Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Tile Roof Installation cost: Albany vs Augusta-Richmond County (2026)

Budget-wise, tile roof installation in Albany ($17,350) runs 4% less than in Augusta-Richmond County ($18,000), a roughly $650 spread.

Albany GA

Lower cost
$10,350 $24,300

Typically around $17,350

Augusta-Richmond County GA

$10,750 $25,250

Typically around $18,000

tile roof installation runs about $650 (4%) more in Augusta-Richmond County than in Albany, driven mostly by local labor rates.
Side by side

Albany vs Augusta-Richmond County: full breakdown

FactorAlbanyAugusta-Richmond County
Typical 2026 cost$17,350$18,000
Estimated range$10,350–$24,300$10,750–$25,250
Labor index (vs US)×0.92×0.95
Climate zoneHotHot
Climate factor×1.05×1.05
Local permit$250$250
Labor share$10,400$10,800
Materials/equipment$6,950$7,200

Tile roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

Is the gap worth worrying about?

4% is within noise for tile roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Tile roof installation by type: Albany vs Augusta-Richmond County

Each tile roof installation option, priced separately for both metros — the same local labor, climate and permit adjustments applied per city, so you can compare like for like.

TypeAlbanyAugusta-Richmond County
Concrete tile$10,350$20,450$10,750$21,250
Clay / terracotta tile$13,700$27,200$14,250$28,250
Slate$19,500$48,350$20,250$50,250

Treat these as 2026 localized estimates for tile roof installation, not quotes from a contractor.

By size

Tile roof installation by roof size: Albany vs Augusta-Richmond County

Tile is priced per square (100 sq ft) and runs about $7–$15 per sq ft installed. Its weight matters: many homes need the roof structure reinforced before concrete or clay tile can go on.

SizeAlbanyAugusta-Richmond County
1,000 sq ft (10 squares)$7,000$13,700$7,250$14,250
1,500 sq ft (15 squares)$8,900$18,500$9,250$19,250
2,000 sq ft (20 squares)$10,350$24,300$10,750$25,250
2,500 sq ft (25 squares)$12,750$29,100$13,250$30,250
3,000+ sq ft (30 squares)$15,650$34,850$16,250$36,250

These are 2026 planning figures for tile roof installation, localized to each city — not formal quotes.

Best time to buy

Cheapest time for tile roof installation in either city

Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

Our take

Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.

FAQ

Albany vs Augusta-Richmond County

Is tile roof installation cheaper in Albany or Augusta-Richmond County?

Albany comes out ahead here, at roughly $17,350 for tile roof installation compared with $18,000 in Augusta-Richmond County — a 4% ($650) gap as of 2026.

Why does tile roof installation cost more in Augusta-Richmond County than Albany?

The main driver is local labor rates: Augusta-Richmond County's labor index is 0.95 versus 0.92 in Albany. Climate zone (hot vs hot) also shift the total.

How much is tile roof installation in Albany, GA?

In Albany, tile roof installation typically runs $10,350–$24,300 in 2026, with most homeowners paying around $17,350.

When is the cheapest time to buy tile roof installation — and does it differ by city?

No, the seasonal pattern is the same in Albany and Augusta-Richmond County: book during Late spring to early fall (dry, 45–85°F) for about 5–10% in savings. Mid-winter and the post-storm rush is the priciest stretch in both cities, mostly due to emergency replacements.

Should I choose where to live based on tile roof installation cost?

Probably not. Yes, $650 is a real gap, but it's a one-time cost you can partly offset in Augusta-Richmond County with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.

Keep comparing

Compare tile roof installation in other cities

Updated June 2026 · By Serhat Özçelik