Metal Roof Installation cost: Coral Springs vs Jacksonville (2026)
The two metros aren't quite in sync on metal roof installation: Coral Springs sits 1% above Jacksonville, or roughly $21,500 versus $21,200 — about $300 apart.
Coral Springs FL
Typically around $21,500
Jacksonville FL
Lower costTypically around $21,200
Coral Springs vs Jacksonville: full breakdown
| Factor | Coral Springs | Jacksonville |
|---|---|---|
| Typical 2026 cost | $21,500 | $21,200 |
| Estimated range | $13,100–$29,850 | $12,950–$29,450 |
| Labor index (vs US) | ×0.96 | ×0.94 |
| Climate zone | Hot | Hot |
| Climate factor | ×1.03 | ×1.03 |
| Local permit | $325 | $275 |
| Labor share | $12,900 | $12,700 |
| Materials/equipment | $8,600 | $8,500 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
How much should this gap actually matter?
A 1% difference on metal roof installation is minor — you'll typically see a wider spread just from getting multiple quotes in the same city, so don't let location drive the decision.
Metal roof installation by type: Coral Springs vs Jacksonville
We localize each metal roof installation type separately for both metros, applying the same labor, climate and permit adjustments each time, so you're comparing like for like.
| Type | Coral Springs | Jacksonville |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,200–$18,050 | $9,050–$17,800 |
| Standing-seam steel | $18,050–$34,750 | $17,800–$34,350 |
| Aluminum | $14,100–$27,900 | $13,900–$27,500 |
| Copper | $29,850–$59,400 | $29,450–$58,650 |
| Zinc | $27,900–$54,450 | $27,500–$53,800 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
Metal roof installation by roof size: Coral Springs vs Jacksonville
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Coral Springs | Jacksonville |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,200–$16,050 | $8,050–$15,850 |
| 1,500 sq ft (15 squares) | $11,150–$22,950 | $11,000–$22,650 |
| 2,000 sq ft (20 squares) | $13,100–$29,850 | $12,950–$29,450 |
| 2,500 sq ft (25 squares) | $16,050–$35,750 | $15,850–$35,300 |
| 3,000+ sq ft (30 squares) | $19,050–$41,650 | $18,750–$41,150 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What roofing pros earn in each metro
Labor is about 60% of a metal roof installation bill, so local wages drive most of the gap. These are real metro hourly wages for skilled installers (BLS OEWS), not estimates.
Miami-Fort Lauderdale-West Palm Beach metro · about 7% below the US average installer wage.
Jacksonville metro · about 9% below the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Storm season pushes demand — and prices — up through summer, since shingles need warm, dry weather to bond correctly. Roofers with open winter calendars will often deal to fill a spring slot.
Where does a smart roofing budget go in 2026?
A roofing quote can hide a lot behind a single number — whether it's a true tear-off, the shingle grade, and what's under the surface. Here's how our editors sort through it.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
The risk case
Nail down the per-sheet decking rate in writing before anyone climbs up. Soft or rotted plywood is the most common mid-job discovery, and without an agreed number the crew names the price after they've already found the damage — turning a cheap quote into an open tab.
Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.
Coral Springs vs Jacksonville
Is metal roof installation cheaper in Coral Springs or Jacksonville?
Yes — Coral Springs costs more. Expect around $21,500 for metal roof installation there against $21,200 in Jacksonville, about $300 (1%) apart in 2026.
Why does metal roof installation cost more in Coral Springs than Jacksonville?
Coral Springs's higher labor index (0.96 vs 0.94 in Jacksonville) is the biggest factor, with the hot/hot climate split and permit fee differences playing a smaller role.
How much is metal roof installation in Coral Springs, FL?
Expect to pay $13,100 to $29,850 for metal roof installation in Coral Springs in 2026, averaging around $21,500.
Do roofing pros really charge more in one city?
It's not a myth — BLS data puts installer wages at about $28.8/hr in the Miami-Fort Lauderdale-West Palm Beach area and $28.3/hr in Jacksonville. Given labor is around 60% of a metal roof installation job's cost, that gap explains most of the price spread.
When is the cheapest time to buy metal roof installation — and does it differ by city?
Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Coral Springs and Jacksonville, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.
Should I choose where to live based on metal roof installation cost?
Probably not. Yes, $300 is a real gap, but it's a one-time cost you can partly offset in Coral Springs with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik