Localized for 1,000+ U.S. cities — adjusted for local labor, climate & permits
City comparison

Flat Roof Replacement cost: Ashburn vs Rockford (2026)

Budget-wise, flat roof replacement in Ashburn ($12,000) runs 20% more than in Rockford ($10,000), a roughly $2,000 spread.

Ashburn IL

$6,150 $17,850

Typically around $12,000

Rockford IL

Lower cost
$5,100 $14,850

Typically around $10,000

Ashburn costs about $2,000 (20%) more than Rockford for flat roof replacement, largely because of the local labor rate gap.
Side by side

Ashburn vs Rockford: full breakdown

FactorAshburnRockford
Typical 2026 cost$12,000$10,000
Estimated range$6,150–$17,850$5,100–$14,850
Labor index (vs US)×1.14×0.95
Climate zoneColdCold
Climate factor×1.03×1.03
Local permit$300$250
Labor share$7,200$6,000
Materials/equipment$4,800$4,000

Localized 2026 planning estimates — not quotes. Each city adjusts the national flat roof replacement range for local labor, climate and permits.

The verdict

How much should this gap actually matter?

20% (about $2,000) is enough to notice on a flat roof replacement budget. Timing the purchase for the off-season and pushing for an apples-to-apples bid in Ashburn can close much of that gap.

By type

Flat roof replacement by type: Ashburn vs Rockford

Below, each flat roof replacement option is priced independently for both cities, with identical local labor, climate and permit logic applied — so the comparison holds up.

TypeAshburnRockford
EPDM (rubber)$6,150$14,350$5,100$11,950
TPO$7,300$15,500$6,100$12,900
PVC$8,500$17,850$7,050$14,850
Modified bitumen$6,150$13,150$5,100$10,950
Built-up roofing (BUR)$7,900$16,650$6,600$13,900

Treat these as 2026 localized estimates for flat roof replacement, not quotes from a contractor.

By size

Flat roof replacement by roof size: Ashburn vs Rockford

Flat and low-slope roofs are priced per square (100 sq ft) and run about $3–$11 per sq ft installed, depending on the membrane. The roof area is close to the footprint since there's little pitch.

SizeAshburnRockford
1,000 sq ft (10 squares)$5,000$10,250$4,150$8,550
1,500 sq ft (15 squares)$6,150$13,150$5,100$10,950
2,000 sq ft (20 squares)$7,300$16,650$6,100$13,900
2,500 sq ft (25 squares)$9,050$19,000$7,550$15,850
3,000+ sq ft (30 squares)$10,800$22,500$9,000$18,750

Flat roof replacement numbers here are 2026 planning ranges, adjusted per city — useful for budgeting, not a substitute for an actual quote.

Local labor reality

What roofing pros earn in each metro

Since labor accounts for around 60% of what a flat roof replacement job costs, it's the biggest lever behind any price gap between cities. What you're seeing below is actual BLS metro wage data for skilled installers — not a guess.

Ashburn, IL
$38.1/hr

Chicago-Naperville-Elgin metro · about 23% above the US average installer wage.

Rockford, IL
Modeled from state data

No BLS metro wage series for Rockford; we use Illinois regional price parity instead.

Source: U.S. Bureau of Labor Statistics, OEWS metro wages for HVAC installers (used as a trade-labor index).

Best time to buy

Cheapest time for flat roof replacement in either city

Why summer costs more: it's the only stretch shingles seal reliably, so every storm-damaged roof in the region is competing for the same crews. Reserve a spring slot during the slow winter season and you're not in that queue.

Best window
Late spring to early fall (dry, 45–85°F)
Avoid
Mid-winter and the post-storm rush
Off-peak savings
5–10%
Editors' roundtable

Where does a smart roofing budget go in 2026?

Roofing budgets swing on decisions most homeowners don't think to ask about — overlay vs. tear-off, shingle tier, deck condition. Our editors break down each one.

The value case

Architectural shingles hit the sweet spot — far more durable than 3-tab for a modest premium, and far cheaper than metal or tile. For most homes they're the right default.

The do-it-right case

Pay for a full tear-off and quality underlayment, flashing and ventilation. An overlay saves money today but traps heat, voids some warranties and costs more at the next replacement.

The risk case

Budget for the unknown: rotten decking found at tear-off is the most common surprise. Get the per-sheet repair rate in writing up front so a "cheap" bid doesn't balloon mid-job.

Our take

A roof's real cost shows up over its lifespan, not on install day. Tear-off, a documented repair rate and a mid-tier shingle grade are what keep that lifetime cost in check.

FAQ

Ashburn vs Rockford

Is flat roof replacement cheaper in Ashburn or Rockford?

In 2026, flat roof replacement is cheaper in Rockford at about $10,000, versus $12,000 in Ashburn — a difference of about $2,000 (20%).

Why does flat roof replacement cost more in Ashburn than Rockford?

It comes down to labor: Ashburn indexes at 1.14 against Rockford's 0.95. The cold-vs-cold climate difference, plus permit fees, adds to the gap.

How much is flat roof replacement in Ashburn, IL?

Ashburn homeowners can expect $6,150 to $17,850 for flat roof replacement in 2026, with $12,000 the typical number.

When is the cheapest time to buy flat roof replacement — and does it differ by city?

The best window is the same in both Ashburn and Rockford: Late spring to early fall (dry, 45–85°F), when demand drops and installers discount to keep crews busy — typically 5–10% off peak pricing. The most expensive time anywhere is an emergency replacement during mid-winter and the post-storm rush.

Should I choose where to live based on flat roof replacement cost?

Probably not. Yes, $2,000 is a real gap, but it's a one-time cost you can partly offset in Ashburn with off-season timing and tighter bids. Long-term factors like energy prices and home condition matter more than this one number.

Keep comparing

Compare flat roof replacement in other cities

Updated June 2026 · By Serhat Özçelik