Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Flat Roof Replacement cost: Billings vs Great Falls (2026)

Budget-wise, flat roof replacement in Billings ($10,050) runs 0% more than in Great Falls ($10,000), a roughly $50 spread.

Billings MT

$5,150 $14,950

Typically around $10,050

Great Falls MT

Lower cost
$5,100 $14,850

Typically around $10,000

Expect to pay roughly $50 (0%) more for flat roof replacement in Billings than in Great Falls — local labor is the main reason.
Side by side

Billings vs Great Falls: full breakdown

FactorBillingsGreat Falls
Typical 2026 cost$10,050$10,000
Estimated range$5,150–$14,950$5,100–$14,850
Labor index (vs US)×0.95×0.95
Climate zoneColdCold
Climate factor×1.03×1.03
Local permit$250$250
Labor share$6,050$6,000
Materials/equipment$4,000$4,000

Flat roof replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

The verdict

Is the gap worth worrying about?

At 0%, this gap is small enough that it's usually swallowed by normal quote-to-quote variation for flat roof replacement — focus on the contractor, not the city.

By type

Flat roof replacement by type: Billings vs Great Falls

Below, each flat roof replacement option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeBillingsGreat Falls
EPDM (rubber)$5,150$12,000$5,100$11,950
TPO$6,150$13,000$6,100$12,900
PVC$7,100$14,950$7,050$14,850
Modified bitumen$5,150$11,050$5,100$10,950
Built-up roofing (BUR)$6,600$14,000$6,600$13,900

Treat these as 2026 localized estimates for flat roof replacement, not quotes from a contractor.

By size

Flat roof replacement by roof size: Billings vs Great Falls

Flat and low-slope roofs are priced per square (100 sq ft) and run about $3–$11 per sq ft installed, depending on the membrane. The roof area is close to the footprint since there's little pitch.

SizeBillingsGreat Falls
1,000 sq ft (10 squares)$4,150$8,600$4,150$8,550
1,500 sq ft (15 squares)$5,150$11,050$5,100$10,950
2,000 sq ft (20 squares)$6,150$14,000$6,100$13,900
2,500 sq ft (25 squares)$7,600$15,950$7,550$15,850
3,000+ sq ft (30 squares)$9,100$18,900$9,000$18,750

Localized 2026 planning estimates — not quotes. Each city adjusts the national flat roof replacement range for local labor, climate and permits.

Best time to buy

Cheapest time for flat roof replacement in either city

Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Two roofs of the same square footage can price hundreds apart because of something you can't see from the ground — the deck under the old shingles. Add the tear-off-versus-overlay call and the shingle grade, and you have the decisions that actually move the number.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

The risk case

The surprise that wrecks a roofing budget is rot in the decking, and you rarely see it until the old shingles come off. Fix the price per replacement sheet in the contract before the crew starts, so a low bid can't quietly climb once the deck is open.

The do-it-right case

A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.

Our take

A roof's real cost shows up over its lifespan, not on install day. Tear-off, a documented repair rate and a mid-tier shingle grade are what keep that lifetime cost in check.

FAQ

Billings vs Great Falls

Is flat roof replacement cheaper in Billings or Great Falls?

Yes — Billings costs more. Expect around $10,050 for flat roof replacement there against $10,000 in Great Falls, about $50 (0%) apart in 2026.

Why does flat roof replacement cost more in Billings than Great Falls?

Labor rates explain most of it — 0.95 in Billings vs 0.95 in Great Falls. A cold climate versus cold accounts for the rest.

How much is flat roof replacement in Billings, MT?

flat roof replacement in Billings runs $5,150–$14,950 as of 2026 — most jobs land near $10,050.

When is the cheapest time to buy flat roof replacement — and does it differ by city?

Timing doesn't change by city here — Late spring to early fall (dry, 45–85°F) is the cheapest window in both Billings and Great Falls, saving roughly 5–10%. Avoid mid-winter and the post-storm rush in either location, when emergency replacements push prices up.

Should I choose where to live based on flat roof replacement cost?

Rarely. The $50 difference is real but one-time, and you can often close most of it in Billings by buying in the off-season and getting tighter, apples-to-apples bids. Ongoing factors — energy prices, climate and home condition — matter more over the life of the system.

Keep comparing

Compare flat roof replacement in other cities

Updated June 2026 · By Serhat Özçelik