Metal Roof Installation cost: Cheyenne vs Gillette (2026)
Cheyenne runs 4% higher than Gillette for metal roof installation — expect around $21,850 in Cheyenne against $21,000 in Gillette, a difference of about $850.
Cheyenne WY
Typically around $21,850
Gillette WY
Lower costTypically around $21,000
Cheyenne vs Gillette: full breakdown
| Factor | Cheyenne | Gillette |
|---|---|---|
| Typical 2026 cost | $21,850 | $21,000 |
| Estimated range | $13,300–$30,350 | $12,800–$29,200 |
| Labor index (vs US) | ×0.96 | ×0.93 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.04 | ×1.04 |
| Local permit | $275 | $250 |
| Labor share | $13,100 | $12,600 |
| Materials/equipment | $8,750 | $8,400 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
How much should this gap actually matter?
4% is within noise for metal roof installation — contractor selection and timing move the price more than which of these two metros you're in.
Metal roof installation by type: Cheyenne vs Gillette
Every metal roof installation type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Cheyenne | Gillette |
|---|---|---|
| Corrugated steel (exposed fastener) | $9,300–$18,300 | $8,950–$17,600 |
| Standing-seam steel | $18,300–$35,350 | $17,600–$34,050 |
| Aluminum | $14,300–$28,350 | $13,750–$27,250 |
| Copper | $30,350–$60,450 | $29,200–$58,150 |
| Zinc | $28,350–$55,400 | $27,250–$53,350 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Metal roof installation by roof size: Cheyenne vs Gillette
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Cheyenne | Gillette |
|---|---|---|
| 1,000 sq ft (10 squares) | $8,300–$16,300 | $7,950–$15,700 |
| 1,500 sq ft (15 squares) | $11,300–$23,350 | $10,850–$22,450 |
| 2,000 sq ft (20 squares) | $13,300–$30,350 | $12,800–$29,200 |
| 2,500 sq ft (25 squares) | $16,300–$36,350 | $15,700–$35,000 |
| 3,000+ sq ft (30 squares) | $19,300–$42,400 | $18,600–$40,800 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
Cheapest time for metal roof installation in either city
Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.
Where does a smart roofing budget go in 2026?
A roofing quote can hide a lot behind a single number — whether it's a true tear-off, the shingle grade, and what's under the surface. Here's how our editors sort through it.
The value case
Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.
The do-it-right case
Skipping the tear-off means burying whatever's failing underneath, and a second layer bakes the shingles from below until they curl early. Doing it properly means stripping to the deck, then paying for real underlayment, flashing and airflow — the work that sets how long the roof lasts, not just how it looks the first week.
The risk case
Nail down the per-sheet decking rate in writing before anyone climbs up. Soft or rotted plywood is the most common mid-job discovery, and without an agreed number the crew names the price after they've already found the damage — turning a cheap quote into an open tab.
Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.
Cheyenne vs Gillette
Is metal roof installation cheaper in Cheyenne or Gillette?
In 2026, metal roof installation is cheaper in Gillette at about $21,000, versus $21,850 in Cheyenne — a difference of about $850 (4%).
Why does metal roof installation cost more in Cheyenne than Gillette?
Cheyenne's higher labor index (0.96 vs 0.93 in Gillette) is the biggest factor, with the cold/cold climate split and permit fee differences playing a smaller role.
How much is metal roof installation in Cheyenne, WY?
metal roof installation in Cheyenne runs $13,300–$30,350 as of 2026 — most jobs land near $21,850.
When is the cheapest time to buy metal roof installation — and does it differ by city?
It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Cheyenne and Gillette (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.
Should I choose where to live based on metal roof installation cost?
Probably not. Yes, $850 is a real gap, but it's a one-time cost you can partly offset in Cheyenne with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.
Updated June 2026 · By Serhat Özçelik