Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Flat Roof Replacement cost: Beaumont vs Fort Worth (2026)

Budget-wise, flat roof replacement in Beaumont ($9,900) runs 3% less than in Fort Worth ($10,200), a roughly $300 spread.

Beaumont TX

Lower cost
$5,050 $14,700

Typically around $9,900

Fort Worth TX

$5,250 $15,150

Typically around $10,200

Expect to pay roughly $300 (3%) more for flat roof replacement in Fort Worth than in Beaumont — local labor is the main reason.
Side by side

Beaumont vs Fort Worth: full breakdown

FactorBeaumontFort Worth
Typical 2026 cost$9,900$10,200
Estimated range$5,050–$14,700$5,250–$15,150
Labor index (vs US)×0.95×0.97
Climate zoneHotHot
Climate factor×1.02×1.02
Local permit$250$300
Labor share$5,950$6,100
Materials/equipment$3,950$4,100

Localized 2026 planning estimates — not quotes. Each city adjusts the national flat roof replacement range for local labor, climate and permits.

The verdict

How much should this gap actually matter?

That 3% gap is small — for flat roof replacement it's usually less than the spread between two local contractors' quotes, so the metro matters far less than who you hire and when you buy.

By type

Flat roof replacement by type: Beaumont vs Fort Worth

Each flat roof replacement option, priced separately for both metros — the same local labor, climate and permit adjustments applied per city, so you can compare like for like.

TypeBeaumontFort Worth
EPDM (rubber)$5,050$11,850$5,250$12,200
TPO$6,050$12,800$6,250$13,200
PVC$7,000$14,700$7,250$15,150
Modified bitumen$5,050$10,850$5,250$11,200
Built-up roofing (BUR)$6,500$13,750$6,750$14,200

Localized 2026 planning estimates — not quotes. Each city adjusts the national flat roof replacement range for local labor, climate and permits.

By size

Flat roof replacement by roof size: Beaumont vs Fort Worth

Flat and low-slope roofs are priced per square (100 sq ft) and run about $3–$11 per sq ft installed, depending on the membrane. The roof area is close to the footprint since there's little pitch.

SizeBeaumontFort Worth
1,000 sq ft (10 squares)$4,100$8,450$4,250$8,750
1,500 sq ft (15 squares)$5,050$10,850$5,250$11,200
2,000 sq ft (20 squares)$6,050$13,750$6,250$14,200
2,500 sq ft (25 squares)$7,500$15,700$7,750$16,150
3,000+ sq ft (30 squares)$8,950$18,600$9,200$19,150

Flat roof replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Local labor reality

What roofing pros earn in each metro

With labor making up about 60% of a flat roof replacement job, wage differences between metros do most of the work here. These figures are real BLS OEWS installer wages, not modeled estimates.

Beaumont, TX
Modeled from state data

No BLS metro wage series for Beaumont; we use Texas regional price parity instead.

Fort Worth, TX
$29.7/hr

Dallas-Fort Worth-Arlington metro · about 5% below the US average installer wage.

Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).

Best time to buy

Cheapest time for flat roof replacement in either city

Shingles need warm, dry weather to seal, and demand peaks after summer storms. Booking in the slow late-fall/winter window for a spring install often earns you off-season pricing.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

The real cost of a roof comes down to three decisions: tear-off or overlay, which shingle tier, and what condition the decking is in. Our editors weigh in.

The value case

Architectural shingles sit between bargain 3-tab and premium metal or tile, and for most houses that middle ground is exactly right. They carry longer wind and wear ratings than 3-tab for a small step up in price, without the four-figure jump metal or tile demands.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

The do-it-right case

A full tear-off lets the crew replace underlayment, flashing and ventilation while the deck is exposed — the layers that actually keep water out. Covering old shingles with new ones costs less on install day, but the trapped heat shortens shingle life, and many manufacturers won't honor a warranty on an overlay.

Our take

Whatever the headline bid says, the roof that lasts is the one installed on a bare, sound deck with the repair price fixed in advance. Overlays and open-ended decking charges are where a cheap quote turns expensive down the line.

FAQ

Beaumont vs Fort Worth

Is flat roof replacement cheaper in Beaumont or Fort Worth?

Yes — Fort Worth costs more. Expect around $10,200 for flat roof replacement there against $9,900 in Beaumont, about $300 (3%) apart in 2026.

Why does flat roof replacement cost more in Fort Worth than Beaumont?

It comes down to labor: Fort Worth indexes at 0.97 against Beaumont's 0.95. The hot-vs-hot climate difference, plus permit fees, adds to the gap.

How much is flat roof replacement in Beaumont, TX?

flat roof replacement in Beaumont runs $5,050–$14,700 as of 2026 — most jobs land near $9,900.

When is the cheapest time to buy flat roof replacement — and does it differ by city?

It doesn't vary by location — Late spring to early fall (dry, 45–85°F) is the discount window in both Beaumont and Fort Worth (roughly 5–10% off), while mid-winter and the post-storm rush tends to be the most expensive in either city.

Should I choose where to live based on flat roof replacement cost?

Not really — the $300 gap is one-time, and smart timing and tighter quotes in Fort Worth can shrink it. Factors that compound over time, like energy prices and home condition, deserve more weight than a single upfront difference.

Keep comparing

Compare flat roof replacement in other cities

Updated June 2026 · By Serhat Özçelik