Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Metal Roof Installation cost: Florence-Graham vs San Diego (2026)

In 2026, metal roof installation is about 1% less expensive in Florence-Graham than in San Diego. Most homeowners pay around $23,800 in Florence-Graham versus $24,050 in San Diego — a gap of roughly $250.

Florence-Graham CA

Lower cost
$14,500 $33,050

Typically around $23,800

San Diego CA

$14,650 $33,450

Typically around $24,050

metal roof installation runs about $250 (1%) more in San Diego than in Florence-Graham, driven mostly by local labor rates.
Side by side

Florence-Graham vs San Diego: full breakdown

FactorFlorence-GrahamSan Diego
Typical 2026 cost$23,800$24,050
Estimated range$14,500–$33,050$14,650–$33,450
Labor index (vs US)×1.09×1.1
Climate zoneMixedMixed
Climate factor×1×1
Local permit$325$325
Labor share$14,300$14,450
Materials/equipment$9,500$9,600

Treat these as 2026 localized estimates for metal roof installation, not quotes from a contractor.

The verdict

How much should this gap actually matter?

A 1% difference on metal roof installation is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.

By type

Metal roof installation by type: Florence-Graham vs San Diego

Below, each metal roof installation option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeFlorence-GrahamSan Diego
Corrugated steel (exposed fastener)$10,150$19,950$10,250$20,200
Standing-seam steel$19,950$38,500$20,200$38,950
Aluminum$15,600$30,900$15,800$31,250
Copper$33,050$65,800$33,450$66,550
Zinc$30,900$60,350$31,250$61,050

All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.

By size

Metal roof installation by roof size: Florence-Graham vs San Diego

Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.

SizeFlorence-GrahamSan Diego
1,000 sq ft (10 squares)$9,050$17,800$9,150$18,000
1,500 sq ft (15 squares)$12,350$25,400$12,450$25,700
2,000 sq ft (20 squares)$14,500$33,050$14,650$33,450
2,500 sq ft (25 squares)$17,800$39,600$18,000$40,050
3,000+ sq ft (30 squares)$21,050$46,150$21,300$46,700

Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Local labor reality

What roofing pros earn in each metro

Since labor accounts for around 60% of what a metal roof installation job costs, it's the biggest lever behind any price gap between cities. What you're seeing below is actual BLS metro wage data for skilled installers — not a guess.

Florence-Graham, CA
$35.9/hr

Los Angeles-Long Beach-Anaheim metro · about 15% above the US average installer wage.

San Diego, CA
$36.5/hr

San Diego-Chula Vista-Carlsbad metro · about 17% above the US average installer wage.

Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).

Best time to buy

Cheapest time for metal roof installation in either city

Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Tear-off vs. overlay, shingle tier and what's hidden under the deck decide the real number. Our editors on the trade-offs.

The value case

Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

Our take

Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.

FAQ

Florence-Graham vs San Diego

Is metal roof installation cheaper in Florence-Graham or San Diego?

In 2026, metal roof installation is cheaper in Florence-Graham at about $23,800, versus $24,050 in San Diego — a difference of about $250 (1%).

Why does metal roof installation cost more in San Diego than Florence-Graham?

The main driver is local labor rates: San Diego's labor index is 1.1 versus 1.09 in Florence-Graham. Climate zone (mixed vs mixed) also shift the total.

How much is metal roof installation in Florence-Graham, CA?

Florence-Graham homeowners can expect $14,500 to $33,050 for metal roof installation in 2026, with $23,800 the typical number.

Do roofing pros really charge more in one city?

Real wage data backs this up — skilled installers earn roughly $35.9/hr in Los Angeles-Long Beach-Anaheim compared with $36.5/hr in San Diego-Chula Vista-Carlsbad (BLS OEWS). Labor is about 60% of a metal roof installation job, so that wage gap is what mostly drives the price difference.

When is the cheapest time to buy metal roof installation — and does it differ by city?

The best window is the same in both Florence-Graham and San Diego: Late spring to early fall (dry, 45–85°F), when demand drops and installers discount to keep crews busy — typically 5–10% off peak pricing. The most expensive time anywhere is an emergency replacement during mid-winter and the post-storm rush.

Should I choose where to live based on metal roof installation cost?

Probably not. Yes, $250 is a real gap, but it's a one-time cost you can partly offset in San Diego with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.

Keep comparing

Compare metal roof installation in other cities

Updated June 2026 · By Serhat Özçelik