Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits

Plumbing · Beaverton, OR

How much does whole-house repipe cost in Beaverton, OR? (2026)

In Beaverton, whole-house repipe runs $3,900$8,850, with most paying around $6,400about 12% above the national average. Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper.

Updated June 2026 · Localized estimate, not a quote

Beaverton · 2026 estimate
$3,900 $8,850

Most homeowners pay around $6,400

$3,900typical $6,400$8,850
Typical cost
$6,400
Labor vs US
+9%
Climate
Mixed
Local permit
$275

Refine your estimate

Tune it to your home to narrow the whole-house repipe range.

Quality tier
Conditions & add-ons
Your adjusted estimate
$3,900 $8,850
Most likely $6,400

Key takeaways for Beaverton

  • Priced about 12% above the national average, whole-house repipe in Beaverton spans $3,900 to $8,850 — figure $6,400 for a standard job.
  • Local labor in Beaverton is +9% relative to the national average, which is what pushes this estimate away from the countrywide number.
  • Permit costs are baked in: Beaverton charges about $275 for the Plumbing permit.
  • Service life runs 50–100 years on average; replacing on your schedule beats replacing on an emergency one.
  • Booking during Off-peak winter for planned work typically saves about Around 5% versus peak-season pricing.
Price breakdown

What goes into the price in Beaverton

A typical Beaverton whole-house repipe of $6,400 breaks down roughly like this — materials priced near the national level, labor set by local rates.

Line itemBeaverton 2026 range
Materials & equipmentHardware and supplies for the job; national pricing applies almost everywhere you go.$1,450 $3,450
Labor & installationThe installation work itself — removal, setup and startup — is what your city's labor rate actually moves.$2,175 $5,125
Permit & feesPlumbing permit cost, adjusted to this city's rate.$275
Total installed cost$3,900 $8,850

Split from the Beaverton estimate using a 60% local-labor share; line items sum to the total.

Local factors

Why whole-house repipe costs what it does in Beaverton

  • Beaverton's labor rates sit about 9% higher than the national average (based on price levels for the Portland-Vancouver-Hillsboro metro area), pushing the price up.
  • A Plumbing permit in Beaverton costs around $275, included above.
Site access, not freeze depth, tends to decide the dig, climate plays a smaller role here — access and method (trenchless vs. dig) matter more for whole-house repipe cost. In Oregon, the method you choose (trenchless vs. dig) will move the price more than the moderate frost depth does.
By size

Whole House Repipe cost by home size in Beaverton

Repipe cost scales with how many bathrooms and fixtures the crew has to reach — more baths means more runs, more wall and ceiling access, and more labor. Pricing below assumes standard single-story access.

home sizeBeaverton 2026 range
1 bath / ~1,000 sq ft$3,500 $6,200
2 bath / ~1,500 sq ft$4,350 $7,800
3 bath / ~2,000 sq ft$5,450 $9,950
4+ bath / 2,500+ sq ft$6,700 $13,150

National size ranges localized to Beaverton labor and climate.

By type

Whole House Repipe cost by type in Beaverton

PEX$3,900 $7,750
CPVC$4,550 $8,850
Copper$6,700 $16,350

Adjusted to Beaverton from national type-level ranges.

By efficiency

Whole House Repipe cost by efficiency in Beaverton

The pipe material drives both price and longevity. PEX is flexible, fast to run, and the cheapest to install; rigid copper costs more in material and labor but is the long-haul standard many buyers prefer.

PEX (cross-linked polyethylene)Cheapest to install; flexible, freeze-tolerant$3,500 $6,700
CPVCMid-cost rigid plastic; common in hot-water lines$4,050 $7,800
Copper (rigid)Highest cost; long lifespan, resale appeal$5,650 $13,150
Where the money goes

Labor vs. materials in Beaverton

Labor (60%)
$3,850

Install crew, removal, permit & startup — the part Beaverton rates move most.

Materials (40%)
$2,550

Equipment & materials — priced closer to the national level.

Split based on a typical $6,400 Beaverton project; your mix varies with scope.

Skilled installers in the Portland-Vancouver-Hillsboro area earn about $34.9/hr (12% above the US average, per BLS metro wage data) — the local wage is what moves the labor half of your whole-house repipe cost.

