Metal Roof Installation cost: Burnsville vs St. Paul (2026)
Burnsville and St. Paul are a near-perfect match on metal roof installation cost in 2026, both landing around $25,050.
Burnsville MN
Typically around $25,050
St. Paul MN
Typically around $25,050
Burnsville vs St. Paul: full breakdown
| Factor | Burnsville | St. Paul |
|---|---|---|
| Typical 2026 cost | $25,050 | $25,050 |
| Estimated range | $15,250–$34,850 | $15,250–$34,850 |
| Labor index (vs US) | ×1.11 | ×1.11 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.04 | ×1.04 |
| Local permit | $300 | $300 |
| Labor share | $15,050 | $15,050 |
| Materials/equipment | $10,000 | $10,000 |
All figures are 2026 localized planning estimates for metal roof installation — get an actual quote before you commit.
A wash — choose on quality, not city
The two metros are effectively a wash for metal roof installation — pick on contractor quality and timing, not location.
Metal roof installation by type: Burnsville vs St. Paul
Each metal roof installation option, priced separately for both metros — the same local labor, climate and permit adjustments applied per city, so you can compare like for like.
| Type | Burnsville | St. Paul |
|---|---|---|
| Corrugated steel (exposed fastener) | $10,650–$21,000 | $10,650–$21,000 |
| Standing-seam steel | $21,000–$40,600 | $21,000–$40,600 |
| Aluminum | $16,400–$32,550 | $16,400–$32,550 |
| Copper | $34,850–$69,350 | $34,850–$69,350 |
| Zinc | $32,550–$63,600 | $32,550–$63,600 |
Localized 2026 planning estimates — not quotes. Each city adjusts the national metal roof installation range for local labor, climate and permits.
Metal roof installation by roof size: Burnsville vs St. Paul
Metal roofing is priced per square (100 sq ft) and costs roughly $6–$14 per sq ft installed — two to three times asphalt, but it lasts decades longer. Standing-seam costs more than exposed-fastener panels.
| Size | Burnsville | St. Paul |
|---|---|---|
| 1,000 sq ft (10 squares) | $9,500–$18,700 | $9,500–$18,700 |
| 1,500 sq ft (15 squares) | $12,950–$26,750 | $12,950–$26,750 |
| 2,000 sq ft (20 squares) | $15,250–$34,850 | $15,250–$34,850 |
| 2,500 sq ft (25 squares) | $18,700–$41,750 | $18,700–$41,750 |
| 3,000+ sq ft (30 squares) | $22,150–$48,650 | $22,150–$48,650 |
Metal roof installation numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.
What roofing pros earn in each metro
Since labor accounts for around 60% of what a metal roof installation job costs, it's the biggest lever behind any price gap between cities. What you're seeing below is actual BLS metro wage data for skilled installers — not a guess.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for metal roof installation in either city
Shingles seal properly only in warm, dry conditions, which is exactly when everyone else wants a new roof too — especially right after a summer hailstorm. Lock in a late-fall or winter booking for a spring install and you skip that rush.
Where does a smart roofing budget go in 2026?
Tear-off vs. overlay, shingle tier and what's hidden under the deck decide the real number. Our editors on the trade-offs.
The do-it-right case
Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The risk case
The surprise that wrecks a roofing budget is rot in the decking, and you rarely see it until the old shingles come off. Fix the price per replacement sheet in the contract before the crew starts, so a low bid can't quietly climb once the deck is open.
Full tear-off, architectural shingles and a written deck-repair rate protect you from the two big risks — hidden rot and warranty gaps. The lowest storm-season bid is rarely the cheapest over the roof's life.
Burnsville vs St. Paul
Is metal roof installation cheaper in Burnsville or St. Paul?
metal roof installation costs about the same in both — roughly $25,050 in each city.
Why does metal roof installation cost more in St. Paul than Burnsville?
It comes down to labor: St. Paul indexes at 1.11 against Burnsville's 1.11. The cold-vs-cold climate difference adds to the gap.
How much is metal roof installation in Burnsville, MN?
Burnsville homeowners can expect $15,250 to $34,850 for metal roof installation in 2026, with $25,050 the typical number.
Do roofing pros really charge more in one city?
Yes — and the wage data shows it. A skilled installer earns about $36.7/hr in the Minneapolis-St. Paul-Bloomington area versus $36.7/hr around Minneapolis-St. Paul-Bloomington (BLS metro wage data). Since labor is roughly 60% of a metal roof installation job, that wage gap is the biggest reason the installed prices differ.
When is the cheapest time to buy metal roof installation — and does it differ by city?
It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Burnsville and St. Paul (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.
Should I choose where to live based on metal roof installation cost?
Not on this basis — Burnsville and St. Paul cost about the same. Weigh contractor quality, scope, equipment tier and timing instead.
Compare metal roof installation in other cities
Updated June 2026 · By Serhat Özçelik