Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Monroe vs Shreveport (2026)

The two metros aren't quite in sync on metal roof installation: Monroe sits 1% below Shreveport, or roughly $20,700 versus $20,950 — about $250 apart.

Monroe LA

Lower cost
$12,600 $28,750

Typically around $20,700

Shreveport LA

$12,750 $29,100

Typically around $20,950

Expect to pay roughly $250 (1%) more for metal roof installation in Shreveport than in Monroe — local labor is the main reason.
Side by side

Monroe vs Shreveport: full breakdown

FactorMonroeShreveport
Typical 2026 cost$20,700$20,950
Estimated range$12,600–$28,750$12,750–$29,100
Labor index (vs US)×0.92×0.93
Climate zoneHotHot
Climate factor×1.03×1.03
Local permit$250$250
Labor share$12,400$12,550
Materials/equipment$8,300$8,400

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

Is the price difference a dealbreaker?

1% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Metal roof installation by type: Monroe vs Shreveport

Every metal roof installation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.

TypeMonroeShreveport
Corrugated steel (exposed fastener)$8,800$17,350$8,900$17,550
Standing-seam steel$17,350$33,500$17,550$33,900
Aluminum$13,550$26,850$13,700$27,200
Copper$28,750$57,250$29,100$57,950
Zinc$26,850$52,500$27,200$53,150

All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.

By size

Metal roof installation by roof size: Monroe vs Shreveport

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizeMonroeShreveport
1,000 sq ft (10 squares)$7,850$15,450$7,950$15,650
1,500 sq ft (15 squares)$10,700$22,100$10,850$22,400
2,000 sq ft (20 squares)$12,600$28,750$12,750$29,100
2,500 sq ft (25 squares)$15,450$34,450$15,650$34,900
3,000+ sq ft (30 squares)$18,300$40,150$18,550$40,650

Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.

Best time to buy

Cheapest time for metal roof installation in either city

The material dictates the season (shingles need warmth to seal), but the price is set by demand, and demand spikes after every regional hailstorm. Booking your spot in the quiet winter months for spring work avoids that spike.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

Our take

Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.

FAQ

Monroe vs Shreveport

Is metal roof installation cheaper in Monroe or Shreveport?

In 2026, metal roof installation is cheaper in Monroe at about $20,700, versus $20,950 in Shreveport — a difference of about $250 (1%).

Why does metal roof installation cost more in Shreveport than Monroe?

It comes down to labor: Shreveport indexes at 0.93 against Monroe's 0.92. The hot-vs-hot climate difference adds to the gap.

How much is metal roof installation in Monroe, LA?

In Monroe, metal roof installation typically runs $12,600–$28,750 in 2026, with most homeowners paying around $20,700.

When is the cheapest time to buy metal roof installation — and does it differ by city?

It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Monroe and Shreveport (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.

Should I choose where to live based on metal roof installation cost?

Not really — the $250 gap is one-time, and smart timing and tighter quotes in Shreveport can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik