Spray Foam Insulation cost: Jacksonville vs Pembroke Pines (2026)
There's essentially no price gap here: spray foam insulation runs close to $3,650 in both Jacksonville and Pembroke Pines in 2026.
Jacksonville FL
Typically around $3,650
Pembroke Pines FL
Typically around $3,650
Jacksonville vs Pembroke Pines: full breakdown
| Factor | Jacksonville | Pembroke Pines |
|---|---|---|
| Typical 2026 cost | $3,650 | $3,650 |
| Estimated range | $1,450–$5,800 | $1,450–$5,850 |
| Labor index (vs US) | ×0.95 | ×0.96 |
| Climate zone | Hot | Hot |
| Climate factor | ×1.02 | ×1.02 |
| Local permit | None | None |
| Labor share | $2,000 | $2,000 |
| Materials/equipment | $1,650 | $1,650 |
These are 2026 planning figures for spray foam insulation, localized to each city — not formal quotes.
No real cost edge either way
The two metros are effectively a wash for spray foam insulation — pick on contractor quality and timing, not location.
Spray foam insulation by type: Jacksonville vs Pembroke Pines
Every spray foam insulation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Jacksonville | Pembroke Pines |
|---|---|---|
| Open-cell | $1,450–$4,350 | $1,450–$4,400 |
| Closed-cell | $2,400–$6,800 | $2,450–$6,850 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national spray foam insulation range for local labor, climate and permits.
Spray foam insulation by area: Jacksonville vs Pembroke Pines
Spray foam is priced by board foot (1 sq ft at 1 inch thick), which works out to about $1.50–$5 per sq ft of surface installed depending on foam type and thickness. Closed-cell costs more but adds twice the R-value per inch.
| Size | Jacksonville | Pembroke Pines |
|---|---|---|
| 500 sq ft | $850–$2,300 | $900–$2,350 |
| 1,000 sq ft | $1,450–$3,850 | $1,450–$3,900 |
| 1,500 sq ft | $2,150–$5,350 | $2,150–$5,400 |
| 2,000+ sq ft | $2,700–$6,300 | $2,750–$6,350 |
These are 2026 planning figures for spray foam insulation, localized to each city — not formal quotes.
What insulation pros earn in each metro
About 55% of a spray foam insulation bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Jacksonville metro · about 9% below the US average installer wage.
Miami-Fort Lauderdale-West Palm Beach metro · about 7% below the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for spray foam insulation in either city
Fall is when everyone rushes to insulate before winter hits, making it the busiest and priciest season. Spring and summer see far less demand — and utility rebate budgets are often still full that early in the year.
How much insulation is worth paying for?
Where an insulation budget lands depends less on square footage than on three calls — the R-value you target, whether air-sealing rides along, and which material fills the cavity.
The R-value case
Insulate to the DOE recommendation for your climate zone — under-insulating to save money leaves comfort and energy savings on the table that would have paid the job back.
The air-sealing case
Insulation without air-sealing underperforms. Sealing leaks first is cheap and often delivers more comfort per dollar than thicker insulation alone — make sure it's in the scope.
The rebate case
Insulation carries some of the strongest incentive money in remodeling, with utility and state rebates covering a real portion of the cost since the federal 25C credit expired at the end of 2025. Look up what applies on DSIRE, then schedule the work while rebate funds are still unclaimed for the year.
Payback is the whole point with insulation, and it arrives fastest when the job is done in full: air-sealing, the DOE-recommended R-value for your climate zone, and whatever utility rebates you qualify for. Trimming any one of those trims the return, not the cost.
Jacksonville vs Pembroke Pines
Is spray foam insulation cheaper in Jacksonville or Pembroke Pines?
There's no meaningful difference: spray foam insulation runs about $3,650 in both places.
Why does spray foam insulation cost more in Pembroke Pines than Jacksonville?
Pembroke Pines's higher labor index (0.96 vs 0.95 in Jacksonville) is the biggest factor, with the hot/hot climate split playing a smaller role.
How much is spray foam insulation in Jacksonville, FL?
spray foam insulation in Jacksonville runs $1,450–$5,800 as of 2026 — most jobs land near $3,650.
Do insulation pros really charge more in one city?
It's not a myth — BLS data puts installer wages at about $28.3/hr in the Jacksonville area and $28.8/hr in Miami-Fort Lauderdale-West Palm Beach. Given labor is around 55% of a spray foam insulation job's cost, that gap explains most of the price spread.
When is the cheapest time to buy spray foam insulation — and does it differ by city?
It doesn't vary by location — Spring and summer is the discount window in both Jacksonville and Pembroke Pines (roughly 5–10% off), while the pre-winter fall rush tends to be the most expensive in either city.
Should I choose where to live based on spray foam insulation cost?
No — the cost is essentially identical between Jacksonville and Pembroke Pines. Base the decision on the things that actually vary: contractor reputation, scope, equipment tier and timing.
Compare spray foam insulation in other cities
Updated June 2026 · By Serhat Özçelik