Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Glendale vs Marana (2026)

The two metros aren't quite in sync on metal roof installation: Glendale sits 1% above Marana, or roughly $21,950 versus $21,650 — about $300 apart.

Glendale AZ

$13,400 $30,500

Typically around $21,950

Marana AZ

Lower cost
$13,200 $30,050

Typically around $21,650

The $300 (1%) premium on metal roof installation in Glendale versus Marana comes down mostly to local labor rates.
Side by side

Glendale vs Marana: full breakdown

FactorGlendaleMarana
Typical 2026 cost$21,950$21,650
Estimated range$13,400–$30,500$13,200–$30,050
Labor index (vs US)×0.98×0.96
Climate zoneHotHot
Climate factor×1.03×1.03
Local permit$300$275
Labor share$13,150$13,000
Materials/equipment$8,800$8,650

These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.

The verdict

Is the gap worth worrying about?

1% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.

By type

Metal roof installation by type: Glendale vs Marana

Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeGlendaleMarana
Corrugated steel (exposed fastener)$9,350$18,400$9,200$18,150
Standing-seam steel$18,400$35,500$18,150$35,050
Aluminum$14,400$28,450$14,200$28,100
Copper$30,500$60,650$30,050$59,850
Zinc$28,450$55,600$28,100$54,900

Treat these as 2026 localized estimates for metal roof installation, not quotes from a contractor.

By size

Metal roof installation by roof size: Glendale vs Marana

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizeGlendaleMarana
1,000 sq ft (10 squares)$8,350$16,400$8,200$16,150
1,500 sq ft (15 squares)$11,350$23,450$11,200$23,100
2,000 sq ft (20 squares)$13,400$30,500$13,200$30,050
2,500 sq ft (25 squares)$16,400$36,500$16,150$36,000
3,000+ sq ft (30 squares)$19,400$42,550$19,150$42,000

These are 2026 planning figures for metal roof installation, localized to each city — not formal quotes.

Local labor reality

What roofing pros earn in each metro

Since labor accounts for around 60% of what a metal roof installation job costs, it's the biggest lever behind any price gap between cities. What you're seeing below is actual BLS metro wage data for skilled installers — not a guess.

Glendale, AZ
$29.9/hr

Phoenix-Mesa-Chandler metro · about 4% below the US average installer wage.

Marana, AZ
Modeled from state data

No BLS metro wage series for Marana; we use Arizona regional price parity instead.

Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).

Best time to buy

Cheapest time for metal roof installation in either city

Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.

The value case

Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The risk case

Nail down the per-sheet decking rate in writing before anyone climbs up. Soft or rotted plywood is the most common mid-job discovery, and without an agreed number the crew names the price after they've already found the damage — turning a cheap quote into an open tab.

Our take

A roof's real cost shows up over its lifespan, not on install day. Tear-off, a documented repair rate and a mid-tier shingle grade are what keep that lifetime cost in check.

FAQ

Glendale vs Marana

Is metal roof installation cheaper in Glendale or Marana?

Marana wins on price: metal roof installation runs about $21,650 there versus $21,950 in Glendale, a gap of roughly $300 (1%) as of 2026.

Why does metal roof installation cost more in Glendale than Marana?

It comes down to labor: Glendale indexes at 0.98 against Marana's 0.96. The hot-vs-hot climate difference, plus permit fees, adds to the gap.

How much is metal roof installation in Glendale, AZ?

metal roof installation in Glendale runs $13,400–$30,500 as of 2026 — most jobs land near $21,950.

When is the cheapest time to buy metal roof installation — and does it differ by city?

Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Glendale and Marana, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.

Should I choose where to live based on metal roof installation cost?

Rarely. The $300 difference is real but one-time, and you can often close most of it in Glendale by buying in the off-season and getting tighter, apples-to-apples bids. Ongoing factors — energy prices, climate and home condition — matter more over the life of the system.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik