Metal Roof Installation cost: Gresham vs Medford (2026)
Gresham runs 4% higher than Medford for metal roof installation — expect around $23,400 in Gresham against $22,600 in Medford, a difference of about $800.
Gresham OR
Typically around $23,400
Medford OR
Lower costTypically around $22,600
Gresham vs Medford: full breakdown
| Factor | Gresham | Medford |
|---|---|---|
| Typical 2026 cost | $23,400 | $22,600 |
| Estimated range | $14,250–$32,500 | $13,750–$31,400 |
| Labor index (vs US) | ×1.07 | ×1.04 |
| Climate zone | Mixed | Mixed |
| Climate factor | ×1 | ×1 |
| Local permit | $300 | $300 |
| Labor share | $14,050 | $13,550 |
| Materials/equipment | $9,350 | $9,050 |
These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.
How much should this gap actually matter?
At 4%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for metal roof installation — focus on the contractor, not the city.
Metal roof installation by type: Gresham vs Medford
Each metal roof installation option, priced separately for both metros — the same local labor, climate and permit adjustments applied per city, so you can compare like for like.
| Type | Gresham | Medford |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,950–$19,600 | $9,600–$18,950 |
| Standing-seam steel | $19,600–$37,850 | $18,950–$36,550 |
| Aluminum | $15,300–$30,350 | $14,800–$29,300 |
| Copper | $32,500–$64,700 | $31,400–$62,450 |
| Zinc | $30,350–$59,350 | $29,300–$57,300 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Metal roof installation by roof size: Gresham vs Medford
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Gresham | Medford |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,900–$17,450 | $8,600–$16,900 |
| 1,500 sq ft (15 squares) | $12,100–$25,000 | $11,700–$24,150 |
| 2,000 sq ft (20 squares) | $14,250–$32,500 | $13,750–$31,400 |
| 2,500 sq ft (25 squares) | $17,450–$38,950 | $16,900–$37,600 |
| 3,000+ sq ft (30 squares) | $20,700–$45,350 | $20,000–$43,800 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
What roofing pros earn in each metro
Labor is about 60% of a metal roof installation bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Portland-Vancouver-Hillsboro metro · about 12% above the US average installer wage.
No BLS metro wage series for Medford; we use Oregon regional price parity instead.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
The material dictates the season (shingles need warmth to seal), but the price is set by demand, and demand spikes after every regional hailstorm. Booking your spot in the quiet winter months for spring work avoids that spike.
Where does a smart roofing budget go in 2026?
A roofing quote can hide a lot behind a single number — whether it's a true tear-off, the shingle grade, and what's under the surface. Here's how our editors sort through it.
The risk case
Nail down the per-sheet decking rate in writing before anyone climbs up. Soft or rotted plywood is the most common mid-job discovery, and without an agreed number the crew names the price after they've already found the damage — turning a cheap quote into an open tab.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.
Gresham vs Medford
Is metal roof installation cheaper in Gresham or Medford?
Yes — Gresham costs more. Expect around $23,400 for metal roof installation there against $22,600 in Medford, about $800 (4%) apart in 2026.
Why does metal roof installation cost more in Gresham than Medford?
Labor rates explain most of it — 1.07 in Gresham vs 1.04 in Medford. A mixed climate versus mixed accounts for the rest.
How much is metal roof installation in Gresham, OR?
Gresham homeowners can expect $14,250 to $32,500 for metal roof installation in 2026, with $23,400 the typical number.
When is the cheapest time to buy metal roof installation — and does it differ by city?
The best window is the same in both Gresham and Medford: Late spring to early fall (dry, 45–85°F), when demand drops and installers discount to keep crews busy — typically 5–10% off peak pricing. The most expensive time anywhere is an emergency replacement during mid-winter and the post-storm rush.
Should I choose where to live based on metal roof installation cost?
Not really — the $800 gap is one-time, and smart timing and tighter quotes in Gresham can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik