the size and complexity of the home, local labor, and the mixed climate zone.
How do you budget a major plumbing job?
There's no fixed price for a repipe or sewer job until you know the method and what's below the yard. Our editors on how to think about the scope.
The method case
Trenchless repair costs more per foot but saves your driveway, landscaping and the restoration bill. Traditional dig is cheaper upfront only if there's little to tear up and rebuild.
The diagnosis-first case
Never budget a sewer or repipe job from a guess. A camera inspection confirms the real scope and stops you paying for work you don't need — or being blindsided by work you do.
The material case
PEX is cheaper, faster and freeze-tolerant; copper costs more but lasts longer and some buyers prefer it. Match the material to your climate and how long you'll own the home.
Scope, not brand, is what sets a plumbing price. Confirm it with a camera inspection, compare trenchless against the full cost of a dig — landscaping included — and match pipe material to your climate.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national whole-house repipe ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to McLean using the BLS metro wage data labor index (×1.08 here), the IECC mixed-climate factor (×1) and a typical local permit fee (≈$275). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our McLean whole-house repipe estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Homeowners in McLean often pair this with
A whole-house repipe rarely happens in isolation — these projects commonly come up alongside it.
Other projects in McLean
Browse local 2026 costs for every home project in McLean, VA.