Flat Roof Replacement cost: Bloomington vs Burnsville (2026)
Flat roof replacement costs about the same in Bloomington and Burnsville in 2026 — roughly $11,700 in each.
Bloomington MN
Typically around $11,700
Burnsville MN
Typically around $11,700
Bloomington vs Burnsville: full breakdown
| Factor | Bloomington | Burnsville |
|---|---|---|
| Typical 2026 cost | $11,700 | $11,700 |
| Estimated range | $6,000–$17,400 | $6,000–$17,400 |
| Labor index (vs US) | ×1.11 | ×1.11 |
| Climate zone | Cold | Cold |
| Climate factor | ×1.03 | ×1.03 |
| Local permit | $300 | $300 |
| Labor share | $7,000 | $7,000 |
| Materials/equipment | $4,700 | $4,700 |
These are 2026 planning figures for flat roof replacement, localized to each city — not formal quotes.
No real cost edge either way
With no real price gap on flat roof replacement, the choice comes down to contractor quality and timing, not which city you're in.
Flat roof replacement by type: Bloomington vs Burnsville
Every flat roof replacement type gets its own localized price for each metro, using the same labor, climate and permit adjustments — a true apples-to-apples comparison.
| Type | Bloomington | Burnsville |
|---|---|---|
| EPDM (rubber) | $6,000–$14,000 | $6,000–$14,000 |
| TPO | $7,150–$15,100 | $7,150–$15,100 |
| PVC | $8,300–$17,400 | $8,300–$17,400 |
| Modified bitumen | $6,000–$12,850 | $6,000–$12,850 |
| Built-up roofing (BUR) | $7,700–$16,250 | $7,700–$16,250 |
Treat these as 2026 localized estimates for flat roof replacement, not quotes from a contractor.
Flat roof replacement by roof size: Bloomington vs Burnsville
Flat and low-slope roofs are priced per square (100 sq ft) and run about $3–$11 per sq ft installed, depending on the membrane. The roof area is close to the footprint since there's little pitch.
| Size | Bloomington | Burnsville |
|---|---|---|
| 1,000 sq ft (10 squares) | $4,850–$10,000 | $4,850–$10,000 |
| 1,500 sq ft (15 squares) | $6,000–$12,850 | $6,000–$12,850 |
| 2,000 sq ft (20 squares) | $7,150–$16,250 | $7,150–$16,250 |
| 2,500 sq ft (25 squares) | $8,850–$18,550 | $8,850–$18,550 |
| 3,000+ sq ft (30 squares) | $10,550–$21,950 | $10,550–$21,950 |
All figures are 2026 localized planning estimates for flat roof replacement — get an actual quote before you commit.
What roofing pros earn in each metro
About 60% of a flat roof replacement bill goes to labor, so wage differences between these two metros matter more than almost anything else. These are real, government-sourced (BLS OEWS) installer wages, not estimates.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Minneapolis-St. Paul-Bloomington metro · about 18% above the US average installer wage.
Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).
Cheapest time for flat roof replacement in either city
Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.
Where does a smart roofing budget go in 2026?
Two roofs of the same square footage can price hundreds apart because of something you can't see from the ground — the deck under the old shingles. Add the tear-off-versus-overlay call and the shingle grade, and you have the decisions that actually move the number.
The risk case
Nail down the per-sheet decking rate in writing before anyone climbs up. Soft or rotted plywood is the most common mid-job discovery, and without an agreed number the crew names the price after they've already found the damage — turning a cheap quote into an open tab.
The value case
Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.
The do-it-right case
A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.
Insist on tear-off over overlay, get the deck-repair rate in writing before work starts, and lean toward architectural shingles. Skipping any of the three tends to cost more later than it saves now.
Bloomington vs Burnsville
Is flat roof replacement cheaper in Bloomington or Burnsville?
flat roof replacement costs about the same in both — roughly $11,700 in each city.
Why does flat roof replacement cost more in Burnsville than Bloomington?
Labor rates explain most of it — 1.11 in Burnsville vs 1.11 in Bloomington. A cold climate versus cold accounts for the rest.
How much is flat roof replacement in Bloomington, MN?
Expect to pay $6,000 to $17,400 for flat roof replacement in Bloomington in 2026, averaging around $11,700.
Do roofing pros really charge more in one city?
Yes — and the wage data shows it. A skilled installer earns about $36.7/hr in the Minneapolis-St. Paul-Bloomington area versus $36.7/hr around Minneapolis-St. Paul-Bloomington (BLS metro wage data). Since labor is roughly 60% of a flat roof replacement job, that wage gap is the biggest reason the installed prices differ.
When is the cheapest time to buy flat roof replacement — and does it differ by city?
It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Bloomington and Burnsville (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.
Should I choose where to live based on flat roof replacement cost?
No — the cost is essentially identical between Bloomington and Burnsville. Base the decision on the things that actually vary: contractor reputation, scope, equipment tier and timing.
Compare flat roof replacement in other cities
Updated June 2026 · By Serhat Özçelik