Plumbing · Edina, MN
How much does whole-house repipe cost in Edina, MN? (2026)
In Edina, whole-house repipe runs $4,150–$9,350, with most paying around $6,750 — about 18% above the national average. Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper.
Updated June 2026 · Localized estimate, not a quote
Most homeowners pay around $6,750
- Typical cost
- $6,750
- Labor vs US
- +3%
- Climate
- Cold
- Local permit
- $250
Refine your estimate
Tune it to your home to narrow the whole-house repipe range.
Key takeaways for Edina
- $4,150 on the low end, $9,350 on the high — whole-house repipe in Edina averages $6,750, about 18% above the national average.
- Edina labor runs +3% versus the US average — the main reason the local price differs from the national figure.
- Budget about $250 for the local Plumbing permit; it's already included above.
- Service life runs 50–100 years on average; replacing on your schedule beats replacing on an emergency one.
- Off-peak winter for planned work is the low-price window — about Around 5% under peak rates.
What goes into the price in Edina
A typical Edina whole-house repipe of $6,750 breaks down roughly like this — materials priced near the national level, labor set by local rates.
| Line item | Edina 2026 range |
|---|---|
| Materials & equipmentHardware and supplies for the job; national pricing applies almost everywhere you go. | $1,550 – $3,650 |
| Labor & installationInstall crew, removal and startup — the part local rates move most. | $2,350 – $5,450 |
| Permit & feesTypical local Plumbing permit, scaled to this metro. | $250 |
| Total installed cost | $4,150 – $9,350 |
Split from the Edina estimate using a 60% local-labor share; line items sum to the total.
Why whole-house repipe costs what it does in Edina
- Expect labor here to run 3% above the national norm (based on price levels for the Minneapolis-St. Paul-Bloomington metro area) — that's what raises the total.
- The cold climate in Edina adds roughly 3% to typical whole-house repipe pricing versus a neutral climate.
- Budget about $250 for the local Plumbing permit in Edina — already folded into the estimate above.
Whole House Repipe cost by home size in Edina
Repipe cost scales with how many bathrooms and fixtures the crew has to reach — more baths means more runs, more wall and ceiling access, and more labor. Pricing below assumes standard single-story access.
| home size | Edina 2026 range |
|---|---|
| 1 bath / ~1,000 sq ft | $3,650 – $6,500 |
| 2 bath / ~1,500 sq ft | $4,600 – $8,250 |
| 3 bath / ~2,000 sq ft | $5,700 – $10,500 |
| 4+ bath / 2,500+ sq ft | $7,100 – $13,950 |
National size ranges localized to Edina labor and climate.
Whole House Repipe cost by type in Edina
| PEX | $4,150 – $8,250 |
| CPVC | $4,800 – $9,400 |
| Copper | $7,100 – $17,400 |
Adjusted to Edina from national type-level ranges.
Whole House Repipe cost by efficiency in Edina
The pipe material drives both price and longevity. PEX is flexible, fast to run, and the cheapest to install; rigid copper costs more in material and labor but is the long-haul standard many buyers prefer.
| PEX (cross-linked polyethylene)Cheapest to install; flexible, freeze-tolerant | $3,650 – $7,100 |
| CPVCMid-cost rigid plastic; common in hot-water lines | $4,250 – $8,250 |
| Copper (rigid)Highest cost; long lifespan, resale appeal | $5,950 – $13,950 |
Labor vs. materials in Edina
Install crew, removal, permit & startup — the part Edina rates move most.
Equipment & materials — priced closer to the national level.
Split based on a typical $6,750 Edina project; your mix varies with scope.
Skilled installers in the Minneapolis-St. Paul-Bloomington area earn about $36.7/hr (18% above the US average, per BLS metro wage data) — the local wage is what moves the labor half of your whole-house repipe cost.
How we estimate it
| National range | $3,400 – $8,000 |
| Edina labor adjustment | ×1.11 |
| cold climate factor | ×1.03 |
| Local permit | +$250 |
| Edina estimate | $4,150 – $9,350 |
Promo prices vs. the real cost
The number that gets you a plumber in the door isn't the number for the job — those are two different budgets:
- "Free" estimate on big jobs$0 — it's a sales visit
- Camera inspection$100–$350 (sometimes waived)
- Service / diagnostic call$75–$200
Additional whole-house repipe costs to budget for
Some of these land on the final invoice and some never surface — it comes down to your home's age, access and existing setup.
| Drywall & wall/ceiling patch + repaintCrews open walls to reach pipes; finishing is often separate | $500 – $3,000 |
| Permit & inspection | $100 – $500 |
| Move out / hotel during workWhole-house repipes can take 2–5 days with water off | $0 – $1,000 |
| Replace shutoff valves & supply lines | $150 – $600 |
| Slab access / concrete cut (slab homes)Only if lines run under a concrete slab | $1,000 – $4,000 |
Typical national add-on ranges; confirm locally during your quote.
What's included
- New PEX or copper supply lines
- Removal of accessible old piping
- Fixture reconnections
- Basic drywall patching and permit
What affects the cost
- Home size and number of bathrooms
- PEX vs copper
- Slab vs crawlspace/basement access
- Wall opening and patching needed
Ways to save on whole-house repipe in Edina
- Get multiple licensed-plumber bids
- PEX costs less than copper and installs faster
- Repipe during a remodel to share wall access
- Act before a leak causes water damage
How long does whole-house repipe last in Edina?
