Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Tile Roof Installation cost: Conway vs Jonesboro (2026)

The two metros aren't quite in sync on tile roof installation: Conway sits 2% above Jonesboro, or roughly $16,850 versus $16,500 — about $350 apart.

Conway AR

$10,050 $23,600

Typically around $16,850

Jonesboro AR

Lower cost
$9,850 $23,150

Typically around $16,500

Expect to pay roughly $350 (2%) more for tile roof installation in Conway than in Jonesboro — local labor is the main reason.
Side by side

Conway vs Jonesboro: full breakdown

FactorConwayJonesboro
Typical 2026 cost$16,850$16,500
Estimated range$10,050–$23,600$9,850–$23,150
Labor index (vs US)×0.93×0.92
Climate zoneMixedMixed
Climate factor×1×1
Local permit$250$250
Labor share$10,100$9,900
Materials/equipment$6,750$6,600

Treat these as 2026 localized estimates for tile roof installation, not quotes from a contractor.

The verdict

Is the price difference a dealbreaker?

2% is within noise for tile roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Tile roof installation by type: Conway vs Jonesboro

Below, each tile roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeConwayJonesboro
Concrete tile$10,050$19,850$9,850$19,500
Clay / terracotta tile$13,350$26,400$13,050$25,900
Slate$18,950$46,950$18,550$46,050

Tile roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

By size

Tile roof installation by roof size: Conway vs Jonesboro

Tile is priced per square (100 sq ft) and runs about $7–$15 per sq ft installed. Its weight matters: many homes need the roof structure reinforced before concrete or clay tile can go on.

SizeConwayJonesboro
1,000 sq ft (10 squares)$6,800$13,350$6,650$13,050
1,500 sq ft (15 squares)$8,650$18,000$8,500$17,650
2,000 sq ft (20 squares)$10,050$23,600$9,850$23,150
2,500 sq ft (25 squares)$12,400$28,250$12,150$27,750
3,000+ sq ft (30 squares)$15,200$33,850$14,900$33,250

Tile roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Best time to buy

Cheapest time for tile roof installation in either city

Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Tear-off vs. overlay, shingle tier and what's hidden under the deck decide the real number. Our editors on the trade-offs.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

The do-it-right case

A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.

Our take

Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.

FAQ

Conway vs Jonesboro

Is tile roof installation cheaper in Conway or Jonesboro?

Jonesboro comes out ahead here, at roughly $16,500 for tile roof installation compared with $16,850 in Conway — a 2% ($350) gap as of 2026.

Why does tile roof installation cost more in Conway than Jonesboro?

It comes down to labor: Conway indexes at 0.93 against Jonesboro's 0.92. The mixed-vs-mixed climate difference adds to the gap.

How much is tile roof installation in Conway, AR?

In Conway, tile roof installation typically runs $10,050–$23,600 in 2026, with most homeowners paying around $16,850.

When is the cheapest time to buy tile roof installation — and does it differ by city?

The best window is the same in both Conway and Jonesboro: Late spring to early fall (dry, 45–85°F), when demand drops and installers discount to keep crews busy — typically 5–10% off peak pricing. The most expensive time anywhere is an emergency replacement during mid-winter and the post-storm rush.

Should I choose where to live based on tile roof installation cost?

Rarely. The $350 difference is real but one-time, and you can often close most of it in Conway by buying in the off-season and getting tighter, apples-to-apples bids. Ongoing factors — energy prices, climate and home condition — matter more over the life of the system.

Keep comparing

Compare tile roof installation in other cities

Updated June 2026 · By Serhat Özçelik