Methodology

How we estimate it

National range$3,400 $8,000
Beaverton labor adjustment×1.07
mixed climate factor×1
Local permit+$275
Beaverton estimate$3,900 $8,850
Typical 2026
$6,400
Range
$3,900$8,850
Climate
mixed
Local permit
$275

Promo prices vs. the real cost

Don't confuse a service-call fee with a project estimate; they cover different things entirely:

  • Camera inspection$100–$350 (sometimes waived)
  • Service / diagnostic call$75–$200
  • "Free" estimate on big jobs$0 — it's a sales visit
Hidden costs

Additional whole-house repipe costs to budget for

None of these are a given. What you actually pay hinges on the condition of the current system and how hard the site is to work in.

Drywall & wall/ceiling patch + repaintCrews open walls to reach pipes; finishing is often separate$500 $3,000
Permit & inspection$100 $500
Move out / hotel during workWhole-house repipes can take 2–5 days with water off$0 $1,000
Replace shutoff valves & supply lines$150 $600
Slab access / concrete cut (slab homes)Only if lines run under a concrete slab$1,000 $4,000

Typical national add-on ranges; confirm locally during your quote.

What's included

  • New PEX or copper supply lines
  • Removal of accessible old piping
  • Basic drywall patching and permit
  • Fixture reconnections

What affects the cost

  • Slab vs crawlspace/basement access
  • Wall opening and patching needed
  • PEX vs copper
  • Home size and number of bathrooms

Ways to save on whole-house repipe in Beaverton

  • Act before a leak causes water damage
  • PEX costs less than copper and installs faster
  • Get multiple licensed-plumber bids
  • Repipe during a remodel to share wall access
Lifespan

How long does whole-house repipe last in Beaverton?

Expected lifespan
50100 years

PEX and CPVC last ~40–50+ years; copper commonly reaches 50–70+ years. A repipe is essentially a once-in-a-lifetime job.

Annual maintenance
$0$150/yr

Repiped supply lines need almost no upkeep; budget only for the occasional shutoff-valve or fixture check.

When to replace

Signs you need whole-house repipe in Beaverton

  • Chronic low water pressure throughout the house
  • Rusty, brown, or metallic-tasting water (corroding pipes)
  • Frequent or repeated pinhole leaks and pipe repairs
  • Old galvanized steel, polybutylene, or lead supply pipes
  • Banging, knocking, or whistling pipes (water hammer / corrosion)
  • Visible corrosion, flaking, or green stains on exposed pipe
  • The home is 50+ years old on its original plumbing
Decision

Repair or replace in Beaverton?

If you're patching the same lines more than once or twice a year — or the pipes are galvanized/polybutylene — a full repipe usually beats spending repeatedly on spot fixes.

Repair if…

  • A single, accessible leak in otherwise sound modern pipe (PEX/copper)
  • The rest of the system is under ~25 years old and leak-free
  • The damaged section is short and easy to isolate

Replace if…

  • Pipes are galvanized steel, polybutylene, or lead
  • Leaks keep recurring in different spots (systemic corrosion)
  • Water pressure and water quality are both declining
  • You're already gutting walls for a remodel (do it once)
Best time to buy

Cheapest time for whole-house repipe in Beaverton

Emergency plumbing work is priced for urgency, full stop. A repipe or sewer line, on the other hand, is a project you can schedule — and scheduling it for a slow month gets you a slightly better rate and a crew that isn't rushing.

Best window
Off-peak winter for planned work
Avoid
Anytime it becomes an emergency
Off-peak savings
Around 5%
Get quotes for major plumbing work during a slow stretch, before a delay turns a planned job into an emergency with no negotiating room.
Reading your quotes

Why whole-house repipe quotes vary — and how to compare them fairly

Price differences on an identical job trace back to the assumptions each contractor made; understand those and the 'expensive' bid often turns out fair.

Why a quote looks high (or low)

  • Scope is often unknown until a camera inspection confirms it.
  • Trenchless vs. traditional dig is a major price difference.
  • Pipe material (PEX vs. copper) changes both cost and longevity.

Get an apples-to-apples bid

  • Confirm permits, inspection and restoration are included.
  • Clarify who owns the city-side portion of the line.
  • Require a camera inspection so the scope is confirmed before work.
  • Ask whether trenchless or dig fits your situation and why.
Hiring

Questions to ask Beaverton Plumbing pros

Quotes only compare cleanly when every bidder is pricing the same work — put these to each of them before you commit.