PEX and CPVC last ~40–50+ years; copper commonly reaches 50–70+ years. A repipe is essentially a once-in-a-lifetime job.
Repiped supply lines need almost no upkeep; budget only for the occasional shutoff-valve or fixture check.
Signs you need whole-house repipe in Edina
- Chronic low water pressure throughout the house
- Rusty, brown, or metallic-tasting water (corroding pipes)
- Frequent or repeated pinhole leaks and pipe repairs
- Old galvanized steel, polybutylene, or lead supply pipes
- Banging, knocking, or whistling pipes (water hammer / corrosion)
- Visible corrosion, flaking, or green stains on exposed pipe
- The home is 50+ years old on its original plumbing
Repair or replace in Edina?
Repair if…
- A single, accessible leak in otherwise sound modern pipe (PEX/copper)
- The rest of the system is under ~25 years old and leak-free
- The damaged section is short and easy to isolate
Replace if…
- Pipes are galvanized steel, polybutylene, or lead
- Leaks keep recurring in different spots (systemic corrosion)
- Water pressure and water quality are both declining
- You're already gutting walls for a remodel (do it once)
Cheapest time for whole-house repipe in Edina
An actual emergency always pays full rate — there's no negotiating room. But a planned repipe or sewer-line job can be timed to a slower month, where crews have more attention to give and a little more room on price.
Why whole-house repipe quotes vary — and how to compare them fairly
Price differences on an identical job trace back to the assumptions each contractor made; understand those and the 'expensive' bid often turns out fair.
Why a quote looks high (or low)
- Permits, inspection and surface/landscape restoration may be excluded.
- Scope is often unknown until a camera inspection confirms it.
- Pipe material (PEX vs. copper) changes both cost and longevity.
Get an apples-to-apples bid
- Ask whether trenchless or dig fits your situation and why.
- Confirm permits, inspection and restoration are included.
- Clarify who owns the city-side portion of the line.
- Require a camera inspection so the scope is confirmed before work.
Questions to ask Edina Plumbing pros
The only honest way to compare is to hold every quote to one checklist. Start with these.
- 1Trenchless vs. traditional dig — which fits my situation and why?
- 2Is a camera inspection included so we confirm the scope before digging?
- 3Are permits, inspection, and surface/landscape restoration included?
- 4What pipe material are you using (PEX vs. copper) and why?
- 5Who is responsible for the city-owned portion of the line?
Whole House Repipe in Edina
How much does whole-house repipe cost in Edina, MN?
Edina's going rate for whole-house repipe is $4,150–$9,350 in 2026, with $6,750 the number most homeowners end up paying. That's not a national average — it's adjusted for Edina labor rates, cold-climate factors and permit fees.
Is whole-house repipe more expensive in Edina than average?
Because local labor indexes at 1.11 relative to the US average, Edina settles in about 18% higher than the national average. (a local Plumbing permit tacks on about $250).
Do I need a permit for whole-house repipe in Edina?
Expect to pull a Plumbing permit in Edina — about $250 — which is already built into the estimate above, not an extra charge.
What affects whole-house repipe cost the most?
Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper. Four things drive the number more than anything else — equipment/material grade, home size and complexity, local labor, and your cold climate zone.
How do you budget a major plumbing job?
Plumbing budgets for repipes and sewer lines hinge on two unknowns — the install method and the ground itself. Our editors break down the trade-offs.
The method case
Trenchless repair costs more per foot but saves your driveway, landscaping and the restoration bill. Traditional dig is cheaper upfront only if there's little to tear up and rebuild.
The material case
PEX installs faster, costs less, and flexes instead of splitting when a line freezes — a real edge in cold zones. Copper carries a higher price and a longer service life, and some buyers still read it as the quality choice; let your climate and how long you'll own the home make the call.
The diagnosis-first case
Pricing a sewer or repipe off a hunch invites two bad outcomes: paying to replace pipe that's fine, or missing the section that's actually collapsed. A camera run through the line settles the question before a single dollar is committed.
Get the camera inspection first, weigh trenchless against the full restoration cost — not just the dig — and pick pipe material for your climate. The scope, not the brand, sets the price.
Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.
How we calculated this estimate
We start with 2026 national whole-house repipe ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Edina using the BLS metro wage data labor index (×1.11 here), the IECC cold-climate factor (×1.03) and a typical local permit fee (≈$250). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.
This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.
References & data sources
Our Edina whole-house repipe estimate is built from these primary, mostly government sources — not a single aggregator.
- Occupational Employment & Wage Statistics (metro wages) — U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
- Regional Price Parities (state & metro) — U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
- IECC Climate Zones — U.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
- Home Energy Tax Credits (25C / 25D) — Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
- Database of State Incentives for Renewables & Efficiency — DSIRE — NC State University.State and utility incentive programs by ZIP code.
Homeowners in Edina often pair this with
A whole-house repipe rarely happens in isolation — these projects commonly come up alongside it.
Other projects in Edina
Browse local 2026 costs for every home project in Edina, MN.