  1. 1Trenchless vs. traditional dig — which fits my situation and why?
  2. 2Is a camera inspection included so we confirm the scope before digging?
  3. 3Are permits, inspection, and surface/landscape restoration included?
  4. 4What pipe material are you using (PEX vs. copper) and why?
  5. 5Who is responsible for the city-owned portion of the line?
FAQ

Whole House Repipe in Beaverton

How much does whole-house repipe cost in Beaverton, OR?

The low end sits near $3,900 and the high end near $8,850 for whole-house repipe in Beaverton this 2026, with $6,400 the common middle. The figure is adjusted for local labor rates, mixed-climate factors and permit fees.

Is whole-house repipe more expensive in Beaverton than average?

Why the gap? Beaverton prices about 12% higher than the national average, and local labor — indexed at 1.07 against the US average — does most of the work. (a local Plumbing permit tacks on about $275).

Do I need a permit for whole-house repipe in Beaverton?

Yes — Beaverton typically requires a Plumbing permit for this job, running about $275. That cost is already folded into the estimate above.

What affects whole-house repipe cost the most?

Replacing a home's water supply piping — typically swapping old galvanized or failing pipe for PEX or copper. What should you watch? Equipment or material grade, the home's size and complexity, local labor rates, and your mixed climate zone — in roughly that order.

Editors' roundtable

How do you budget a major plumbing job?

There's no fixed price for a repipe or sewer job until you know the method and what's below the yard. Our editors on how to think about the scope.

The material case

In freeze-prone regions PEX has the advantage: cheaper, quicker to run, and forgiving when temperatures drop. Copper asks for more up front but outlasts it and can nudge resale with certain buyers. The tiebreaker is your weather and your timeline in the house, not a blanket rule.

The method case

Compare the two methods on the finished bill, not the excavation quote. Trenchless costs more to install yet skips restoring everything a trench destroys, while a conventional dig looks cheap right up until you price setting the yard right again.

The diagnosis-first case

The estimate is only as honest as the inspection behind it. Push a camera down the line first and the scope becomes a documented fact — no padding for problems that aren't there, no ambush once the trench is open.

Our take

Confirm the scope with a camera before anyone quotes a number, then judge trenchless against a dig by its total cost with the yard restored — and spec PEX or copper to match your winters. Do that and the price tracks the actual job, not a label.

Editorial analysis by Serhat Özçelik, reviewed by Costadia Editorial. These are our own cost perspectives, not third-party endorsements.

How we calculated this estimate

We start with 2026 national whole-house repipe ranges compiled from contractor-pricing sources (Angi, HomeGuide, Fixr and EnergySage averages), then localize them to Beaverton using the BLS metro wage data labor index (×1.07 here), the IECC mixed-climate factor (×1) and a typical local permit fee (≈$275). Federal incentive details reference the IRS Inflation Reduction Act (25C/25D) and DSIRE.

This is a planning estimate, not a quote.Actual prices vary with your home's condition, equipment grade and contractor — always confirm with licensed local pros before budgeting.

By Serhat ÖzçelikReviewed by Costadia EditorialUpdated June 2026Sources: BLS · BEA · IECC · IRS · DSIRE · industry cost data

References & data sources

Our Beaverton whole-house repipe estimate is built from these primary, mostly government sources — not a single aggregator.

  1. Occupational Employment & Wage Statistics (metro wages)U.S. Bureau of Labor Statistics.Metro-level trade wages behind each city's labor index.
  2. Regional Price Parities (state & metro)U.S. Bureau of Economic Analysis.Regional price levels used where metro wage data is unavailable.
  3. IECC Climate ZonesU.S. DOE — Building Energy Codes Program.Climate-zone factors applied to weather-sensitive projects.
  4. Home Energy Tax Credits (25C / 25D)Internal Revenue Service.Federal rebate and tax-credit figures for eligible upgrades.
  5. Database of State Incentives for Renewables & EfficiencyDSIRE — NC State University.State and utility incentive programs by ZIP code.
Plan ahead

Homeowners in Beaverton often pair this with

A whole-house repipe rarely happens in isolation — these projects commonly come up alongside it.

Explore

Other projects in Beaverton

Browse local 2026 costs for every home project in Beaverton, OR.